SIST EN 15869-2:2010
(Main)Inland navigation vessels - Electrical shore connection, three phase current 400 V, up to 63 A, 50 Hz - Part 2: Onshore unit, safety requirements
Inland navigation vessels - Electrical shore connection, three phase current 400 V, up to 63 A, 50 Hz - Part 2: Onshore unit, safety requirements
This European Standard specifies requirements applicable to equipment for shore-to-vessel supply of threephase 400 V electrical power up to 63 A and a frequency of 50 Hz to berthed inland navigation vessels. This part of the European Standard specifies safety requirements for the onshore unit of the electrical shore connection. This part of the European Standard applies only to the supply of inland navigation vessels in ports and berths for commercial shipping. Supply stations for leisure craft and houseboats in marinas or similar locations have to meet the requirements of IEC 60364-7-709. For low-voltage electrical installations, the requirements specified in the HD 60364 and HD 384 series are applicable generally. The requirements in this part of EN 15869 supplement, amend or supersede some of the requirements in HD 60364/HD 384 Parts 1 to 6. Where no requirements are given in this part of EN 15869, the requirements specified in the HD 60364 and HD 384 are applicable; a detailed list is given in the Bibliography.
Fahrzeuge der Binnenschifffahrt - Elektrischer Landanschluss, Drehstrom 400 V, bis 63 A, 50 Hz - Teil 2: Landseitiger Teil, sicherheitstechnische Anforderungen
Diese Europäische Norm legt Anforderungen an Vorrichtungen zur landseitigen Versorgung von stilliegenden Fahrzeugen der Binnenschifffahrt mit elektrischer Energie, Drehstrom 400 V, mit einer Stromstärke bis 32 A und der Frequenz von 50 Hz fest.
Dieser Teil der Europäischen Norm legt sicherheitstechnische Anforderungen an den landseitigen Teil des elektrischen Landanschlusses fest.
Bateaux de navigation intérieure - Connexion au réseau électrique terrestre, courant triphasé de 400 V, 63 A maximum, 50 Hz - Partie 2: Unité terrestre, exigences de sécurité
La présente Norme européenne prescrit des exigences relatives aux dispositifs d’alimentation terrestre en énergie électrique, courant triphasé de 400 V, d’une intensité maximale de 63 A, fréquence de 50 Hz, de bateaux de navigation intérieure à l’arrêt.
La présente partie de la norme européenne stipule des exigences de sécurité concernant l’unité terrestre de la connexion au réseau électrique terrestre.
La présente partie de la norme européenne concerne uniquement l’alimentation des bateaux de navigation intérieure dans les ports et aux places de mouillage dédiées à la navigation intérieure commerciale. Pour l’alimentation des bateaux de sport et des bateaux d’habitation dans les marinas et autres installations semblables, les exigences de la CEI 60364-7-709 s’appliquent.
Pour les installations à basse tension, les exigences des séries HD 60364 et HD 384 s’appliquent en général. Les exigences énoncées dans la présente partie de l’EN 15869 complètent, modifient ou remplacent certaines des exigences figurant dans les parties 1 à 6 des HD 60364/HD 384. En l’absence d’exigences dans la présente partie de l’EN 15869, les exigences des séries HD 60364 et HD 384 s’appliquent, une liste exhaustive des parties concernées étant fournie dans la bibliographie.
Plovila za celinske vode - Električne povezave s kopnim, trifazni tok 400 V, do 63 A, 50 Hz - 2. del: Kopenska enota, varnostne zahteve
Ta evropski standard določa zahteve, ki se uporabljajo za opremo za dobavo trifaznega toka 400 V električne moči do 63 A in frekvence 50 Hz s kopnega na plovilo usidranim plovilom za celinske vode. Ta del evropskega standarda določa varnostne zahteve za kopensko enoto električnih povezav s kopnim. Ta del evropskega standarda se uporablja samo za dobavo plovilom za celinske vode v pristaniščih in sidriščih za komercialni ladijski promet. Dobavne postaje za ladje za prosti čas in plovila za bivanje v marinah ali na podobnih lokacijah morajo zadoščati zahtevam IEC 60364-7-709. Za električne instalacije nizke napetosti se splošno uporabljajo zahteve, opredeljene v HD 60364 in HD 384 serijah. Zahteve tega dela EN 15869 dopolnjujejo, spremenijo ali nadomestijo nekatere od zahtev v HD 60364/HD 384 deli 1 do 6. Kjer v tem delu EN 15869 niso podane nikakršne zahteve, veljajo zahteve, opredeljene v HD 60364 in HD 384; natančen spisek je podan v bibliografiji.
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Fahrzeuge der Binnenschifffahrt - Elektrischer Landanschluss, Drehstrom 400 V, bis 63 A, 50 Hz - Teil 2: Landseitiger Teil, sicherheitstechnische AnforderungenBateaux de navigation intérieure - Connexion au réseau électrique terrestre, courant triphasé de 400 V, 63 A maximum, 50 Hz - Partie 2: Unité terrestre, exigences de sécuritéInland navigation vessels - Electrical shore connection, three phase current 400 V, up to 63 A, 50 Hz - Part 2: Onshore unit, safety requirements47.060Inland navigation vessels47.020.60Electrical equipment of ships and of marine structuresICS:Ta slovenski standard je istoveten z:EN 15869-2:2010SIST EN 15869-2:2010en,fr,de01-april-2010SIST EN 15869-2:2010SLOVENSKI
STANDARD
SIST EN 15869-2:2010
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 15869-2
February 2010 ICS 47.020.60; 47.060; 93.140 English Version
Inland navigation vessels - Electrical shore connection, three phase current 400 V, up to 63 A, 50 Hz - Part 2: Onshore unit, safety requirements
Bateaux de navigation intérieure - Connexion au réseau électrique terrestre, courant triphasé 400 V, à 63 A, 50 Hz -Partie 2: Unité terrestre, exigences de sécurité
Fahrzeuge der Binnenschifffahrt - Elektrischer Landanschluss, Drehstrom 400 V, bis 63 A, 50 Hz - Teil 2: Landseitiger Teil, sicherheitstechnische Anforderungen This European Standard was approved by CEN on 25 December 2009.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2010 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 15869-2:2009: ESIST EN 15869-2:2010
EN 15869-2:2010 (E) 2 Contents Page Foreword.3 Introduction.4 1 Scope.5 2 Normative references.5 3 Terms and definitions.6 4 Safety requirements.7 4.1 General.7 4.2 Mechanical safety.8 4.3 Electrical safety.8 4.4 Other provisions.9 5 Designation.9 6 Marking.9 7 Manufacturer’s declaration of conformity.9 Bibliography.10
Figures Figure 1 — Block diagram of an electrical power-supply station with two connector units.7
SIST EN 15869-2:2010
EN 15869-2:2010 (E) 3 Foreword This document (EN 15869-2:2010) has been prepared by Technical Committee CEN/TC 15 “Inland navigation vessels”, the secretariat of which is held by DIN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by August 2010, and conflicting national standards shall be withdrawn at the latest by August 2010 EN 15869, Inland navigation vessels — Electrical shore connection — Three-phase current 400 V, up to
63 A, 50 Hz comprises: ¾ Part 1:
General requirements ¾ Part 2:
Onshore unit, safety requirements ¾ Part 3: On-board unit, safety requirements According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom.
SIST EN 15869-2:2010
EN 15869-2:2010 (E) 4
Introduction Inland navigation vessels are equipped with a variety of electrical loads operating at 230 V or 400 V.
While underway, continuous electrical power supply is provided by the onboard system from generators driven by diesel engines.
When the vessel is berthed, these generators have to remain in operation if there is no suitable onshore power supply available.
In some cases, this leads to intense noise pollution both for the crew on the vessel itself and on other vessels lying alongside and also for residents ashore.
The exhaust fumes are an additional pollution factor. The electrical shore connections specified in this standard make it possible to provide the vessels with an electrical power supply while berthed and to eliminate noise and exhaust pollution.
This calls for a uniform Europe-wide connection that can be activated and deactivated by the vessel's crew in all ports and berths, if possible, without requiring any assistance from shore-based personnel.
This standard contains electrical safety requirements for the prevention of hazards in making, using and breaking the shore connection. Furthermore, cashless settlement for the electricity used shall be possible, ideally a standard Europe-wide payment system. Electrical shore connections with a permissible current of over 63 A as used for passenger ships with a hotelling function are not covered by this standard. . . SIST EN 15869-2:2010
EN 15869-2:2010 (E) 5 1
Scope This European Standard specifies requirements applicable to equipment for shore-to-vessel supply of three-phase 400 V electrical power up to 63 A and a frequency of 50 Hz to berthed inland navigation vessels. This part of the European Standard specifies safety requirements for the onshore unit of the electrical shore connection. This part of the European Standard applies only to the supply of inland navigation vessels in ports and berths for commercial shipping.
Supply stations for leisure craft and houseboats in marinas or similar locations have to meet the requirements of IEC 60364-7-709. For low-voltage electrical installations, the requirements specified in the HD 60364 and HD 384 series are applicable generally. The requirements in this part of EN 15869 supplement, amend or supersede some of the requirements in HD 60364/HD 384 Parts 1 to 6. Where no requirements are given in this part of EN 15869, the requirements specified in the HD 60364 and HD 384 are applicable; a detailed list is given in the Bibliography. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 15869-1, Inland navigation vessels — Electrical shore connection, three-phase current 400 V, up to 63 A, 50 Hz — Part 1: General requirements EN 14145, Holders for lifebuoys
EN 60309-1, Plugs, socket-outlets and couplers for industrial purposes — Part 1: General requirements
(IEC 60309-1:1999) EN 60309-2, Plugs, socket-outlets and couplers for industrial purposes — Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories (IEC 60309-2:1999)
EN 60309-4, Plugs, socket-outlets and couplers for industrial purposes — Part 4: Switched socket-outlets and connectors with or without interlock (IEC 60309-4:2006, modified)
EN 60529, Degrees of protection provided by enclosures (IP code) (IEC 60529:1989)
EN 60898-1, Electrical accessories — Circuit-breakers for overcurrent protection for household and similar installations — Part 1:
Circuit-breakers for a.c. operation (IEC 60898-1:2002, modified)
EN 61008-1, Residual current operated circuit-breakers without integral overcurrent protection for household and similar uses (RCCBs) — Part 1: General rules (IEC
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.