ETSI ETS 300 019-1-0 ed.1 (1994-05)

SLOVENSKI STANDARD
SIST ETS 300 019-1-0:2006
01-februar-2006
Inženiring opreme (EE) – Okoljski pogoji in preskusi vplivov okolja za
telekomunikacijsko opremo – 1-0. del: Klasifikacija okoljskih pogojev – Uvod
Equipment Engineering (EE); Environmental conditions and environmental tests for

telecommunications equipment; Part 1-0: Classification of environmental conditions;

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the

Whilst every care has been taken in the preparation and publication of this document, errors in content,

typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to

"ETSI Editing and Committee Support Dept." at the address shown on the title page.

Foreword .......................................................................................................................................................5

1 Scope ..................................................................................................................................................7

2 Normative references..........................................................................................................................7

3 Definitions............................................................................................................................................7

3.1 Storage ................................................................................................................................7

3.2 Transportation......................................................................................................................7

3.3 In-use...................................................................................................................................7

3.3.1 Stationary use..................................................................................................7

3.3.2 Mobile use (including portable) .......................................................................7

3.3.3 Portable and non-stationary use......................................................................7

3.4 Environmental condition.......................................................................................................8

3.5 Environmental factor............................................................................................................8

3.6 Environmental parameter ....................................................................................................8

3.7 Severity of environmental parameter...................................................................................8

3.8 Environmental class.............................................................................................................8

4 Environmental classes ........................................................................................................................8

4.1 Purpose of classification ......................................................................................................8

4.2 Environmental classes covered in Part 1.............................................................................9

5 Explanation of climatograms.............................................................................................................10

6 Environmental contents of equipment documentation ......................................................................11

6.1 Environmental considerations to be included in the design process for producing

equipment ..........................................................................................................................11

6.2 Environmental contents of a product specification ............................................................11

6.3 Contents of an environmental test programme .................................................................11

History..........................................................................................................................................................12

This multi-part European Telecommunication Standard (ETS) has been produced by the Equipment

Engineering (EE) Technical Committee of the European Telecommunications Standards Institute (ETSI).

ETS 300 019 is concerned with environmental conditions and environmental tests for telecommunications

Part 1 specifies different standardised environmental classes covering climatic and biological

conditions, chemically and mechanically active substances and mechanical conditions during

Part 2 specifies the recommended test severities and test methods for the different environmental

Part 2-0 forms a general overview of Part 2. This part (Part 1-0), forms a general overview of Part 1.

An associated ETSI Technical Report (ETR), ETR 035 [1], gives an introduction to the main concepts of

environmental engineering, the purpose and use of environmental classes and the corresponding test

This European Telecommunication Standard (ETS) defines the classes of environmental conditions and

their severities to which equipment may be exposed at specified locations. The severities specified are

those which will have a low probability of being exceeded - generally less than 1 %.

This ETS contains, by dated or undated reference, provisions from other publications. These normative

references are cited at the appropriate places in the text and the publications are listed hereafter. For

dated references, subsequent amendments to or revisions of any of these publications apply to this ETS

only when incorporated in it by amendment or revision. For undated references the latest edition of the

The equipment is placed at a certain site for a long period, but is not intended for use during this period. If

the equipment is packaged, the environmental conditions apply to the packaging protecting the

Transportation is the phase during which the equipment is moved from one place to another after being

made ready for dispatch. It includes loading, unloading and temporary storage. The equipment is not in-

An equipment is mounted firmly on the structure, or on mounting devices, or it is permanently placed at a