ISO 17357-2:2014

Ships and marine technology — Floating pneumatic rubber fenders — Part 2: Low pressure

ISO 17357-2:2014 specifies the material, performance, and dimensions of low-pressure floating pneumatic rubber fenders, which are intended to be used for the berthing, and mooring of a ship to another ship or berthing structure. It also specifies the minimum test and inspection procedures for floating low-pressure pneumatic rubber fenders. ISO 17357-2:2014 does not address the methods for selecting the correct fender type or any safety hazards associated with its use.

Navires et technologie maritime — Éperons pneumatiques flottants — Partie 2: Basse pression

General Information

• Status: Published
• Publication Date: 15-Jan-2014
• ICS: 47.020.99 - Other standards related to shipbuilding and marine structures
• ICS: 83.140.99 - Other rubber and plastics products
• Technical Committee: ISO/TC 8/SC 4 - Outfitting and deck machinery
• Drafting Committee: ISO/TC 8/SC 4 - Outfitting and deck machinery
• Current Stage: 9020 - International Standard under periodical review
• Start Date: 15-Apr-2024
• Completion Date: 15-Apr-2024

Relations

• Revises: ISO 17357:2002 - Ships and marine technology — High-pressure floating pneumatic rubber fenders
• Effective Date: 11-Jun-2011

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 17357-2
First edition
2014-01-15
Ships and marine technology —
Floating pneumatic rubber fenders —
Part 2:
Low pressure
Navires et technologie maritime — Éperons pneumatiques
flottants —
Partie 2: Basse pression
Reference number
ISO 17357-2:2014(E)
©
ISO 2014

---------------------- Page: 1 ----------------------
ISO 17357-2:2014(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2014
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland
ii © ISO 2014 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 17357-2:2014(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Classification . 3
4.1 Low-pressure fender types . 3
4.2 Initial internal pressure . 3
5 Ordering information . 3
5.1 Information to the manufacturer . 3
5.2 Information from the manufacturer . 3
6 Low-pressure fender requirements . 3
6.1 Clamped end fender requirements . 3
6.2 Moulded end fender requirements . 4
6.3 Size requirements . 5
7 Performance . 5
7.1 Specification of performance . 5
7.2 Performance curves . 5
7.3 Fender performance . 5
8 Performance confirmation of prototype fender
...