EN ISO 9073-1:2023
(Main)Nonwovens - Test methods - Part 1: Determination of mass per unit area (ISO 9073-1:2023)
Nonwovens - Test methods - Part 1: Determination of mass per unit area (ISO 9073-1:2023)
This document specifies a method for the determination of the mass per unit area of nonwoven fabrics.
Vliesstoffe - Prüfverfahren - Teil 1: Bestimmung der flächenbezogenen Masse (ISO 9073-1:2023)
Dieses Dokument legt ein Verfahren zur Bestimmung der flächenbezogenen Masse von Vliesstoffen fest.
SICHERHEITSHINWEIS — Dieses Dokument erhebt nicht den Anspruch, eine vollständige Aufzählung von gegebenenfalls zutreffenden Sicherheitsproblemen zu beinhalten, die mit seiner Anwendung verbunden sind. Es liegt in der Verantwortung des Anwenders dieses Dokuments, geeignete Sicherheits- und Gesundheitsschutzmaßnahmen vorzusehen und im Vorfeld die Anwendbarkeit von einschränkenden Vorschriften zu klären. Es wird erwartet, dass die Person, die diese Prüfung durchführt, in allen Aspekten dieses Verfahrens umfassend geschult wurde.
Nontissés - Méthodes d'essai - Partie 1: Détermination de la masse surfacique (ISO 9073-1:2023)
Le présent document spécifie une méthode de détermination de la masse surfacique des étoffes non tissées.
Vlaknovine - Metode preskušanja - 1. del: Ugotavljanje ploščinske mase (ISO 9073-1:2023)
Meritve površine in mase preskušanca ter izračun njegove mase na površinsko enoto v gramih na kvadratni meter. V tem delu standarda ISO 9073 so določene zahteve za izpolnitev posebnih potreb vlakovin, ki so drugačne od zahtev, navedenih v standardu ISO 3801. Nanašajo se na a) drugačen postopek vzorčenja; b) drugo specifikacijo za dimenzije preskušanca; c) večjo natančnost za ravnovesje.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-september-2023
Vlaknovine - Metode preskušanja - 1. del: Ugotavljanje ploščinske mase (ISO 9073-
1:2023)
Nowovens - Test methods - Part 1: Determination of mass per unit area (ISO 9073-
1:2023)
Vliesstoffe - Prüfverfahren - Teil 1: Bestimmung der flächenbezogenen Masse (ISO 9073
-1:2023)
Nontissés - Méthodes d'essai - Partie 1: Détermination de la masse surfacique (ISO
9073-1:2023)
Ta slovenski standard je istoveten z: EN ISO 9073-1:2023
ICS:
59.080.30 Tkanine Textile fabrics
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EN ISO 9073-1
EUROPEAN STANDARD
NORME EUROPÉENNE
June 2023
EUROPÄISCHE NORM
ICS 59.080.30 Supersedes EN 29073-1:1992
English Version
Nowovens - Test methods - Part 1: Determination of mass
per unit area (ISO 9073-1:2023)
Nontissés - Méthodes d'essai - Partie 1: Détermination Vliesstoffe - Prüfverfahren - Teil 1: Bestimmung der
de la masse surfacique (ISO 9073-1:2023) flächenbezogenen Masse (ISO 9073-1:2023)
This European Standard was approved by CEN on 27 May 2023.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 9073-1:2023 E
worldwide for CEN national Members.
Contents Page
European foreword . 3
European foreword
This document (EN ISO 9073-1:2023) has been prepared by Technical Committee ISO/TC 38 "Textiles"
in collaboration with Technical Committee CEN/TC 248 “Textiles and textile products” the secretariat of
which is held by BSI.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by December 2023, and conflicting national standards
shall be withdrawn at the latest by December 2023.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN 29073-1:1992.
Any feedback and questions on this document should be directed to the users’ national standards
body/national committee. A complete listing of these bodies can be found on the CEN website.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and the
United Kingdom.
Endorsement notice
The text of ISO 9073-1:2023 has been approved by CEN as EN ISO 9073-1:2023 without any
modification.
INTERNATIONAL ISO
STANDARD 9073-1
Second edition
2023-06
Nonwovens — Test methods —
Part 1:
Determination of mass per unit area
Nontissés — Méthodes d’essai —
Partie 1: Détermination de la masse surfacique
Reference number
ISO 9073-1:2023(E)
ISO 9073-1:2023(E)
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii
ISO 9073-1:2023(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 2
5 Apparatus . 2
6 Sampling . 2
6.1 General . 2
6.2 Preparation of test specimen . . 3
7 Conditioning . 3
8 Procedure .3
8.1 Mass measurement based on cutting test specimens to the proper size 50 000 mm . 3
8.2 Mass measurement of small/unique test specimens, where the largest rectangle
possible is cut . 4
9 Expression of results . 4
10 Precision . 4
11 Test report . 4
Bibliography . 6
iii
ISO 9073-1:2023(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO document should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
ISO draws attention to the possibility that the implementation of this document may involve the use
of (a) patent(s). ISO takes no position concerning the evidence, validity or applicability of any claimed
patent rights in respect thereof. As of the date of publication of this document, ISO had not received
notice of (a) patent(s) which may be required to implement this document. However, implementers are
cautioned that this may not represent the latest information, which may be obtained from the patent
database available at www.iso.org/patents. ISO shall not be held responsible for identifying any or all
such patent rights.
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to
the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see
www.iso.org/iso/foreword.html.
This document was prepared by Technical Committee ISO/TC 38, Textiles, in collaboration with the
European Committee for Standardization (CEN) Technical Committee CEN/TC 248, Textiles and textile
products, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna
Agreement).
This second edition cancels and replaces the first edition (ISO 9073-1:1989), which has been technically
revised.
The main changes compared to the previous edition are as follows:
— the title has been changed from "Textiles — Test methods for nonwovens — Part 1: Determination of
mass per unit area" to "Nonwovens — Test methods — Part 1: Determination of mass per unit area";
— the mandatory Terms and definitions clause (Clause 3) has been added and subsequent clauses have
been renumbered;
— the text has been reviewed and improved.
A list of all parts in the ISO 9073 series can be found on the ISO website.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www.iso.org/members.html.
iv
INTERNATIONAL STANDARD ISO 9073-1:2023(E)
Nonwovens — Test methods —
Part 1:
Determination of mass per unit area
SAFETY WARNING — This document does not claim to address all of the safety concerns, if
any, associated with its use. It is the responsibility of the user of this document to establish
appropriate safety and health practices and determine the applicability of regulatory limitations
prior to use. It is expected that the person performing this test has been fully trained in all
aspects of this procedure.
1 Scope
This document specifies a method for the determination of the mass per unit area of nonwoven fabrics.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 139, Textiles — Standard atmospheres for conditioning and testing
ISO 186, Paper and board — Sampling to determine average quality
ISO 9092, Nonwovens — Vocabulary
ISO 11224, Textiles — Web formation and bonding in nonwovens — Vocabulary
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 9092, ISO 11224 and the
following apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https:// www .iso .org/ obp
— IEC Electropedia: available at https:// www .electropedia .org/
3.1
sample
product or portion of a product taken from a production lot for testing purposes, identifiable and
traceable back to the origin
3.2
tes
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.