SIST EN 300 086-2 V1.2.1:2008

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Electromagnetic compatibility and Radio spectrum Matters (ERM) - Land Mobile Service - Radio equipment with an internal or external RF connector intended primarily for analogue speech - Part 2: Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive33.100.01Elektromagnetna združljivost na splošnoElectromagnetic compatibility in general33.070.01Mobilni servisi na splošnoMobile services in general33.060.20Sprejemna in oddajna opremaReceiving and transmitting equipmentICS:Ta slovenski standard je istoveten z:EN 300 086-2 Version 1.2.1SIST EN 300 086-2 V1.2.1:2008en01-december-2008SIST EN 300 086-2 V1.2.1:2008SLOVENSKI

ETSI EN 300 086-2 V1.2.1 (2008-09)Harmonized European Standard (Telecommunications series) Electromagnetic compatibilityand Radio spectrum Matters (ERM);Land Mobile Service;Radio equipment with an internal or external RFconnector intended primarily for analogue speech;Part 2: Harmonized EN covering essential requirementsunder article 3.2 of the R&TTE Directive

Reference REN/ERM-TGDMR-258-2 Keywords analogue, antenna, mobile, PMR, radio, regulation, speech ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE

Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88

Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http://portal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media.

DECTTM, PLUGTESTSTM, UMTSTM, TIPHONTM, the TIPHON logo and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. SIST EN 300 086-2 V1.2.1:2008

Contents Intellectual Property Rights................................................................................................................................5 Foreword.............................................................................................................................................................5 Introduction........................................................................................................................................................5 1 Scope........................................................................................................................................................6 2 References................................................................................................................................................6 2.1 Normative references.........................................................................................................................................7 2.2 Informative references........................................................................................................................................7 3 Definitions, symbols and abbreviations...................................................................................................7 3.1 Definitions..........................................................................................................................................................7 3.2 Symbols..............................................................................................................................................................7 3.3 Abbreviations.....................................................................................................................................................7 4 Technical requirements specifications.....................................................................................................8 4.1 Environmental profile.........................................................................................................................................8 4.2 Transmitter requirements...................................................................................................................................8 4.2.1 Frequency error.............................................................................................................................................8 4.2.1.1 Definition................................................................................................................................................8 4.2.1.2 Limit........................................................................................................................................................8 4.2.1.3 Conformance...........................................................................................................................................8 4.2.2 Transmitter power (conducted).....................................................................................................................8 4.2.2.1 Definition................................................................................................................................................8 4.2.2.2 Limit........................................................................................................................................................8 4.2.2.3 Conformance...........................................................................................................................................8 4.2.3 Maximum effective radiated power..............................................................................................................8 4.2.3.1 Definition................................................................................................................................................8 4.2.3.2 Limit........................................................................................................................................................8 4.2.3.3 Conformance...........................................................................................................................................8 4.2.4 Adjacent and alternate channel power..........................................................................................................9 4.2.4.1 Definition................................................................................................................................................9 4.2.4.2 Limit........................................................................................................................................................9 4.2.4.3 Conformance...........................................................................................................................................9 4.2.5 Unwanted emissions in the spurious domain................................................................................................9 4.2.5.1 Definition................................................................................................................................................9 4.2.5.2 Limit........................................................................................................................................................9 4.2.5.3 Conformance...........................................................................................................................................9 4.2.6 Intermodulation attenuation..........................................................................................................................9 4.2.6.1 Definition................................................................................................................................................9 4.2.6.2 Limit........................................................................................................................................................9 4.2.6.3 Conformance...........................................................................................................................................9 4.3 Receiver requirements........................................................................................................................................9 4.3.1 Maximum usable receiver sensitivity...........................................................................................................9 4.3.1.1 Definition................................................................................................................................................9 4.3.1.2 Limit......................................................................................................................................................10 4.3.1.3 Conformance.........................................................................................................................................10 4.3.2 Co-channel rejection...................................................................................................................................10 4.3.2.1 Definition..............................................................................................................................................10 4.3.2.2 Limit......................................................................................................................................................10 4.3.2.3 Conformance.........................................................................................................................................10 4.3.3 Adjacent channel selectivity.......................................................................................................................10 4.3.3.1 Definition..............................................................................................................................................10 4.3.3.2 Limit......................................................................................................................................................10 4.3.3.3 Conformance.........................................................................................................................................10 4.3.4 Spurious response rejection........................................................................................................................10 4.3.4.1 Definition..............................................................................................................................................10 4.3.4.2 Limit......................................................................................................................................................10 SIST EN 300 086-2 V1.2.1:2008

4.3.4.3 Conformance.........................................................................................................................................11 4.3.5 Intermodulation response rejection.............................................................................................................11 4.3.5.1 Definition..............................................................................................................................................11 4.3.5.2 Limit......................................................................................................................................................11 4.3.5.3 Conformance.........................................................................................................................................11 4.3.6 Blocking or desensitization.........................................................................................................................11 4.3.6.1 Definition..............................................................................................................................................11 4.3.6.2 Limit......................................................................................................................................................11 4.3.6.3 Conformance.........................................................................................................................................11 4.3.7 Spurious radiations.....................................................................................................................................11 4.3.7.1 Definition..............................................................................................................................................11 4.3.7.2 Limit......................................................................................................................................................11 4.3.7.3 Conformance.........................................................................................................................................11 5 Testing for compliance with technical requirements..............................................................................12 5.1 Environmental conditions for testing...............................................................................................................12 5.1.1 Normal and extreme test-conditions...........................................................................................................12 5.1.2 Test power source.......................................................................................................................................12 5.1.3 Choice of samples for test suites.................................................................................................................12 5.2 Interpretation of the measurement results........................................................................................................12 5.3 Essential radio test suites..................................................................................................................................12 5.3.1 Frequency error...........................................................................................................................................13 5.3.2 Transmitter power (conducted)...................................................................................................................13 5.3.3 Maximum effective radiated power............................................................................................................13 5.3.4 Adjacent and alternate channel power........................................................................................................13 5.3.5 Unwanted emissions in the spurious domain..............................................................................................13 5.3.6 Intermodulation attenuation........................................................................................................................13 5.3.7 Receiver Spurious radiations......................................................................................................................13 5.3.8 Maximum usable receiver sensitivity..........................................................................................................13 5.3.9 Co-channel rejection...................................................................................................................................13 5.3.10 Adjacent channel selectivity.......................................................................................................................13 5.3.11 Spurious response rejection........................................................................................................................13 5.3.12 Intermodulation response rejection.............................................................................................................13 5.3.13 Receiver blocking or desensitization..........................................................................................................14 Annex A (normative): HS Requirements and conformance Test specifications Table (HS-RTT)................................................................................................................15 Annex B (informative): The EN title in the official languages...........................................................17 History..............................................................................................................................................................18

Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http://webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Harmonized European Standard (Telecommunications series) has been produced by ETSI Technical Committee Electromagnetic compatibility and Radio spectrum Matters (ERM). The present document has been produced by ETSI in response to a mandate from the European Commission issued under Council Directive 98/34/EC (as amended) [i.2] laying down a procedure for the provision of information in the field of technical standards and regulations. The present document is intended to become a Harmonized Standard, the reference of which will be published in the Official Journal of the European Communities referencing the Directive 1999/5/EC [i.1] of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity ("the R&TTE Directive"). Technical specifications relevant to Directive 1999/5/EC [i.1] are given in annex A. The present document is part 2 of a multi-part deliverable covering the Land Mobile Service; Radio equipment with an internal or external RF connector intended primarily for analogue speech, as identified below: Part 1: "Technical characteristics and methods of measurement"; Part 2: "Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive".

National transposition dates Date of adoption of this EN: 23 September 2008 Date of latest announcement of this EN (doa): 31 December 2008 Date of latest publication of new National Standard or endorsement of this EN (dop/e):

30 June 2009 Date of withdrawal of any conflicting National Standard (dow): 30 June 2010

Introduction The present document is part of a set of standards developed by ETSI and is designed to fit in a modular structure to cover all radio and telecommunications terminal equipment within the scope of the R&TTE Directive. The modular structure is shown in EG 201 399 [i.3]. SIST EN 300 086-2 V1.2.1:2008

1 Scope The present document covers the technical requirements for radio transmitters and receivers used in stations in the Private Mobile Radio (PMR) service. It applies to use in the land mobile service, operating on radio frequencies between 30 MHz and 1 GHz, with channel separations of 12,5 kHz, 20 kHz and 25 kHz, primarily intended for analogue speech. Table 1: Radiocommunications service frequency bands

Radiocommunications service frequency bands Transmit 30 MHz to 1 000 MHz Receive 30 MHz to 1 000 MHz

The equipment comprises a transmitter and associated modulator and/or a receiver and associated demodulator. The types of equipment covered by the present document are as follows: • base station (equipment fitted with an antenna connector, intended for use in a fixed location); • mobile station (equipment fitted with an ant