SIST EN 302 617-2 V2.1.1:2016
(Main)The present document applies to ground based transmitters, receivers and transceivers. These radio equipment types are
capable of operating in all or any part of the aeronautical frequency band between 225 MHz and 399,975 MHz.
The present document contains requirements to demonstrate that "... Radio equipment shall be so constructed that it
both effectively uses and supports the efficient use of radio spectrum in order to avoid harmful interference" [i.2].
In addition to the present document, other ENs that specify technical requirements in respect of essential requirements
under other parts of article 3 of the Directive 2014/53/EU [i.2] as well as essential requirements under the Single
European Sky Interoperability Regulation (as amended) [i.3] and related implementing rules and/or essential
requirements under the EASA basic regulation 216/2008 [i.5] may apply to equipment within the scope of the present
document.
Talni UHF radijski oddajniki, sprejemniki in sprejemniki-oddajniki za UHF aeronavtično mobilno storitev, ki uporablja amplitudno modulacijo - 2. del: Harmonizirani standard, ki zajema bistvene zahteve člena 3.2 direktive 2014/53/EU
Ta dokument velja za talne oddajnike, sprejemnike in sprejemnike-oddajnike. Ti tipi radijske opreme lahko delujejo v vseh aeronavtičnih frekvenčnih pasovih med 225 MHz in 399,975 MHz. Ta dokument zajema zahteve za dokaz, da »... je radijska oprema sestavljena tako, da učinkovito uporablja in tudi podpira učinkovito uporabo radijskega spektra, tako da ne pride do škodljivega motenja« [i.2].
Poleg tega dokumenta se za opremo na področju uporabe tega dokumenta uporabljajo tudi drugi standardi EN, ki določajo tehnične zahteve v zvezi z bistvenimi zahtevami iz drugih delov člena 3 Direktive 2014/53/EU [i.2], ter tudi bistvene zahteve iz spremenjene Uredbe o interoperabilnosti enotnega evropskega neba [i.3] in zadevna izvedbena pravila in/ali bistvene zahteve iz Uredbe EASA 216/2008 [i.5].
General Information
Standards Content (sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Ground-based UHF radio transmitters, receivers and transceivers for the UHF aeronautical mobile service using amplitude modulation - Part 2: Harmonised Standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU49.090On-board equipment and instruments33.060.20Sprejemna in oddajna opremaReceiving and transmitting equipmentICS:Ta slovenski standard je istoveten z:EN 302 617-2 V2.1.1SIST EN 302 617-2 V2.1.1:2016en01-marec-2016SIST EN 302 617-2 V2.1.1:2016SLOVENSKI
STANDARDSIST EN 302 617-2 V2.1.1:2016
ETSI EN 302 617-2 V2.1.1 (2015-12) Ground-based UHF radio transmitters, receivers and transceivers for the UHF aeronautical mobile service using amplitude modulation; Part 2: Harmonised Standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU
HARMONISED EUROPEAN STANDARD SIST EN 302 617-2 V2.1.1:2016ETSI ETSI EN 302 617-2 V2.1.1 (2015-12) 2
Reference REN/ERM-JTFEA-18 Keywords aeronautical, AM, DSB, radio, testing, UHF ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice The present document can be downloaded from: http://www.etsi.org/standards-search The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: https://portal.etsi.org/People/CommiteeSupportStaff.aspx Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2015. All rights reserved.DECTTM, PLUGTESTSTM, UMTSTM and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association. SIST EN 302 617-2 V2.1.1:2016
ETSI ETSI EN 302 617-2 V2.1.1 (2015-12) 3 Contents Intellectual Property Rights ................................................................................................................................ 5 Foreword ............................................................................................................................................................. 5 Modal verbs terminology .................................................................................................................................... 5 Executive summary ............................................................................................................................................ 6 1 Scope ........................................................................................................................................................ 7 2 References ................................................................................................................................................ 7 2.1 Normative references ......................................................................................................................................... 7 2.2 Informative references ........................................................................................................................................ 7 3 Definitions and abbreviations ................................................................................................................... 8 3.1 Definitions .......................................................................................................................................................... 8 3.2 Abbreviations ..................................................................................................................................................... 8 4 Technical requirements specifications ..................................................................................................... 8 4.1 Environmental profile ......................................................................................................................................... 8 4.2 Conformance requirements ................................................................................................................................ 9 4.2.1 Transmitter requirements .............................................................................................................................. 9 4.2.1.0 Applicability............................................................................................................................................ 9 4.2.1.1 Frequency error ....................................................................................................................................... 9 4.2.1.2 Carrier power (conducted) ...................................................................................................................... 9 4.2.1.3 Adjacent channel power .......................................................................................................................... 9 4.2.1.4 Conducted spurious emissions ................................................................................................................ 9 4.2.1.5 Intermodulation attenuation .................................................................................................................... 9 4.2.1.6 Keying transient frequency behaviour .................................................................................................... 9 4.2.1.7 Cabinet Radiation .................................................................................................................................... 9 4.2.2 Receiver requirements ................................................................................................................................ 10 4.2.2.1 General .................................................................................................................................................. 10 4.2.2.2 Sensitivity ............................................................................................................................................. 10 4.2.2.3 Adjacent channel rejection .................................................................................................................... 10 4.2.2.4 Spurious response rejection ................................................................................................................... 10 4.2.2.5 Intermodulation response rejection ....................................................................................................... 10 4.2.2.6 Blocking or desensitization ................................................................................................................... 10 4.2.2.7 Conducted spurious emissions .............................................................................................................. 10 4.2.2.8 Cross modulation rejection ................................................................................................................... 10 4.2.2.9 Cabinet radiation ................................................................................................................................... 10 5 Testing for compliance with technical requirements .............................................................................. 11 5.1 Environmental conditions for testing ............................................................................................................... 11 5.2 Interpretation of the measurement results ........................................................................................................ 11 5.3 Radio test suites ................................................................................................................................................ 12 5.3.1 Transmitter test specifications .................................................................................................................... 12 5.3.1.1 Frequency error ..................................................................................................................................... 12 5.3.1.2 Carrier power (conducted) .................................................................................................................... 12 5.3.1.3 Adjacent channel power ........................................................................................................................ 12 5.3.1.4 Conducted spurious emissions .............................................................................................................. 12 5.3.1.5 Intermodulation attenuation .................................................................................................................. 12 5.3.1.6 Keying transient frequency behaviour .................................................................................................. 12 5.3.1.7 Cabinet Radiation .................................................................................................................................. 12 5.3.2 Receiver test specifications ......................................................................................................................... 12 5.3.2.1 Sensitivity ............................................................................................................................................. 12 5.3.2.2 Adjacent channel rejection .................................................................................................................... 13 5.3.2.3 Spurious response rejection ................................................................................................................... 13 5.3.2.4 Intermodulation response rejection ....................................................................................................... 13 5.3.2.5 Blocking or desensitization ................................................................................................................... 13 5.3.2.6 Conducted spurious emissions .............................................................................................................. 13 5.3.2.7 Cross modulation rejection ................................................................................................................... 13 5.3.2.8 Cabinet Radiation .................................................................................................................................. 13 SIST EN 302 617-2 V2.1.1:2016
ETSI ETSI EN 302 617-2 V2.1.1 (2015-12) 4 Annex A (normative): Relationship between the present document and the essential requirements of Directive 2014/53/EU ......................................................... 14 History .............................................................................................................................................................. 16
SIST EN 302 617-2 V2.1.1:2016ETSI ETSI EN 302 617-2 V2.1.1 (2015-12) 5 Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http://ipr.etsi.org). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Harmonised European Standard (EN) has been produced by ETSI Technical Committee Electromagnetic compatibility and Radio spectrum Matters (ERM). The present document has been prepared in reply to the Commission's standardisation request Commission Implementing Decision C(2015) 5376 final of 04.08.2015 to provide a means of conforming to the essential requirements of Directive 2014/53/EU on the harmonisation of the laws of the Member States relating to the making available on the market of radio equipment. Once the present document is cited in the Official Journal of the European Union under that Directive, compliance with the normative clauses of the present document given in table A.1 confers, within the limits of the scope of the present document, a presumption of conformity with the corresponding essential requirements of that Directive, and associated EFTA regulations.
The present document is part 2 of a multi-part deliverable covering Ground-based UHF radio transmitters, receivers and transceivers for the UHF aeronautical mobile service using amplitude modulation, as identified below: Part 1: "Technical characteristics and methods of measurement"; Part 2: "Harmonised Standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU".
National transposition dates Date of adoption of this EN: 3 December 2015 Date of latest announcement of this EN (doa): 31 March 2016 Date of latest publication of new National Standard or endorsement of this EN (dop/e):
30 September 2016 Date of withdrawal of any conflicting National Standard (dow): 30 September 2017
Modal verbs terminology In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and "cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of provisions). "must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation. SIST EN 302 617-2 V2.1.1:2016
ETSI ETSI EN 302 617-2 V2.1.1 (2015-12) 6 Executive summary The present document covers the essential requirements for efficient use of radio spectrum by DSB AM ground base stations, with channel separations of 25 kHz intended for analogue speech. The present document includes necessary changes due to adaption to the new Radio Equipment Directive. SIST EN 302 617-2 V2.1.1:2016
ETSI ETSI EN 302 617-2 V2.1.1 (2015-12) 7 1 Scope The present document applies to ground based transmitters, receivers and transceivers. These radio equipment types are capable of operating in all or any part of the aeronautical frequency band between 225 MHz and 399,975 MHz. The present document contains requirements to demonstrate that "... Radio equipment shall be so constructed that it both effectively uses and supports the efficient use of radio spectrum in order to avoid harmful interference" [i.2]. In addition to the present document, other ENs that specify technical requirements in respect of essential requirements under other parts of article 3 of the Directive 2014/53/EU [i.2] as well as essential requirements under the Single European Sky Interoperability Regulation (as amended) [i.3] and related implementing rules and/or essential requirements under the EASA basic regulation 216/2008 [i.5] may apply to equipment within the scope of the present document. 2 References 2.1 Normative references References are either specific (identified by date of publication and/or edition number or version number) or non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the referenced document (including any amendments) applies. Referenced documents which are not found to be publicly available in the expected location might be found at http://docbox.etsi.org/Reference. NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee their long term validity. The following referenced documents are necessary for the application of the present document. [1] ETSI EN 302 617-1 (V1.1.1) (01-2009): "Electromagnetic compatibility and Radio spectrum Matters (ERM); Ground-based UHF radio transmitters, receivers and transceivers for the UHF aeronautical mobile service using amplitude modul
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.