EN 1366-4:2006+A1:2010

Fire resistance tests for service installations - Part 4: Linear joint seals

This European Standard specifies a method for determining the fire resistance of linear joint seals based on their intended end use. This European Standard is used in conjunction with EN 1363-1.
The following tests are included in this European Standard:
-   no mechanically induced movement;
-   mechanically induced movement, either prior to or during fire exposure.
This European Standard does not provide quantitative information on the rate of leakage of smoke and/or hot gases, or on the transmission or generation of fumes.
The load-bearing capacity of a linear joint seal is not addressed in this European Standard.

Feuerwiderstandsprüfungen für Installationen - Teil 4: Abdichtungssysteme für Bauteilfugen

Diese Europäische Norm legt ein Verfahren zur Bestimmung der Feuerwiderstandsdauer von Fugenabdichtungen
in Abhängigkeit vom beabsichtigten Verwendungszweck fest. Diese Norm gilt zusammen mit
EN 1363-1.
Diese Europäische Norm enthält folgende Prüfungen:
⎯ keine mechanisch induzierte Bewegung;
⎯ mechanisch induzierte Bewegung, entweder vor oder während der Brandeinwirkung.
Eine Prüfung nach dieser Europäischen Norm ergibt keine quantitativen Aussagen zur Leckrate von Rauch
und/oder heißen Gasen oder zur Übertragung bzw. Entwicklung von Rauch.
Die Tragfähigkeit einer Fugenabdichtung ist nicht Gegenstand dieser Europäischen Norm.

Essai de résistance au feu des installations de service - Partie 4: Calfeutrements de joints linéaires

La présente Norme européenne prescrit une méthode pour déterminer la résistance des calfeutrements de joints linéaires en fonction de l’utilisation finale pour laquelle ils sont prévus. La Norme européenne est utilisée conjointement avec l’EN 1363-1.
Les essais suivants sont inclus dans la présente Norme européenne :
—   sans déplacement induit par des actions mécaniques ;
—   avec déplacement induit par des actions mécaniques, avant ou pendant l'exposition au feu.
La présente Norme européenne ne fournit pas d'informations quantitatives relatives au taux de fuite de fumées et/ou de gaz chauds ou à l'émission ou la génération de fumées.
Elle n'aborde pas non plus la capacité portante des calfeutrements de joints linéaires.

Preskusi požarne odpornosti servisnih inštalacij - 4. del: Tesnilna sredstva za ravne stike

Ta evropski standard določa metodo za določanje požarne odpornosti tesnilnih sredstev za ravne stike glede na njihovo končno uporabo. Ta evropski standard se uporablja skupaj z EN 1363-1. Ta evropski standard vključuje naslednje preskuse: - brez mehanično izzvanega premika; - mehanično izzvan premik bodisi pred bodisi med izpostavljenostjo ognju. Ta evropski standard ne zagotavlja kvantitativnih informacij na stopnji puščanja dima in/ali vročih plinov oziroma na prenosu ali sproščanju hlapov. Nosilna zmogljivost tesnilnih sredstev za ravne stike ni obravnavana v tem evropskem standardu.

General Information

• Status: Withdrawn
• Publication Date: 13-Apr-2010
• Withdrawal Date: 09-Feb-2021
• ICS: 13.220.50 - Fire-resistance of building materials and elements
• Technical Committee: CEN/TC 127 - Fire safety in buildings
• Drafting Committee: CEN/TC 127/WG 2 - Services
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Completion Date: 10-Feb-2021
• Directive: 305/2011 - Regulation (eu) No 305/2011 of the European Parliament and of the Council of 9 march 2011 laying down harmonised conditions for the marketing of construction products and repealing council directive 89/106/eec
• Directive: 89/106/EEC - Construction products
• Mandate: M/BC/CEN/91/9 - CPD: Fire resistance
• Ref Project: SIST EN 1366-4:2006+A1:2010 - Fire resistance tests for service installations - Part 4: Linear joint seals

Relations

• Merged From: EN 1366-4:2006 - Fire resistance tests for service installations - Part 4: Linear joint seals
• Effective Date: 19-Jan-2023
• Merged From: EN 1366-4:2006/FprA1 - Fire resistance tests for service installations - Part 4: Linear joint seals
• Effective Date: 18-Jan-2023
• Replaced By: EN 1366-4:2021 - Fire resistance tests for service installations - Part 4: Linear joint seals
• Effective Date: 08-Jun-2022

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Preskusi požarne odpornosti servisnih inštalacij - 4. del: Tesnilna sredstva za ravne stikeFeuerwiderstandsprüfungen für Installationen - Teil 4: Abdichtungssysteme für BauteilfugenEssai de résistance au feu des installations de service - Partie 4: Calfeutrements de joints linéairesFire resistance tests for service installations - Part 4: Linear joint seals13.220.50Požarna odpornost gradbenih materialov in elementovFire-resistance of building materials and elementsICS:Ta slovenski standard je istoveten z:EN 1366-4:2006+A1:2010SIST EN 1366-4:2006+A1:2010en,fr01-junij-2010SIST EN 1366-4:2006+A1:2010SLOVENSKI
STANDARD
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 1366-4:2006+A1
April 2010 ICS 13.220.50 Supersedes EN 1336-4:2006English Version
Fire resistance tests for service installations - Part 4: Linear joint seals
Essai de résistance au feu des installations de service - Partie 4: Calfeutrements de joints linéaires
Feuerwiderstandsprüfungen für Installationen - Teil 4: Abdichtungssysteme für Bauteilfugen This European Standard was approved by CEN on 17 April 2006 and includes Amendment 1 approved by CEN on 4 March 2010.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2010 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 1366-4:2006+A1:2010: ESIST EN 1366-4:2006+A1:2010

Standard condition for linear joint seals with no mechanically induced movement of the joint faces . 28A.1Standard condition . 28A.2Test procedure . 28Annex B (normative)
Standard condition for linear joint seals with mechanically induced movement of the joint faces . 29B.1General . 29B.2Standard condition(s) . 29B.2.1Standard conditions for lateral movement . 29B.2.2Standard condition for shear movement . 30B.3Conditions for other movements . 30Annex C (informative)
Guidance on the use of this European Standard . 33C.1General . 33C.2Application of the test . 33C.3Test conditions . 33C.4Specimen preparation . 34C.5Notes on general performance criteria . 34C.6Notes on validity of test results . 34C.7Notes on Annex B . 34 SIST EN 1366-4:2006+A1:2010

Ducts  Part 2:
Fire dampers  Part 3:
Penetration seals  Part 4:
Linear joint seals  Part 5:
Service ducts and shafts  Part 6:
Raised access and hollow core floors  Part 7:
Conveyor systems and their closures  Part 8:
Smoke extraction ducts  Part 9:
Single compartment smoke extraction ducts  Part 10: Smoke control dampers  Part 11: Fire protection system for essential services (in course of preparation)1)
1) To be published. SIST EN 1366-4:2006+A1:2010
...