CEN/TS 15405:2006
(Main)Solid recovered fuels - Methods for the determination of density of pellets and briquettes
Solid recovered fuels - Methods for the determination of density of pellets and briquettes
This Technical Specification specifies a method for the determination of particle density of irregularly shaped pieces of compressed fuels such as pellets or briquettes.
NOTE Particle density is subject to variation due to the susceptibility of organic material to environmental or technical impacts such as air humidity, vibration, abrasion or biodegradation. Therefore, particle density can vary during time thus the measured values should be regarded as a momentary fuel property.
Feste Sekundärbrennstoffe - Verfahren zur Bestimmung der Dichte von Pellets und Briketts
Combustibles solides de récupération - Méthodes pour la détermination de la densité des granulés et des briquettes
Trdno alternativno gorivo - Metode za ugotavljanje gostote peletov in briketov
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST-TS CEN/TS 15405:2007
01-marec-2007
Trdno alternativno gorivo - Metode za ugotavljanje gostote peletov in briketov
Solid recovered fuels - Methods for the determination of density of pellets and briquettes
Feste Sekundärbrennstoffe - Verfahren zur Bestimmung der Dichte von Pellets und
Briketts
Combustibles solides de récupération - Méthodes pour la détermination de la densité
des granulés et des briquettes
Ta slovenski standard je istoveten z: CEN/TS 15405:2006
ICS:
75.160.10 Trda goriva Solid fuels
SIST-TS CEN/TS 15405:2007 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
TECHNICAL SPECIFICATION
CEN/TS 15405
SPÉCIFICATION TECHNIQUE
TECHNISCHE SPEZIFIKATION
October 2006
ICS 75.160.10
English Version
Solid recovered fuels - Methods for the determination of density
of pellets and briquettes
Combustibles solides de récupération - Méthodes pour la Feste Sekundärbrennstoffe - Verfahren zur Bestimmung
détermination de la densité des granulés et des briquettes der Dichte von Pellets und Briketts
This Technical Specification (CEN/TS) was approved by CEN on 25 March 2006 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to submit their
comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS available
promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in parallel to the CEN/TS)
until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania,
Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2006 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 15405:2006: E
worldwide for CEN national Members.
---------------------- Page: 2 ----------------------
CEN/TS 15405:2006 (E)
Contents Page
Foreword.3
Introduction .4
1 Scope .5
2 Normative references .5
3 Terms and definitions .5
4 Principle.5
5 Apparatus .5
6 Sampling and sample preparation.8
7 Procedure .8
8 Calculation.9
9 Precision.10
10 Test report .10
Annex A (informative) Correction values for the density of water as a function of temperature .11
Annex B (informative) Volume determination of regularly shaped briquettes by stereometry.12
Bibliography .14
2
---------------------- Page: 3 ----------------------
CEN/TS 15405:2006 (E)
Foreword
This document (CEN/TS 1540
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.