EN 14904-3:2019
(Main)Surfaces for sports areas - Multi-sports floor systems for indoor use - Part 3: In-situ testing
Surfaces for sports areas - Multi-sports floor systems for indoor use - Part 3: In-situ testing
This document specifies in situ requirements for verification of performance of a multi-sports floor system designed for use in indoor sport halls and gymnasia.
The purpose of this document is to help testing laboratories to interpret in situ measurements.
This document also applies to single sport facilities designed for the following sports: volleyball, basketball, badminton, small sided football, and handball.
NOTE 1 Physical education is considered as a multisport use.
NOTE 2 Part 1 covers essential requirements (as defined in regulation EU N° 305/2011) for multi-sports floor systems designed for use in indoor sport halls and gymnasia.
NOTE 3 Additional characteristics for multi-sports floor systems designed for use in indoor sport halls and gymnasia are specified in part 2 of this standard.
This document does not apply to synthetic turf or textile surfaces used indoors.
Sportböden - Mehrzweck-Sporthallenböden - Teil 3: In-situ-Prüfung
Diese Europäische Norm legt Anforderungen für die In-situ-Prüfung der Leistungsfähigkeit von Sportboden¬systemen zur Mehrzwecknutzung bei Nutzung von Sport- und Turnhallen im Innenbereich nach deren Einbau fest.
Diese Europäische Norm gilt auch für Einrichtungen, die nur für die Ausübung einer der folgenden Sportarten konstruiert wurden: Volleyball, Basketball, Badminton, Kleinfeldfußball und Handball.
ANMERKUNG 1 Sportunterricht wird als Mehrzwecknutzung angesehen.
ANMERKUNG 2 Teil 1 behandelt Wesentliche Merkmale (nach der Richtlinie (EU) Nr. 305/2011) an Sportbodensysteme zur Mehrzwecknutzung bei Nutzung von Sport- und Turnhallen im Innenbereich.
ANMERKUNG 3 Andere Anforderungen an Sportbodensysteme zur Mehrzwecknutzung bei Nutzung von Sport- und Turnhallen im Innenbereich werden in Teil 2 dieser Norm festgelegt.
Diese Europäische Norm gilt nicht für Kunststoffrasen- oder textile Flächen, die im Innenbereich genutzt werden.
Sols sportifs - Systèmes de sols multi-sports pour utilisation en intérieur - Partie 3 : Essais sur site
Le présent document spécifie les exigences sur site applicables à la vérification des performances d'un système de sol multi-sports conçu pour être utilisé dans les salles de sport et les gymnases intérieurs.
Le présent document a pour objectif d'aider les laboratoires d'essai à interpréter les mesures in situ.
Le présent document s'applique également aux installations conçues pour un seul des sports suivants : le volley-ball, le basket-ball, le badminton, le football en salle et le handball.
NOTE 1 L'éducation physique est considérée comme une pratique multi-sports.
NOTE 2 La Partie 1 couvre les exigences essentielles (telles que définies dans le Règlement UE n° 305/2011) pour les systèmes de sol multi-sports conçus pour être utilisés dans les salles de sport et les gymnases intérieurs.
NOTE 3 Les caractéristiques supplémentaires relatives aux systèmes de sols multi-sports conçus pour être utilisés dans les salles de sport et les gymnases intérieurs sont spécifiées dans la partie 2 de la présente norme.
Le présent document ne s'applique pas aux surfaces en gazon synthétique ou en textile utilisées en intérieur.
Podloge za športne dejavnosti - Sistemi večnamenskih podlog za notranjo uporabo - 3. del: Preskušanje na mestu samem
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-julij-2017
3RGORJH]DãSRUWQHGHMDYQRVWL6LVWHPLYHþQDPHQVNLKSRGORJ]DQRWUDQMR
XSRUDERGHO 3UHVNXãDQMHQDPHVWXVDPHP
Surfaces for sports areas - Multi-sports floor systems for indoor use - Part 3: In-situ
testing
Sportböden - Mehrzweck-Sporthallenböden - Teil 3: In-situ-Prüfung
Sols sportifs - Systèmes de sols multi-sports pour utilisation en intérieur - Partie 3 :
Essais sur site
Ta slovenski standard je istoveten z: prEN 14904-3
ICS:
97.220.10 Športni objekti Sports facilities
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
DRAFT
EUROPEAN STANDARD
prEN 14904-3
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2017
ICS 97.220.10 Will supersede EN 14904:2006
English Version
Surfaces for sports areas - Multi-sports floor systems for
indoor use - Part 3: In-situ testing
Sols sportifs - Sols multi-sports intérieurs - Partie 3: Sportböden - Mehrzweck-Sporthallenböden -
Essais sur site Anforderungen
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 217.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2017 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 14904-3:2017 E
worldwide for CEN national Members.
prEN 14903-3:2017 (E)
Contents Page
European foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Installation and maintenance instructions . 5
5 Requirements for site testing . 5
5.1 General . 5
5.2 Requirements on site . 6
5.2.1 General . 6
5.2.2 Linear friction . 6
5.2.3 Shock absorption . 6
5.2.4 Vertical ball behaviour . 6
5.2.5 Degree of evenness of the installed sport floor system . 7
5.3 Positioning of test apparatus on site . 7
6 Test reports . 7
6.1 General . 7
6.2 In situ test report . 7
Annex A (informative) Rotational slip resistance . 8
Bibliography . 9
prEN 14903-3:2017 (E)
European foreword
This document (prEN 14903-3:2017) has been prepared by Technical Committee CEN/TC 217 “Surfaces
for sports areas”, the secretariat of which is held by AFNOR.
This document is currently submitted to the CEN Enquiry.
This document, together with prEN 14904-1 and prEN 14904-2, will supersede EN 14904:2006.
EN 14904 consists of the following parts, under the general title Multi-sports floor systems for indoor use:
— Part 1: Essential characteristics
— Part 2: Specifications
— Part 3: In situ testing
prEN 14903-3:2017 (E)
Introduction
This European Standard is the first revision of EN 14904 which was first published in 2006. This standard
specifies procedures for in situ testing for verification of some properties (defined in EN 14904-1 and
EN 14904-2) which need to be considered for a sports floor system that is to be used for one or more than
one sport.
When setting the various performance criteria detailed within the standard, the needs of Volleyball,
Basketball, Badminton, Small sided Football, Handball and Physical Education were prioritized. Whilst
the performance criteria are applicable when one or more sports are played on a sports floor system, it
was also felt that if a facility was to be used for just one of the five aforementioned sports then this
standard would also be applicable. However, this standard may not be appropriate for single sport
centres designed for specialist sports such as Tennis or Cricket as some of the performance criteria (such
as shock absorption and angle ball rebound) are not appropriate nor are some of the test methods.
When independent third party testing of indoor multisport surfaces is required to assess compliance it is
recommended that the laboratory complies with EN ISO/IEC 17025 for the tests specified in the standard.
It should also be noted that the performance criteria and test methods within this standard are not
appropriate for Synthetic Turf or Textile surfaces when used indoors as these types of products would
not usually be considered as suitable for a multi-sport facility nor for the playing of the specified sports
listed above. Appropriate standards for these types of products are currently being developed.
prEN 14903-3:2017 (E)
1 Scope
This European Standard specifies in situ requirements for verifica
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.