SIST EN 300 341 V2.1.1:2016

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.DUPRQL]LUDQL(8Land Mobile Service - Radio equipment using an integral antenna transmitting signals to initiate a specific response in the receiver - Harmonised Standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU33.070.01Mobilni servisi na splošnoMobile services in general33.060.99Druga oprema za radijske komunikacijeOther equipment for radiocommunicationsICS:Ta slovenski standard je istoveten z:ETSI EN 300 341 V2.1.1 (2016-03)SIST EN 300 341 V2.1.1:2016en01-junij-2016SIST EN 300 341 V2.1.1:2016SLOVENSKI

ETSI EN 300 341 V2.1.1 (2016-03) Land Mobile Service; Radio equipment using an integral antenna transmitting signals to initiate a specific response in the receiver; Harmonised Standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU

Reference REN/ERM-TGDMR-352 Keywords analogue, mobile, PMR, radio, signalling ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE

Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88

Important notice The present document can be downloaded from: http://www.etsi.org/standards-search The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at https://portal.etsi.org/TB/ETSIDeliverableStatus.aspx If you find errors in the present document, please send your comment to one of the following services: https://portal.etsi.org/People/CommiteeSupportStaff.aspx Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media.

DECTTM, PLUGTESTSTM, UMTSTM and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association. SIST EN 300 341 V2.1.1:2016

ETSI ETSI EN 300 341 V2.1.1 (2016-03) 3 Contents Intellectual Property Rights ................................................................................................................................ 6 Foreword ............................................................................................................................................................. 6 Modal verbs terminology .................................................................................................................................... 6 1 Scope ........................................................................................................................................................ 7 2 References ................................................................................................................................................ 7 2.1 Normative references ......................................................................................................................................... 7 2.2 Informative references ........................................................................................................................................ 8 3 Definitions, symbols and abbreviations ................................................................................................... 8 3.1 Definitions .......................................................................................................................................................... 8 3.2 Symbols .............................................................................................................................................................. 8 3.3 Abbreviations ..................................................................................................................................................... 9 4 Speech equipment with signalling ............................................................................................................ 9 5 General and operational requirements .................................................................................................... 10 5.1 General ............................................................................................................................................................. 10 5.1.1 Environmental profile ................................................................................................................................. 10 5.1.2 Choice of model for testing ........................................................................................................................ 10 6 Test conditions, power sources and ambient temperatures .................................................................... 10 6.1 Normal and extreme test conditions ................................................................................................................. 10 6.2 Test power source ............................................................................................................................................. 10 6.3 Normal test conditions ...................................................................................................................................... 11 6.3.1 Normal temperature and humidity .............................................................................................................. 11 6.3.2 Normal test power source ............................................................................................................................ 11 6.3.2.1 Mains voltage ........................................................................................................................................ 11 6.3.2.2 Regulated lead-acid battery power sources used on vehicles ................................................................ 11 6.3.2.3 Other power sources .............................................................................................................................. 11 6.4 Extreme test conditions ..................................................................................................................................... 11 6.4.1 Extreme temperatures .................................................................................................................................. 11 6.4.2 Extreme test source voltages ....................................................................................................................... 12 6.4.2.1 Mains voltage ........................................................................................................................................ 12 6.4.2.2 Regulated lead-acid battery power sources used on vehicles ................................................................ 12 6.4.2.3 Power sources using other types of batteries ......................................................................................... 12 6.4.2.4 Other power sources .............................................................................................................................. 12 6.5 Procedure for tests at extreme temperatures ..................................................................................................... 12 6.5.0 Thermal Balance.......................................................................................................................................... 12 6.5.1 Procedure for equipment designed for continuous operation ...................................................................... 12 6.5.2 Procedure for equipment designed for intermittent operation .................................................................... 12 7 General conditions of measurement ....................................................................................................... 13 7.1 Normal test signals, test conditions and the unwanted test signals................................................................... 13 7.2 Artificial antenna ............................................................................................................................................... 13 7.3 Test sites and general arrangements for radiated measurements ...................................................................... 13 7.4 Transmitter automatic shut-off facility ............................................................................................................. 13 7.5 Modes of operation of the transmitter .............................................................................................................. 13 7.6 Arrangements for test signals at the input of the receiver via a test fixture or a test antenna ........................... 14 7.7 Receiver mute or squelch facility ..................................................................................................................... 14 7.8 Encoder for receiver measurements ................................................................................................................. 14 7.9 Facilities for access between the receiver demodulator output and its decoder ............................................... 14 7.10 Calling indicator ................................................................................................................................................ 14 7.11 Reset ................................................................................................................................................................. 14 7.12 Reset time ......................................................................................................................................................... 14 8 Technical characteristics of the transmitter ............................................................................................ 15 8.1 Frequency error ................................................................................................................................................ 15 8.1.0 Applicability ............................................................................................................................................... 15 8.1.1 Definition .................................................................................................................................................... 15 SIST EN 300 341 V2.1.1:2016

ETSI ETSI EN 300 341 V2.1.1 (2016-03) 4 8.1.2 Method of measurement ............................................................................................................................. 15 8.1.3 Limits .......................................................................................................................................................... 15 8.2 Effective radiated power ................................................................................................................................... 16 8.2.0 Applicability ............................................................................................................................................... 16 8.2.1 Definition .................................................................................................................................................... 16 8.2.2 Method of measurement .............................................................................................................................. 16 8.2.2.1 Maximum effective radiated power under normal test conditions ........................................................ 16 8.2.2.2 Average effective radiated power under normal test conditions ........................................................... 18 8.2.3 Method of measurements of maximum and average effective radiated power under extreme test conditions .................................................................................................................................................... 19 8.2.4 Limits .......................................................................................................................................................... 19 8.3 Adjacent and alternate channel power .............................................................................................................. 20 8.3.0 Applicability ............................................................................................................................................... 20 8.3.1 Definition .................................................................................................................................................... 20 8.3.2 Method of measurement .............................................................................................................................. 20 8.3.3 Limits .......................................................................................................................................................... 21 8.4 Radiated spurious emissions .............................................................................................................................. 21 8.4.0 Applicability ............................................................................................................................................... 21 8.4.1 Definition .................................................................................................................................................... 22 8.4.2 Method of measurement .............................................................................................................................. 22 8.4.3 Limits .......................................................................................................................................................... 24 8.5 Transient frequency behaviour of the transmitter ............................................................................................. 24 8.5.0 Applicability ............................................................................................................................................... 24 8.5.1 Definitions .................................................................................................................................................. 24 8.5.2 Method of measurement .............................................................................................................................. 25 8.5.3 Limits .......................................................................................................................................................... 28 9 Technical characteristics of the receiver ................................................................................................ 28 9.1 Average usable sensitivity (field strength, responses) ...................................................................................... 28 9.1.0 Applicability ............................................................................................................................................... 28 9.1.1 Definition .................................................................................................................................................... 28 9.1.2 Method of measurement under normal test conditions ............................................................................... 28 9.1.3 Method of measurement of the average usable sensitivities under extreme test conditions ....................... 30 9.1.4 References for degradation measurements ................................................................................................. 30 9.1.4.1 Definition ............................................................................................................................................... 30 9.1.4.2 Procedures for measurements using the test fixture .............................................................................. 31 9.1.4.3 Procedures for measurements using the test site ................................................................................... 31 9.1.5 Limits .......................................................................................................................................................... 31 9.2 Co-channel rejection ......................................................................................................................................... 32 9.2.0 Applicability ............................................................................................................................................... 32 9.2.1 Definition .................................................................................................................................................... 32 9.2.2 Method of measurement .............................................................................................................................. 32 9.2.3 Limits .......................................................................................................................................................... 33 9.3 Adjacent channel selectivity .............................................................................................................................. 34 9.3.0 Applicability ............................................................................................................................................... 34 9.3.1 Definition .................................................................................................................................................... 34 9.3.2 Method of measurement .............................................................................................................................. 34 9.3.3 Limits .......................................................................................................................................................... 35 9.4 Spurious response rejection ............................................................................................................................... 35 9.4.0 Applicability ............................................................................................................................................... 35 9.4.1 Definition .................................................................................................................................................... 36 9.4.2 Introduction to the method of measurement ............................................................................................... 36 9.4.3 Measurement arrangement ........................................................................................................................... 37 9.4.4 Method of the search ................................................................................................................................... 38 9.4.5 Method of measurement .............................................................................................................................. 38 9.4.6 Limits .......................................................................................................................................................... 39 9.5 Intermodulation response rejection .................................................................................................................. 39 9.5.0 Applicability ............................................................................................................................................... 39 9.5.1 Definition .................................................................................................................................................... 39 9.5.2 Method of measurement .............................................................................................................................. 40 9.5.3 Limits .......................................................................................................................................................... 41 9.6 Blocking or desensitization ............................................................................................................................... 41 SIST EN 300 341 V2.1.1:2016

ETSI ETSI EN 300 341 V2.1.1 (2016-03) 5 9.6.0 Applicability ............................................................................................................................................... 41 9.6.1 Definition .................................................................................................................................................... 41 9.6.2 Method of measurement .............................................................................................................................. 42 9.6.3 Limits .......................................................................................................................................................... 43 9.7 Receiver Spurious radiations ............................................................................................................................. 43 9.7.0 Applicability ............................................................................................................................................... 43 9.7.1 Definition .................................................................................................................................................... 43 9.7.2 Method of measurement .............................................................................................................................. 44 9.7.3 Limits .......................................................................................................................................................... 45 10 Testing for compliance with technical requirements .............................................................................. 45 10.1 Test conditions, power supply and ambient temperatures ................................................................................ 45 10.2 Interpretation of the measurement results ........................................................................................................ 46 Annex A (normative): Radiated measurement .................................................................................. 47 A.1 Test sites and general arrangements for measurements involving the use of radiated fields ................. 47 A.1.0 General ............................................................................................................................................................. 47 A.1.1 Anechoic chamber ............................................................................................................................................ 47 A.1.2 Anechoic chamber with a conductive ground plane ......................................................................................... 48 A.1.3 Open Area Test Site (OATS) ........................................................................................................................... 49 A.1.4 Test antenna ...................................................................................................................................................... 50 A.1.5 Substitution antenna ......................................................................................................................................... 50 A.1.6 Measuring antenna ........................................................................................................................................... 51 A.2 Guidance on the use of radiation test sites ............................................................................................. 51 A.2.0 General ............................................................................................................................................................. 51 A.2.1 Verification of the test site ............................................................................................................................... 51 A.2.2 Preparation of the EUT ..................................................................................................................................... 51 A.2.3 Power supplies to the EUT ............................................................................................................................... 51 A.2.4 Volume control setting for analogue speech tests ............................................................................................ 51 A.2.5 Range length ..................................................................................................................................................... 52 A.2.6 Site preparation ................................................................................................................................................ 52 A.3 Coupling of signals ................................................................................................................................. 53 A.3.1 General ............................................................................................................................................................. 53 A.3.2 Data signals ...................................................................................................................................................... 53 A.3.3 Speech and analogue signals ............................................................................................................................ 53 A.3.3.0 General ........................................................................................................................................................ 53 A.3.3.1 Acoustic coupler description....................................................................................................................... 53 A.3.3.2 Calibration .................................................................................................................................................. 53 A.4 Test fixture ............................................................................................................................................. 54 A.4.1 Description ....................................................................................................................................................... 54 A.4.2 Calibration ........................................................................................................................................................ 54 A.4.3 Mode of use ...................................................................................................................................................... 55 Annex B (normative): Specification for some particular measurement arrangements ................. 56 B.1 Power measuring receiver specification ................................................................................................. 56 B.1.0 General ............................................................................................................................................................. 56 B.1.1 IF filter ............................................................................................................................................................. 56 B.1.2 Attenuation indicator ........................................................................................................................................ 58 B.1.3 RMS value indicator ......................................................................................................................................... 58 B.1.4 Oscillator and amplifier .................................................................................................................................... 58 B.2 Spectrum analyser specification ............................................................................................................. 58 B.2.1 Adjacent and alternate channel power measurement ........................................................................................ 58 B.2.2 Unwanted emissions measurement ................................................................................................................... 59 B.3 Integrating and power summing device ................................................................................................. 59 Annex C (normative): Relationship between the present document and the essential requirements of Directive 2014/53/EU ......................................................... 60 History .............................................................................................................................................................. 62