ISO 2537:2007
(Main)Hydrometry — Rotating-element current-meters
Hydrometry — Rotating-element current-meters
ISO 2537:2007 specifies the operational requirements, construction, calibration, and maintenance of rotating-element devices for the measurement of flow velocities in open channels.
Hydrométrie — Moulinets à élément rotatif
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 2537
Fourth edition
2007-05-01
Hydrometry — Rotating-element current-
meters
Hydrométrie — Moulinets à élément rotatif
Reference number
ISO 2537:2007(E)
©
ISO 2007
---------------------- Page: 1 ----------------------
ISO 2537:2007(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall
not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the
unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2007
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
©
ii ISO 2007 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 2537:2007(E)
Contents Page
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle of operation . 1
5 Types of current-meters . 2
6 Operational requirements . 2
7 Characteristics of cup-type and propeller-type current-meter . 3
8 Construction features . 3
9 Calibration (rating) . 3
10 Maintenance of current-meter . 6
11 Operational and servicing manual . 6
Annex A (normative) Construction features of current-meters . 7
Annex B (normative) Maintenance of current-meter . 11
Bibliography . 13
©
ISO 2007 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 2537:2007(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International
Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.