Reinforcement products — Woven fabrics — Determination of width and length

ISO 5025:2017 specifies a method for determining the width and length of a woven-fabric reinforcement in the form of a roll[1] . [1] Attention is drawn to ISO 22198 which is a related International Standard dealing with textiles.

Produits de renfort — Tissus — Détermination de la largeur (laize) et de la longueur

General Information

Publication Date
Current Stage
9093 - International Standard confirmed
Completion Date
Ref Project


Buy Standard

ISO 5025:2017 - Reinforcement products -- Woven fabrics -- Determination of width and length
English language
4 pages
sale 15% off
sale 15% off

Standards Content (Sample)

Third edition
Reinforcement products — Woven
fabrics — Determination of width
and length
Produits de renfort — Tissus — Détermination de la largeur (laize) et
de la longueur
Reference number
ISO 5025:2017(E)
ISO 2017

---------------------- Page: 1 ----------------------
ISO 5025:2017(E)

© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 5025:2017(E)

Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 1
5 Apparatus . 1
6 Sampling, type of test specimen and number of test specimens . 2
7 Procedure. 2
7.1 General . 2
7.2 Width . 2
7.3 Length . 2
8 Expression of results . 2
8.1 Width . 2
8.2 Length . 2
9 Precision . 2
10 Test report . 3
Bibliography . 4
© ISO 2017 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 5025:2017(E)

ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see
Any trade name used in this document is information given for the co

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.