ISO 11451-3:2015
(Main)Road vehicles — Vehicle test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 3: On-board transmitter simulation
Road vehicles — Vehicle test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 3: On-board transmitter simulation
ISO 11451-3:2015 specifies methods for testing the immunity of passenger cars and commercial vehicles to electromagnetic disturbances from on-board transmitters connected to an external antenna and portable transmitters with integral antennas, regardless of the vehicle propulsion system (e.g. spark ignition engine, diesel engine, electric motor).
Véhicules routiers — Méthodes d'essai d'un véhicule soumis à des perturbations électriques par rayonnement d'énergie électromagnétique en bande étroite — Partie 3: Simulation des émetteurs embarqués
General Information
Relations
Buy Standard
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 11451-3
Third edition
2015-06-01
Road vehicles — Vehicle test
methods for electrical disturbances
from narrowband radiated
electromagnetic energy —
Part 3:
On-board transmitter simulation
Véhicules routiers — Méthodes d’essai d’un véhicule soumis
à des perturbations électriques par rayonnement d’énergie
électromagnétique en bande étroite —
Partie 3: Simulation des émetteurs embarqués
Reference number
ISO 11451-3:2015(E)
©
ISO 2015
---------------------- Page: 1 ----------------------
ISO 11451-3:2015(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 11451-3:2015(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Test conditions . 1
5 Test location . 2
5.1 General . 2
5.2 Absorber lined shielded enclosure (ALSE) . 2
5.3 Outdoor test site . 2
6 Test instrumentation . 2
6.1 General . 2
6.2 Signal sources . 2
6.2.1 Transmitters with antenna outside the vehicle . 2
6.2.2 Transmitters with antenna inside the vehicle . 3
6.3 RF power and field monitoring equipment . 3
6.4 Antennas . 3
6.4.1 Transmitters with antenna outside the vehicle . 3
6.4.2 Transmitters with antenna inside the vehicle .
...
INTERNATIONAL ISO
STANDARD 11451-3
Third edition
2015-06-01
Road vehicles — Vehicle test
methods for electrical disturbances
from narrowband radiated
electromagnetic energy —
Part 3:
On-board transmitter simulation
Véhicules routiers — Méthodes d’essai d’un véhicule soumis
à des perturbations électriques par rayonnement d’énergie
électromagnétique en bande étroite —
Partie 3: Simulation des émetteurs embarqués
Reference number
ISO 11451-3:2015(E)
©
ISO 2015
---------------------- Page: 1 ----------------------
ISO 11451-3:2015(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 11451-3:2015(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Test conditions . 1
5 Test location . 2
5.1 General . 2
5.2 Absorber lined shielded enclosure (ALSE) . 2
5.3 Outdoor test site . 2
6 Test instrumentation . 2
6.1 General . 2
6.2 Signal sources . 2
6.2.1 Transmitters with antenna outside the vehicle . 2
6.2.2 Transmitters with antenna inside the vehicle . 3
6.3 RF power and field monitoring equipment . 3
6.4 Antennas . 3
6.4.1 Transmitters with antenna outside the vehicle . 3
6.4.2 Transmitters with antenna inside the vehicle .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.