EN 13071-2:2008+A1:2013
(Main)Stationary waste containers up to 5 000 l, top lifted and bottom emptied - Part 2: Additional requirements for underground or partly underground systems
Stationary waste containers up to 5 000 l, top lifted and bottom emptied - Part 2: Additional requirements for underground or partly underground systems
This European Standard specifies the additional requirements for underground or partly underground systems top lifted and bottom emptied, used for collection of solid non-hazardous wastes with a capacity up to 5 000 l.
Stationäre Abfallsammelbehälter bis 5 000 l, mit Behälteraufnahme an der Oberseite und Bodenentleerung - Teil 2: Zusätzliche Anforderungen für unterirdische oder teilweise unterirdische Systeme
Diese Europäische Norm legt die zusätzlichen Anforderungen für unterirdische oder teilweise unterirdische Systeme mit Behälteraufnahme an der Oberseite und Bodenentleerung fest, welche für die Sammlung von festen, ungefährlichen Abfallstoffen, mit einem Volumen bis 5 000 l genutzt werden.
Conteneurs fixes à déchets de capacité inférieure ou égale à 5 000 l, levés par le haut et vidés par le bas - Partie 2: Exigences complémentaires relatives aux systèmes enterrés ou semi-enterrés
La présente Norme européenne spécifie les exigences complémentaires qui s’appliquent aux systèmes enterrés ou semi-enterrés, levés par le haut et vidés par le bas, utilisés pour la collecte de déchets solides non dangereux, d’une capacité inférieure ou égales à 5 000 l.
Nepremični zabojniki za odpadke do 5000 l, ki se dvigujejo zgoraj in praznijo spodaj - 2. del: Dodatne zahteve za podzemne ali delno podzemne sisteme
Ta evropski standard določa dodatne zahteve za podzemne ali delno podzemne sisteme, ki se dvigujejo zgoraj in praznijo spodaj, kapacitete do 5 000 l, ter se uporabljajo za zbiranje trdih nenevarnih odpadkov.
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.LVWHPHStationäre Abfallsammelbehälter bis 5 000 l, mit Behälteraufnahme an der Oberseite und Bodenentleerung - Teil 2: Zusätzliche Anforderungen für unterirdische oder teilweise unterirdische SystemeConteneurs fixes à déchets de capacité inférieure ou égale à 5 000 l, levés par le haut et vidés par le bas - Partie 2: Exigences complémentaires relatives aux systèmes enterrés ou semi-enterrésStationary waste containers up to 5 000 l, top lifted and bottom emptied - Part 2: Additional requirements for underground or partly underground systems13.030.40Naprave in oprema za odstranjevanje in obdelavo odpadkovInstallations and equipment for waste disposal and treatmentICS:Ta slovenski standard je istoveten z:EN 13071-2:2008+A1:2013SIST EN 13071-2:2008+A1:2014en,fr,de01-januar-2014SIST EN 13071-2:2008+A1:2014SLOVENSKI
STANDARDSIST EN 13071-2:20081DGRPHãþD
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 13071-2:2008+A1
October 2013 ICS 13.030.40 Supersedes EN 13071-2:2008
English Version
Stationary waste containers up to 5 000 l, top lifted and bottom emptied - Part 2: Additional requirements for underground or partly underground systems
Conteneurs fixes à déchets de capacité inférieure ou égale à 5 000 l, levés par le haut et vidés par le bas - Partie 2: Exigences complémentaires relatives aux systèmes enterrés ou semi-enterrés
Stationäre Abfallsammelbehälter bis 5 000 l, mit Behälteraufnahme an der Oberseite und Bodenentleerung - Teil 2: Zusätzliche Anforderungen für unterirdische oder teilweise unterirdische Systeme This European Standard was approved by CEN on 18 April 2008 and includes Corrigendum 1 issued by CEN on 24 March 2010 and Amendment 1 approved by CEN on 19 August 2013.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2013 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 13071-2:2008+A1:2013: E SIST EN 13071-2:2008+A1:2014
A–deviations . 13
Figures Figure 1 — Underground and partly underground system . 5 Figure 2 — Example of resistance of emergent part to exterior impacts . 10 Tables Table 1 — Sequence of the tests . 12
1 Scope This European Standard specifies the additional requirements for underground or partly underground systems top lifted and bottom emptied, used for collection of solid non-hazardous wastes with a capacity up to 5 000 l. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 10327, Continuously hot-dip coated strip and sheet of low carbon steels for cold forming - Technical delivery conditions EN 13071-1:2008, Stationary waste containers up to 5 000 l, top lifted and bottom emptied – Part 1: General requirements EN ISO 1461, Hot dip galvanized coatings on fabricated iron and steel articles – Specifications and test methods (ISO 1461:1999) ISO 2081, Metallic coatings – Electroplated coatings of zinc on iron or steel SIST EN 13071-2:2008+A1:2014
3 Terms and definitions For the purposes of this document, the terms and definitions given in EN 13071-1:2008 and the following apply. 3.1 underground or partly underground system system whose emptying device is located below surrounding ground level at any point
a) partly underground system b) underground system Key C
container EP
emergent part H
housing L
liner LC
lifting connection PP
pedestrian platform R
roof
Figure 1 — Underground and partly underground system
3.2 container
mobile part of underground or partly underground system, designated to collect/receive the waste 3.3 liner
equipment installed fully or partly in the ground, whose function is to receive the container SIST EN 13071-2:2008+A1:2014
part of the container that is fixed to the pedestrian platform, above ground level, that is used to fill the container 3.5 pedestrian platform
part of the system to which the housing is fixed or is used by pedestrians to walk on to fill the container 3.6 emergent part part of the liner that permanently emerges from surrounding ground level 3.7 hole space below ground level that is left by the container when it is removed from the liner 3.8 safety barrier
moving part of the system that prevents accidental access to the hole left by the container when it is removed from the liner 3.9 safety floor moving part of the system that covers the hole left by the container when it is removed from the liner 4 Requirements 4.1 General requirements See EN 13071-1:2008, Clause 4. 4.2 Design !Round filling apertures having a diameter more than 200 mm or rectangular ones with no dimension less than 150 mm shall be equipped with a drum or a self-closing device (lid, cover, flap, .). " The liner shall be resistant to withstand ground pressure and shall be secured against floating or sinking. The liner shall be designed and built to allow easy cleaning and pumping out of any fluids that have leaked from the container. The container shall retain residual liquids up to a minimum of 2 % of the nominal volume. Safety devices shall be resistant to all weather conditions, moisture and dirt that could negatively affect their functionality. For maintenance and cleaning, all parts of the underground or partly underground system shall be easily accessible. If present, the pedestrian platform shall be designed in order to prevent accidental slipping and tripping of pedestrians. SIST EN 13071-2:2008+A1:2014
During supervised operations, the hole if deeper than 500 mm measured at any point shall be equipped with safety device(s) in order to prevent anyone accidentally falling into it, or being injured by any moving parts of the system. The safety device can be either a safety floor or a safety barrier. If, when the container is removed, the emergent part is a minimum of 900 mm above ground level at any point, no other safety device will be required to protect accidental falls into the hole. In all cases, the safety device(s) shall be highly visible or sensitive to pedestrians.
If the hole is left unsupervised, it shall be covered b
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.