SIST EN 13863-4:2005

Concrete pavements - Part 4: Test methods for the determination of wear resistance of concrete pavements to studded tyres

This European Standard describes a test method for determination of wear resistance of specimens cut from hardened concrete pavements. It is possible to use the method for testing moulded specimens from laboratory.
NOTE   The test method is applicable for the finished concrete (end product testing) and not only for the aggregate as described in EN 1097-9. In the report of the Swedish Road and Transport Research Institute on a " Ring Analysis of Nordic Road Simulators: Proposal for a common test method for the determination of the wear resistance of concrete pavements", No. 774A-1996, more information of the methods precision is given.

Fahrbahnbefestigungen aus Beton - Teil 4: Prüfverfahren zur Bestimmung des Widerstandes gegen Verschleiß durch Spikereifen von Fahrbahnbefestigungen aus Beton

Dieses Dokument beschreibt ein Prüfverfahren zur Bestimmung des Verschleißwiderstandes gegen Spikereifen
von Prüfkörpern, die aus Fahrbahnbefestigungen aus erhärteten Beton entnommen werden oder von im
Laboratorium hergestellten Prüfkörpern.
ANMERKUNG Das Prüfverfahren ist nicht nur nach EN 1097-9 auf Gesteinskörnungen anwendbar, sondern auch auf
Fertigbeton (Prüfung des Endprodukts). Der Bericht des Swedish Road and Transport Research Institute, in dem im Rahmen
eines Ringversuchs mit Simulatoren für nordische Straßen (Ring Analyses of Nordic Road Simulators) ein Vorschlag für ein
allgemeines Prüfverfahren zur Bestimmung der Verschleißfestigkeit von Betondecken unterbreitet wird, enthält weitere
Informationen zur Präzision der Verfahren (siehe Literaturhinweise).
Dieses Dokument enthält drei Prüfverfahren.

Revetements en béton - Partie 4: Méthodes d'essai pour la détermination de la résistance a l'usure des chaussées béton par abrasion provoquée par les pneus a crampons

Ce document décrit une méthode d'essai pour la mesure de la résistance aux pneus cloutés des carottes de chaussées béton apres prise ou d'éprouvettes moulées en laboratoire.
NOTE   Cette méthode d'essai est applicable sur le béton lui-meme (produit fini) et pas seulement sur les granulats comme indiqué dans la EN 1097-9. Dans un rapport de l'Institut suédois de recherche sur les routes et les transports (1996) : "Analyse circulaire des simulateurs d'usure par pneus cloutés : proposition pour une méthode commune de détermination des la résistance a l'usure par des pneus a crampon des revetements en béton", une estimation des fidélités des méthodes est donnée (voir bibliographie).
Ce document décrit trois processus opératoires.

Betonska vozišča - 4. del: Preskusne metode za ugotavljanje odpornosti betonskih vozišč proti obrabi pri uporabi ježevk

General Information

• Status: Withdrawn
• Publication Date: 30-Apr-2005
• Withdrawal Date: 01-Aug-2012
• ICS: 93.080.20 - Road construction materials
• Technical Committee: CES - Roads
• Current Stage: 9900 - Withdrawal (Adopted Project)
• Start Date: 01-Aug-2012
• Due Date: 24-Aug-2012
• Completion Date: 02-Aug-2012
• Ref Project: EN 13863-4:2004 - Concrete pavements - Part 4: Test methods for the determination of wear resistance of concrete pavements to studded tyres

Relations

• Replaced By: SIST EN 13863-4:2012 - Concrete pavements - Part 4: Test methods for the determination of wear resistance of concrete pavements to studded tyres
• Effective Date: 01-Sep-2012

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 13863-4:2005
01-maj-2005
%HWRQVNDYR]LãþDGHO3UHVNXVQHPHWRGH]DXJRWDYOMDQMHRGSRUQRVWLEHWRQVNLK
YR]LãþSURWLREUDELSULXSRUDELMHåHYN
Concrete pavements - Part 4: Test methods for the determination of wear resistance of
concrete pavements to studded tyres
Fahrbahnbefestigungen aus Beton - Teil 4: Prüfverfahren zur Bestimmung des
Widerstandes gegen Verschleiß durch Spikereifen von Fahrbahnbefestigungen aus
Beton
Revetements en béton - Partie 4: Méthodes d'essai pour la détermination de la
résistance a l'usure des chaussées béton par abrasion provoquée par les pneus a
crampons
Ta slovenski standard je istoveten z: EN 13863-4:2004
ICS:
93.080.20 Materiali za gradnjo cest Road construction materials
SIST EN 13863-4:2005 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 13863-4:2005

---------------------- Page: 2 ----------------------

SIST EN 13863-4:2005
EUROPEAN STANDARD
EN 13863-4
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2004
ICS 93.080.20

English version
Concrete pavements - Part 4: Test methods for the
determination of wear resistance of concrete pavements to
studded tyres
Fahrbahnbefestigungen aus Beton - Teil 4: Prüfverfahren
zur Bestimmung des Widerstandes gegen Verschleiß durch
Spikereifen von Fahrbahnbefestigungen aus Beton
This European Standard was approved by CEN on 2 September 2004.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2004 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 13863-4:2004: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 13863-4:2005
EN 13863-4:2004 (E)
Contents
Page
Foreword.3
1 Scope .4
2 Normative references .4
3 Test specimen.4
4 Test equipment .5
5 Preparation of samples .6
6 Procedure .6
7 Report .8
Bibliography .9

2

---------------------- Page: 4 ----------------------

SIST EN 13863-4:2005
EN 13863-4:2004 (E)
Foreword
This document (EN 13863-4:2004) has been prepared by Technical Committee CEN/TC 227 “Road materials”,
the secretariat of which is held by DIN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by May 2005, and conflicting national standards shall be withdrawn at the
latest by May 2005.
This European Standard is one of a series concerned with test methods for the functional requirements for
concrete pavements.
EN 13863-1, Concrete pavements — Part 1: Test method for the determination of the thickness of a concrete
pavement by survey method.
EN 13863-2, Concrete pavements — Part 2: Test method for the determination of the bond between two
layers.
EN 13863-3, Concrete pavements — Part 3: Test methods for the determination of the thickness of a
concrete pavement from cores.
EN 13863-4, Concrete pavements — Part 4: Test methods for the determination of wear resistance of
concrete pavements to studded tyres.
No European Standard is superseded.
This document includes a Bibliography.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Cyprus, Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, Switzerland
and United Kingdom.
3

---------------------- Page: 5 ----------------------

SIST EN 13863-4:2005
EN 13863-4:2004 (E)
1 Scope
This document describes a test method for the determination of the wear resistance to studded tyres of
specimens cut from hardened concrete pavements or moulded laboratory specimens.
NOTE The test method is applicable for the finished concrete (end product testing) and not only for the aggregate as
described in EN 1097-9. In the report from Swedish Road and Transport Research Institute (1996) “Ring Analysis of
Nordic Road Simulators: Proposal for a common test method for the determination of the wear resistance of concrete
pavements” more information of the methods precision is given (see Bibliography).
This document describes three proceedings for testing.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
EN 196-6, Methods of testing cement — Determination of fineness.
EN 197-1, Cement — Part 1: Composition, specifications and conformity criteria of common cements.
EN 1097-9, Tests for mechanical and physical properties of aggregate — Part 9: Determination of the
resistance to wear by abrasion from studded tyres - Nordic test.
EN 12504-1, Testing
...