Grouts for tiles - Part 5: Determination of water absorption

This European Standard applies to all ceramic tile grouts for internal and external tile installations on walls and floors.
This European Standard specifies the test method to be used to determine the water absorption coefficient due to capillary action when the grout surface contacts the water without any additional pressure. The coefficient is measured by means of prisms.
This European Standard does not contain performance requirements or recommendations for the design and installation of ceramic tiles.
NOTE   Ceramic tile grouts may also be used for other types of tiles (natural and agglomerated stones, etc.), where these do not adversely affect the stones.

Klebstoffe und Fugenmörtel für Fliesen und Platten - Teil 5: Bestimmung der Wasseraufnahme

Diese Europäische Norm ist auf sämtliche Fugenmörtel für keramische Fliesen und Platten an Wand und Boden für innen und außen anwendbar.
Diese Europäische Norm legt das Prüfverfahren zur Bestimmung des Wasseraufnahmekoeffizienten durch Kapillarwirkung fest, wenn die Oberfläche des Fugenmörtels ohne zusätzlichen Druck mit Wasser in Berührung kommt. Der Koeffizient wird mit Prismen bestimmt.
Diese Europäische Norm enthält keine Anforderungen und keine Empfehlungen hinsichtlich der Planung und Verlegung von keramischen Fliesen/Platten.
ANMERKUNG   Fugenmörtel für keramische Fliesen und Platten dürfen auch für andere Arten von Fliesen und Platten verwendet werden (Natur , Betonwerksteine usw.), sofern diese die Steine nicht negativ beeinflussen.

Mortiers de joints pour carrelage - Partie 5: Détermination de l'absorption d'eau

La présente Norme européenne s’applique à tous les mortiers utilisés pour le jointoiement de carrelages
céramiques sur les murs et au sol, à l’intérieur et à l’extérieur.
La présente Norme européenne spécifie la méthode d’essai qui doit être utilisée pour déterminer le coefficient
d’absorption d’eau par capillarité lorsque la surface du mortier entre en contact avec l’eau sans autre pression
supplémentaire. Le coefficient est mesuré au moyen d’éprouvettes parallélépipédiques.
La présente Norme européenne ne contient pas de spécifications, ni de recommandations pour la conception
et la pose des carrelages en céramique.
NOTE Les mortiers de joints pour carrelages céramiques peuvent être également utilisés pour d’autres types de
carrelage (pierre naturelle ou agglomérée, etc.) s'ils sont compatibles.

Lepila in fugirne malte za ploščice - 5. del: Ugotavljanje vpijanja vode

General Information

Status
Withdrawn
Publication Date
21-Oct-2008
Withdrawal Date
13-Sep-2022
Current Stage
9960 - Withdrawal effective - Withdrawal
Completion Date
14-Sep-2022

Relations

Buy Standard

Standard
EN 12808-5:2009
English language
6 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Mörtel und Klebstoffe für Fliesen und Platten — Teil 5: Bestimmung der WasseraufnahmeMortiers de joints pour carrelage - Partie 5: Détermination de l'absorption d'eauGrouts for tiles - Part 5: Determination of water absorption91.100.23Ceramic tiles91.100.10Cement. Mavec. Apno. MaltaCement. Gypsum. Lime. Mortar83.180LepilaAdhesivesICS:Ta slovenski standard je istoveten z:EN 12808-5:2008SIST EN 12808-5:2009en,fr,de01-marec-2009SIST EN 12808-5:2009SLOVENSKI
STANDARDSIST EN 12808-5:20021DGRPHãþD



SIST EN 12808-5:2009



EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 12808-5October 2008ICS 91.100.10Supersedes EN 12808-5:2001
English VersionGrouts for tiles - Part 5: Determination of water absorptionMortiers de joints pour carrelage - Partie 5: Déterminationde l'absorption d'eauMörtel und Klebstoffe für Fliesen und Platten - Teil 5:Bestimmung der WasseraufnahmeThis European Standard was approved by CEN on 29 August 2008.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the CEN Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as theofficial versions.CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2008 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 12808-5:2008: ESIST EN 12808-5:2009



EN 12808-5:2008 (E) 2 Contents Page Foreword.3 1 Scope.4 2 Normative references.4 3 Sampling.4 4 Test conditions.4 5 Test materials.4 6 Apparatus.4 7 Mixing of grouts.5 8 Preparation of test specimens.5 9 Conditioning.6 10 Test procedure.6 11 Evaluation and expression of results.6 12 Test report.6
SIST EN 12808-5:2009



EN 12808-5:2008 (E) 3 Foreword This document (EN 12808-5:2008) has been prepared by Technical Committee CEN/TC 67 “Ceramic tiles”, the secretariat of which is held by UNI. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by April 2009, and conflicting national standards shall be withdrawn at the latest by April 2009. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying a
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.