EN 60598-2-11:2013/A1:2022
(Amendment)Luminaires - Part 2-11: Particular requirements - Aquarium luminaires
Luminaires - Part 2-11: Particular requirements - Aquarium luminaires
No scope available
Leuchten - Teil 2-11: Besondere Anforderungen - Aquarienleuchten
Luminaires - Partie 2-11: Exigences particulières - Luminaires pour aquarium
Svetilke - 2-11. del: Posebne zahteve - Svetilke za akvarije - Dopolnilo A1 (IEC 60598-2-11:2013/AMD1:2022)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-november-2022
Svetilke - 2-11. del: Posebne zahteve - Svetilke za akvarije - Dopolnilo A1 (IEC
60598-2-11:2013/AMD1:2022)
Luminaires - Part 2-11: Particular requirements - Aquarium luminaires (IEC 60598-2-
11:2013/AMD1:2022)
Leuchten - Teil 2-11: Besondere Anforderungen - Aquarienleuchten (IEC 60598-2-
11:2013/AMD1:2022)
Luminaires - Partie 2-11: Exigences particulières - Luminaires pour aquarium (IEC 60598
-2-11:2013/AMD1:2022)
Ta slovenski standard je istoveten z: EN 60598-2-11:2013/A1:2022
ICS:
29.140.40 Svetila Luminaires
97.180 Razna oprema za dom in Miscellaneous domestic and
trgovino commercial equipment
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN 60598-2-11:2013/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM September 2022
ICS 29.140.40
English Version
Luminaires - Part 2-11: Particular requirements - Aquarium
luminaires
(IEC 60598-2-11:2013/AMD1:2022)
Luminaires - Partie 2-11: Exigences particulières - Leuchten - Teil 2-11: Besondere Anforderungen -
Luminaires pour aquarium Aquarienleuchten
(IEC 60598-2-11:2013/AMD1:2022) (IEC 60598-2-11:2013/AMD1:2022)
This amendment A1 modifies the European Standard EN 60598-2-11:2013; it was approved by CENELEC on 2022-08-08. CENELEC
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this amendment the
status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as
the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Türkiye and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 60598-2-11:2013/A1:2022 E
European foreword
The text of document 34D/1612/CDV, future IEC 60598-2-11/AMD1, prepared by SC 34D
"Luminaires" of IEC/TC 34 "Lighting" was submitted to the IEC-CENELEC parallel vote and approved
by CENELEC as EN 60598-2-11:2013/A1:2022.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2023-05-08
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2025-08-08
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a Standardization Request given to CENELEC by the
European Commission and the European Free Trade Association, and supports essential
requirements of EU Directive(s) / Regulation(s).
For the relationship with EU Directive(s) / Regulation(s), see informative Annex ZZ, which is an
integral part of this document.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 60598-2-11:2013/AMD1:2022 was approved by CENELEC
as a European Standard without any modification.
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod),
the relevant EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available
here: www.cenelec.eu.
Replace the following reference:
Publication Year Title EN/HD Year
IEC 60598-1 - Luminaires - Part 1: General requirements EN IEC 60598-1 2021
and tests
Annex ZZ
(informative)
Relationship between this European standard and the safety
objectives of Directive 2014/35/EU [2014 OJ L96] aimed to be
covered
This European Standard has been prepared under a Commission’s standardization request relating to
harmonized standards in the field of the Low Voltage Directive, M/511, to provide one voluntary means
of conforming to safety objectives of Directive 2014/35/EU of the European Parliament and of the
Council of 26 February 2014 on the harmonization of the laws of the Member States relating to the
making available on the market of electrical equipment designed for use within certain voltage limits
[2014 OJ L96].
Once this standard is cited in the Official Journal of the European Union under that Directive,
compliance with the normative clauses of this standard given in Table ZZ.1 confers, within the limits of
the scope of this standard, a presumption of conformity with the corresponding safety objectives of
that Directive, and associated EFTA regulations.
Table ZZ.1 — Correspondence between this European standard and Annex I of Directive
2014/35/EU [2014 OJ L96]
Clause(s) / sub-clause(s)
Safety objectives of Directive 2014/35/EU Remarks / Notes
of this EN
1. General conditions
a) the essential characteristics, the recognition 11.6
and observance of which will ensure that
electrical equipment will be used safely and in
applications for which it was made, shall be
marked on the electrical equipment, or, if this
is not possible, on an accompanying
document;
b) the electrical equipment, together with its All
component parts, shall be made in such a way
as to ensure that it can be safely and properly
assembled and connected;
c) the electrical equipment shall be so See item 2 and 3 of this
designed and manufactured as to ensure that table
protection against the hazards set out in points
2 and 3 is assured, providing that the
equipment is used in applications for which it
was made and is adequately maintained.
2. Protection against hazards arising from the electrical equipment
Measures of a technical nature shall be laid down in accordance with point 1, in order to ensure that:
a) persons and domestic animals are 11.7
adequately protected against the danger of
11.8
physical injury or other harm which might be
11.9
caused by direct or indirect contact;
11.10
11.11
11.12
11.15
b) temperatures, arcs or radiation which would 11.7
cause a danger, are not produced;
11.8
11.13
11.15
c) persons, domestic animals and property are 11.7
adequately protected against non-electrical
11.8
dangers caused by the electrical equipment
which are revealed by experience;
d) the insulation is suitable for foreseeable 11.8
conditions.
11.14
11.15
3. Protection against hazards which may be caused by external influences on the electrical
equipment
Technical measures shall be laid down in accordance with point 1, in order to ensure that the electrical
equipment:
a) meets the expected mechanical 11.6
requirements in such a way that persons,
11.7
domestic animals and property are not
endangered;
b) is resistant to non-mechanical influences in 11.14
expected environmental conditions, in such a
11.16
way that persons, domestic animals and
property are not endangered;
c) does not endanger persons, domestic 11.7
animals and property in foreseeable conditions
11.13
of overload.
11.16
WARNING 1 — Presumption of conformity stays valid only as long as a reference to this European
standard is maintained in the list published in the Official Journal of the European Union. Users of this
standard should consult frequently the latest list published in the Official Journal of the European
Union.
WARNING 2 — Other Union legislation may be applicable to the product(s) falling within the scope of
this standard.
IEC 60598-2-11 ®
Edition 2.0 2022-07
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
A MENDMENT 1
AM ENDEMENT 1
Luminaires –
Part 2-11: Particular requirements – Aquarium luminaires
Luminaires –
Partie 2-11: Exigences particulières – Luminaires pour aquarium
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONA
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.