SIST-TS CEN/TS 15082:2008
(Main)Wood preservatives - Determination of the preventive effectiveness against sapstain fungi and mould fungi on freshly sawn timber - Field test
Wood preservatives - Determination of the preventive effectiveness against sapstain fungi and mould fungi on freshly sawn timber - Field test
This CEN Technical Specification specifies a field test method for determining the effectiveness of a product in the prevention of the colonization of freshly felled wood by sapstain fungi and mould fungi.
Holzschutzmittel - Bestimmung der vorbeugenden Wirksamkeit gegen Schnittholzbläue und Schimmelpilze auf frisch geschnittenem Holz - Feldversuch
Diese Technische Spezifikation legt ein Feldversuchsverfahren zur Bestimmung der Wirksamkeit eines Produktes bei der Vorbeugung gegen die Besiedelung durch Schnittholzbläue und Schimmelpilze von frisch gefälltem Holz fest.
Produits de préservation du bois - Détermination de l'efficacité préventive contre le bleuissement et les moisissures des sciages frais - Essai de champ
Le présent document spécifie une méthode d'essai de champ pour la détermination de l'efficacité préventive d'un produit contre la colonisation de bois fraîchement abattus par les champignons de bleuissement et les moisissures.
Zaščitna sredstva za les - Ugotavljanje preventivne učinkovitosti zaščitnega sredstva proti glivam modrivkam in plesnim na sveže posekanem lesu - Terenska metoda
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST-TS CEN/TS 15082:2008
01-december-2008
=DãþLWQDVUHGVWYD]DOHV8JRWDYOMDQMHSUHYHQWLYQHXþLQNRYLWRVWL]DãþLWQHJD
VUHGVWYDSURWLJOLYDPPRGULYNDPLQSOHVQLPQDVYHåHSRVHNDQHPOHVX7HUHQVND
PHWRGD
Wood preservatives - Determination of the preventive effectiveness against sapstain
fungi and mould fungi on freshly sawn timber - Field test
Holzschutzmittel - Bestimmung der vorbeugenden Wirksamkeit gegen Schnittholzbläue
und Schimmelpilze auf frisch geschnittenem Holz - Feldversuch
Produits de préservation du bois - Détermination de l'efficacité préventive contre le
bleuissement et les moisissures des sciages frais - Essai de champ
Ta slovenski standard je istoveten z: CEN/TS 15082:2005
ICS:
71.100.50 .HPLNDOLMH]D]DãþLWROHVD Wood-protecting chemicals
SIST-TS CEN/TS 15082:2008 en,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TS CEN/TS 15082:2008
---------------------- Page: 2 ----------------------
SIST-TS CEN/TS 15082:2008
TECHNICAL SPECIFICATION
CEN/TS 15082
SPÉCIFICATION TECHNIQUE
TECHNISCHE SPEZIFIKATION
July 2005
ICS 71.100.50
English version
Wood preservatives - Determination of the preventive
effectiveness against sapstain fungi and mould fungi on freshly
sawn timber - Field test
Produits de préservation du bois - Détermination de Holzschutzmittel - Bestimmung der vorbeugenden
l'efficacité préventive contre le bleuissement et les Wirksamkeit gegen Schnittholzbläue und Schimmelpilze
moisissures des sciages frais - Essai de champ auf frisch geschnittenem Holz - Feldversuch
This Technical Specification (CEN/TS) was approved by CEN on 1 March 2005 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to submit their
comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS available
promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in parallel to the CEN/TS)
until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 15082:2005: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST-TS CEN/TS 15082:2008
CEN/TS 15082:2005 (E)
Contents Page
Foreword .3
Introduction.4
1 Scope .5
2 Terms and definitions.5
3 Principle.5
4 Test material and apparatus.5
5 Sampling of the preservative .6
6 Test specimens .6
7 Procedure .7
8 Validity of the test .9
9 Test report .9
Annex A (informative) Reference formulation copper-8-quinolinolate.11
Annex B (informative) Example of storage conditions.12
Annex C (informative) Example of a test report .13
Bibliography.15
2
---------------------- Page: 4 ----------------------
SIST-TS CEN/TS 15082:2008
CEN/TS 15082:2005 (E)
Foreword
This document (CEN/TS 15082:2005) has been prepared by Technical Committee CEN/TC 38 “Durability of
wood and wood-based products”, the secretariat of which is held by AFNOR.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to announce this CEN Technical Specification: Austria, Belgium, Cyprus, Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, Switzerland
and the United Kingdom.
3
---------------------- Page: 5 ----------------------
SIST-TS CEN/TS 15082:2008
CEN/TS 15082:2005 (E)
Introduction
This CEN Technical Specification specifies a field test method which gives a basis for assessing the
effectiveness of a wood preservative product for the protection of freshly felled timber against colonization by
sapstain, mould and other disfiguring micro-organisms. This field test method provides one criterion by which
the value of a product can be assessed. If little is known about the activity of a product against sapstain and
mould fungi, it is advisable to carry out a preliminary laboratory assessment using a suitable method.
To ensure that colonization of the test specimens will occur, the test should be carried out at sites where
sapstain and mould growth occur on untreated susceptible timber species and should be carried out to
coincide with the periods of higher fungal activity.
NOTE Periods of highest fungal activity are usually in the spring and autumn. If tests have not been conducted at a
location previously, local experience should be sought to determine the most appropriate time of year.
The procedures described in this CEN Technical Specification are intended to be carried out by suitably
trained and/or supervised specialists. Appropriate safety precautions should be observed throughout the use
of the CEN Technical Specification.
4
---------------------- Page: 6 ----------------------
SIST-TS CEN/TS 15082:2008
CEN/TS 15082:2005 (E)
1 Scope
This CEN Technical Specification specifies a field test method for determining the effectiveness of a product in
the prevention of the colonization of freshly felled wood by sapstain fungi and mould fungi.
2 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
2.1
representative sample
sample having its physical or chemical characteristics identical to the volumetric average characteristics of the
total volume being sampled
2.2
supplier
sponsor of the test (person or company providing the sample of wood preservatives to be tested)
3 Principle
Treatment of several series of test specimens of a susceptible wood species with solutions in which the
concentrations of the test product are ranged in a given progression. Treatment of two series of similar test
specimens with defined concentrations of a reference formulation. Exposure of these test specimens to
colonization by the natural microflora. Comparison of the effectiveness of the test product with that of the
reference formulation and the untreated control test specimens.
4 Test material and apparatus
4.1 Products and reagents
4.1.1 Diluents
For water-soluble or water-diluable preservatives use water of drinkable quality.
4.1.2 Reference formulation
Copper-8-quinolinolate.
NOTE 1 Details on this wood preservative are given in Annex A.
NOTE 2 If experience with another reference formulation is available in field tests in comparison with copper-8-
quinolinolate, then an equivalent reference formulation can be used.
5
---------------------- Page: 7 ----------------------
SIST-TS CEN/TS 15082:2008
CEN/TS 15082:2005 (E)
4.2 Apparatus
4.2.1 Dipping tank, suitable for dipping the size of test specimen used (see 6.3) and the volume of solution
(see 7.1.1).
4.2.2 Supports, for the test specimens during exposure. The supports shall be made of the same species of
timber as the test specimens or any inert material, that it is to say with no risk or interacting with the test
specimens or the reference and test preservative treatments. They shall provide support for the test
specimens between 100 mm and 200 mm above the level of the surrounding ground.
NOTE It is convenient to use pallets so that complete stacks can be moved mechanically.
4.2.3 Stickers, to separate the test specimens in the top half of each stack. The stickers shall be made of
the same species of timber as the test specimens and treated with the same concentration of preservative, or
any inert material, that is to say with no risk of interacting with the test specimens or the reference and test
preservative treatments. The stickers shall separate the test specimens by (20 ± 5) mm.
4.2.4 Securing bands, to secure the test specimens in the stack during storage.
4.2.5 Exposure site, an open area free from extremes of local environmental influences, especially
industrial pollution. The type of surface (e.g. grass, soil or concrete) shall be the same for all stacks in any test
and details shall be recorded in the test report. Any vegetation shall be maintained at a level below that of the
top of the supports on which the test specimens are stacked (see 4.2.2).
The prevailing meteorological conditions during the test exposure period shall be recorded and included in the
test report.
4.2.6 Ordinary laboratory equipment, including a balance capable of weighing to an accuracy of 1 g.
5 Sampling of the preservative
The sample of preservative shall be representative of the product to be tested. Samples shall be stored and
handled in accordance with any written recommendations from the supplier.
NOTE For the sampling of preservatives from bulk supplies, the procedure given in EN 212 should be used.
6 Test specimens
6.1 Species of wood
The species of wood to be used shall be susceptible to attack by sapstain and mould fungi.
The reference species should be a susceptible pine species, either Scots pine (Pinus sylvestris Linnaeus),
Corsican pine (Pinus nigra var. maritime) or maritime pine (Pinus pinaster).
NOTE Tests can be undertaken using other species (e.g. spruce, beech) corresponding to the above characteristics
and of particular importance for certain countries, but a reference pine species treated with the reference formulation
should also be included to validate the severity of the test. When the test has been conducted using other species (e.g.
spruce, beech) the results are only valid for that species.
6
---------------------- Page: 8 ----------------------
SIST-TS CEN/TS 15082:2008
CEN/TS 15082:2005 (E)
6.2 Wood quality
The wood shall be free from cracks, stain, decay, insect damage and other defects but sound knots are
permitted. The wood shall not have been water-stored, floated, chemically treated or steamed. The wood shall
originate from trees felled in spring or autumn. The trees shall be conve
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.