ISO 965-1:2013/PRF Amd 1

General Information

Status
Published
Technical Committee
Drafting Committee
Current Stage
Ref Project

RELATIONS

Buy Standard

Draft
ISO 965-1:2013/PRF Amd 1
English language
1 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (sample)

INTERNATIONAL ISO
STANDARD 965-1
Fourth edition
2013-09-15
AMENDMENT 1
ISO general purpose metric screw
threads — Tolerances —
Part 1:
Principles and basic data
AMENDMENT 1
Filetages métriques ISO pour usages généraux — Tolérances —
Partie 1: Principes et données fondamentales
AMENDEMENT 1
PROOF/ÉPREUVE
Reference number
ISO 965-1:2013/Amd.1:2021(E)
ISO 2021
---------------------- Page: 1 ----------------------
ISO 965-1:2013/Amd.1:2021(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2021

All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may

be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting

on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address

below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii PROOF/ÉPREUVE © ISO 2021 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 965-1:2013/Amd.1:2021(E)
Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards

bodies (ISO member bodies). The work of preparing International Standards is normally carried out

through ISO technical committees. Each member body interested in a subject for which a technical

committee has been established has the right to be represented on that committee. International

organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.

ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of

electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are

described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the

different types of ISO documents should be noted. This document was drafted in accordance with the

editorial rules of the ISO/IEC Directives, Part 2 (see www .iso .org/ directives).

Attention is drawn to the possibility that some of the elements of this docu
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.