SIST EN IEC 60317-89:2024
(Main)Specifications for particular types of winding wires - Part 89: Polyesterimide enameled round aluminum wire, class 200 (IEC 60317-89:2023)
Specifications for particular types of winding wires - Part 89: Polyesterimide enameled round aluminum wire, class 200 (IEC 60317-89:2023)
IEC 60317-89:2023 specifies the requirements of enamelled round aluminium winding wire of class 200 with a sole coating based on polyesterimide resin, which can be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. NOTE A modified resin is a resin that has undergone a chemical change, or contains one or more additives to enhance certain performance or application characteristics. The range of nominal conductor diameters covered by this standard is as follows:
grade 1: 0,250 mm up to and including 1,600 mm;
grade 2: 0,250 mm up to and including 5,000 mm.
The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-3:2008 and IEC 60317-0-3:2008/AMD1:2013. This International Standard is to be used in conjunction with IEC 60317-0-3:2008, its Amendment 1 (2013) and its Amendment 2 (2019).
Technische Lieferbedingungen für bestimmte Typen von Wickeldrähten Teil 89: Runddrähte aus Aluminium, lackisoliert mit Polyesterimid, Klasse 200 (IEC 60317-89:2023)
Spécifications pour types particuliers de fils de bobinage - Partie 89: Fil de section circulaire en aluminium émaillé au polyestérimide, classe 200 (IEC 60317-89:2023)
IEC 60317-89-2023 spécifie les exigences relatives aux fils de bobinage de section circulaire en aluminium émaillé de classe 200, avec un revêtement simple à base de résine polyestérimide, qui peut être modifiée sous réserve qu'elle conserve l'identité chimique de la résine initiale et respecte l'ensemble des exigences spécifiées du fil. NOTE Une résine modifiée est une résine dont les propriétés chimiques ont été modifiées, ou qui contient un ou plusieurs additifs visant à améliorer certaines performances ou caractéristiques d’application. La gamme des diamètres nominaux des conducteurs couverte par la présente norme est:
grade 1: de 0,250 mm jusqu’à 1,600 mm (inclus);
grade 2: de 0,250 mm jusqu’à 5,000 mm (inclus).
Les diamètres nominaux des conducteurs sont spécifiés à l’Article 4 de l’IEC 60317-0-3:2008 et de l’IEC 60317-0-3:2008/AMD1:2013. La présente Norme internationale doit être utilisée conjointement avec l'IEC 60317-0-3:2008, son Amendement 1 (2013) et son Amendement 2 (2019).
Specifikacije za posebne vrste navijalnih žic - 89. del: Okrogla aluminijeva žica, lakirana s poliesterimidnim lakom, razred 200 (IEC 60317-89:2023)
Standard IEC 60317-89:2023 določa zahteve za okroglo aluminijevo navijalno žico razreda 200, lakirano z eno samo prevleko na osnovi poliestramidne smole, ki se lahko spremeni, če ohrani kemijsko identiteto izvirne smole in izpolnjuje vse določene zahteve za žice. OPOMBA: Spremenjena smola je smola, ki je bila kemijsko spremenjena ali vsebuje enega ali več aditivov za izboljšanje določene lastnosti učinkovitosti ali uporabe. Razpon nazivnega premera prevodnika, ki ga zajema ta standard, je, kot sledi:
razred 1: od 0,250 mm do (vključno) 1,600 mm;
razred 2: od 0,250 mm do (vključno) 5,000 mm.
Nazivni premeri prevodnika so navedeni v točki 4 standarda IEC 60317-0-3:2008 in IEC 60317-0-3:2008/AMD1:2013. Ta mednarodni standard je treba uporabljati v povezavi s standardom IEC 60317-0-3:2008, njegovo spremembo 1 (2013) in spremembo 2 (2019).
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN IEC 60317-89:2024
01-maj-2024
Specifikacije za posebne vrste navijalnih žic - 89. del: Okrogla aluminijeva žica,
lakirana s poliesterimidnim lakom, razred 200 (IEC 60317-89:2023)
Specifications for particular types of winding wires - Part 89: Polyesterimide enameled
round aluminum wire, class 200 (IEC 60317-89:2023)
Technische Lieferbedingungen für bestimmte Typen von Wickeldrähten Teil 89:
Runddrähte aus Aluminium, lackisoliert mit Polyesterimid, Klasse 200 (IEC 60317-
89:2023)
Spécifications pour types particuliers de fils de bobinage - Partie 89: Fil de section
circulaire en aluminium émaillé au polyestérimide, classe 200 (IEC 60317-89:2023)
Ta slovenski standard je istoveten z: EN IEC 60317-89:2023
ICS:
29.060.10 Žice Wires
77.150.10 Aluminijski izdelki Aluminium products
SIST EN IEC 60317-89:2024 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN IEC 60317-89:2024
---------------------- Page: 2 ----------------------
SIST EN IEC 60317-89:2024
EUROPEAN STANDARD EN IEC 60317-89
NORME EUROPÉENNE
EUROPÄISCHE NORM September 2023
ICS 29.060.10
English Version
Specifications for particular types of winding wires - Part 89:
Polyesterimide enamelled round aluminum wire, class 200
(IEC 60317-89:2023)
Spécifications pour types particuliers de fils de bobinage - Technische Lieferbedingungen für bestimmte Typen von
Partie 89: Fil de section circulaire en aluminium émaillé au Wickeldrähten Teil 89: Runddrähte aus Aluminium,
polyestérimide, classe 200 lackisoliert mit Polyesterimid, Klasse 200
(IEC 60317-89:2023) (IEC 60317-89:2023)
This European Standard was approved by CENELEC on 2023-09-04. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Türkiye and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 60317-89:2023 E
---------------------- Page: 3 ----------------------
SIST EN IEC 60317-89:2024
EN IEC 60317-89:2023 (E)
European foreword
The text of document 55/1939/CDV, future edition 1 of IEC 60317-89, prepared by IEC/TC 55
"Winding wires" was submitted to the IEC-CENELEC parallel vote and approved by CENELEC as
EN IEC 60317-89:2023.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2024-06-04
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2026-09-04
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 60317-89:2023 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standard indicated:
IEC 60264 (series) NOTE Approved as EN 60264 (series)
IEC 60317 (series) NOTE Approved as EN 60317 (series)
IEC 60851 (series) NOTE Approved as EN 60851 (series)
2
---------------------- Page: 4 ----------------------
SIST EN IEC 60317-89:2024
EN IEC 60317-89:2023 (E)
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documen
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.