M/284 -

To produce a Harmonised Standard under article 3.2 of the R&TTE Directive, taking into account the ECC Report 206 to support Wireless industrial automation devices within the 5,725 GHz to 5,875 GHz frequency range. Equipment related to the EN is described in TR 102 889-2.

To produce a Harmonised Standard under article 3.2 of the R&TTE Directive, taking into account the ECC Report 206 to support Wireless industrial automation devices within the 5,725 GHz to 5,875 GHz frequency range. Equipment related to the EN is described in TR 102 889-2.

The present document, together with ETSI EN 301 489-1 [1], covers the assessment of Short Range Devices (SRD) and
ancillary equipment in respect of ElectroMagnetic Compatibility (EMC).
The present document specifies the applicable test conditions, performance assessment, and performance criteria for
Short Range Devices (SRD) and the associated ancillary equipment.
In case of differences (for instance concerning special conditions, definitions, abbreviations) between the present
document and the ETSI EN 301 489-1 [1], the provisions of the present document take precedence.
The environmental classification and the emission and immunity requirements used in the present document are as
stated in the ETSI EN 301 489-1 [1], except for any special conditions included in the present document.
Technical specifications related to the antenna port of radio equipment and radiated emissions from the enclosure port
of radio equipment and combinations of radio and associated ancillary equipment are not included in the present
document. Such technical specifications are normally found in the relevant product standards for the effective use of the
radio spectrum.
The present document, together with ETSI EN 301 489-1 [1], are aimed to cover requirements to demonstrate an
adequate level of electromagnetic compatibility.

REN/ERM-EMC-332

The present document specifies technical characteristics and methods of measurements for transmitter equipment for
broadcast sound services using the Digital Audio Broadcast (DAB) modulation system operating in VHF band III
(174 MHz to 240 MHz).
The present document covers the essential requirements of article 3.2 of Directive 2014/53/EU [i.1] under the
conditions identified in annex A.
NOTE: The relationship between the present document and essential requirements of article 3.2 of Directive
2014/53/EU [i.1] is given in annex A.

REN/ERM-TG17-015

REN/MSG-0020-RED

To develope a harmonised standard for systems and equipment described in ETSI TR 103 109 taking into account the outcome of the sharing studies performed within CEPT.  It can be foressen that the required MBR antenna directivity and related pointing adjustments (e.g. to offset the movements of a ship) both in azimut and elevation are special technical requirements that, inter-alia other requirements - may need to be describes in a harmonised European standard

To develope a harmonised standard for systems and equipment described in ETSI TR 103 109 taking into account the outcome of the sharing studies performed within CEPT.  It can be foressen that the required MBR antenna directivity and related pointing adjustments (e.g. to offset the movements of a ship) both in azimut and elevation are special technical requirements that, inter-alia other requirements - may need to be describes in a harmonised European standard

The present document specifies technical characteristics and methods of measurements for radio equipment at the
Ground Station and Aircraft Station for Broadband Direct Air-to-Ground communications systems employing
beamforming antennas.
The present document covers the essential requirements of article 3.2 of Directive 2014/53/EU [i.5] under the
conditions identified in annex A.

DEN/BRAN-60013

The present document specifies technical characteristics and methods of measurements for radio equipment with
integral antennas operating indoor or outdoor at data rates of multiple-gigabit per second in the 60 GHz frequency
range.
These radio equipments operate with very wideband communications using a variety of directional medium and high
gain antennas to enable a high degree of spectrum reuse, and may use a flexible bandwidth scheme under which they
normally operate in a wideband mode, and periodically reduce their bandwidth (e.g. for antenna training and other
activities).
The technical characteristics of applications using these radio equipments are further described in ETSI
TR 102 555 [i.1].
Equipment in this frequency range intended for outdoor Fixed Local Area Network Extension (FLANE) or Fixed
Point-to-Point applications are not in the scope of the present document.

REN/BRAN-60020

REN/MSG-TFES-011-14

DEN/ERM-TGMAR-080

DEN/ERM-TG30-004-2

REN/ERM-TGSRR-056-2

REN/BRAN-60011

REN/ATTM-0431

REN/ERM-TG28-502

REN/ERM-TG17WG3-261-2

DEN/ERM-TG17-001-2

REN/ERM-RP08-0110-2

REN/ERM-TG28-045-2

REN/ERM-TG37-024

DEN/ERM-TGMAR-055-2

REN/ERM-RP08-0409-2

REN/ERM-TGSRR-049-2

REN/ERM-RP08-0311-2

REN/ERM-TG36-001-3

DEN/ERM-TG37-008

REN/ERM-TG31A-0113-2

REN/ERM-TGSRR-061-2

DEN/ERM-TGSRR-001-2

REN/BRAN-60008

DEN/BRAN-60010

The present document specifies technical characteristics and methods of measurements for Point-to-point (P-P) Digital
Fixed Radio Systems (DFRS) operating in frequency bands allocated to Fixed Service (FS) from 1 GHz to 86 GHz,
corresponding to the appropriate frequency bands from 1,4 GHz to 86 GHz as described in annex B to annex J.
Systems in the scope of the present document are generally intended to operate in full frequency division duplex (FDD)
and covers also unidirectional applications. Time division duplex (TDD) applications, when possibly applicable in a
specific band, are explicitly mentioned as appropriate in annex B through annex J.
The present document covers the essential requirements of article 3.2 of Directive 2014/53/EU [i.1] under the
conditions identified in annex A.

REN/MSG-TFES-11-13-RED

REN/MSG-GSM-1311Q7R1

REN/ATTM-04025

REN/SES-00391

DEN/ERM-TG17WG2-002-2

REN/TM-04170-2

DEN/ERM-TG17WG2-001-2

REN/ERM-TG17WG1-002-2

REN/MSG-TFES-11-02-RED

REN/ERM-TG17WG2-004-2

The present document specifies technical characteristics and methods of measurements for the following radio
equipment type:
- GSM mobile station.
This radio equipment type is for operation within the Digital cellular telecommunications system in the GSM 900
and/or GSM 1800 frequency bands as shown in table 1, with a channel separation of 200 kHz, utilizing constant
envelope modulation and carrying traffic channels according to the Time Division Multiple Access (TDMA) principle.
The present document covers the essential requirements of article 3.2 of Directive 2014/53/EU [i.9] under the
conditions identified in annex A.
The present document covers the general access requirements for terminal equipment up to and including 3GPP Rel-12.
The general access requirements, applied to the terminal equipment, are for one release only. The present document
does not cover the GPRS Class A mobiles and the ECSD mobiles.
For each test purpose and its corresponding conformance requirement, a reference is given to the test method in
ETSI TS 151 010-1 [2]. The requirements apply at the air interface, which may be stimulated to perform the tests by
additional equipment if necessary.
The measurement uncertainty is described in ETSI TS 151 010-1 [2], annex 5.
In addition to the present document, other ENs that specify technical requirements in respect of essential requirements
under other parts of article 3 of the Radio Equipment Directive [i.9] will apply to equipment within the scope of the
present document.
NOTE 1: A list of such ENs is included on the web site http://www.newapproach.org.
ETSI TS 151 010-1 [2] constitutes the conformance test suite for GSM. The verification of the conformance
requirements in the present document is based on the tests described in this reference. The set of requirements in
ETSI TS 151 010-1 [2] and the set of requirements in the present document need not be identical.
Some requirements only apply to specific types of mobile station (e.g. data tests only apply to mobile stations with a
data facility, tests that only apply to GSM 900 or only to GSM 1800 or to both). The present document indicates the
specific test which should be carried out for each mobile station type.
An active accessory is covered by the present document if it modifies the terminal performance in an aspect which
affects conformance to essential requirements.
NOTE 2: Only active devices are subject to the present document. Accessories may be tested with specific
terminals, and either approved for use with those terminals only, or may possibly be approved for use
with a wider range of terminals, depending on the nature and effect of the accessory.

The present document specifies technical characteristics and methods of measurements for the following types of
equipment:
• radar equipment for obstacle detection applications in the frequency range from 76 GHz to 77 GHz at the road
crossing of a railway track and references CEPT/ECC ERC Recommendation 70-03 [i.1] Annex 4;
• Short Range Devices (SRD) intended for the use at road crossing of a railway track.
It covers integrated transceivers and separate transmit/receive modules.
The present document does not necessarily include all the characteristics which may be required by a user, nor does it
necessarily represent the optimum performance achievable.
In case of differences (for instance concerning special conditions, definitions, abbreviations) between the present
document and ETSI EN 303 396 [1], the provisions of the present document take precedence.

The present document specifies technical characteristics and methods of measurement for radio transmitters and
receivers operating in the frequency range 5 855 MHz to 5 925 MHz. The spectrum usage conditions are set out in
ECC Decision (08)01 [i.1] for the frequency range 5 875 MHz to 5 925 MHz (with 5 905 MHz to 5 925 MHz
considered as a future ITS extension) and in ECC Recommendation (08)01 [i.2] for the frequency range 5 855 MHz
to 5 875 MHz. The Commission Decision 2008/671/EC [i.3] mandates a harmonised use of the frequency band
5 875 MHz to 5 905 MHz dedicated to safety-related applications of ITS throughout the member states of the European
Union. Table 1 outlines the 5 GHz ITS frequency band segmentation.