Plywood — Tolerances on dimensions

ISO 1954:2013 specifies dimensional tolerances of plywood panels (length, width, thickness) and tolerances for edge straightness and squareness.

Contreplaqué — Tolérances sur dimensions

General Information

Publication Date
Technical Committee
Drafting Committee
Current Stage
9020 - International Standard under periodical review
Start Date
Completion Date
Ref Project


Buy Standard

ISO 1954:2013 - Plywood -- Tolerances on dimensions
English language
2 pages
sale 15% off
sale 15% off

Standards Content (Sample)

Second edition
Plywood — Tolerances on dimensions
Contreplaqué — Tolérances sur dimensions
Reference number
ISO 1954:2013(E)
ISO 2013

---------------------- Page: 1 ----------------------
ISO 1954:2013(E)

© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
Published in Switzerland
ii © ISO 2013 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 1954:2013(E)

Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Moisture content of panels . 1
4 Tolerances . 1
4.1 General . 1
4.2 Tolerances on length and width . 1
4.3 Tolerances on thickness . 1
4.4 Tolerance on straightness of edges . 2
4.5 Tolerance on squareness . 2
© ISO 2013 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 1954:2013(E)

ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation on the meaning of ISO specific terms and expressions related to conformity
assessment, as well as information about ISO’s adherence to the WTO principles in the Technical Barriers
to Trade (TBT) see the following URL: Foreword - Supplementary info

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.