ISO/DIS 2100-314

Aerospace elements of electrical and optical connection -- Test methods

Connections électriques et optiques d'éléments aérospatiaux -- Méthodes d'essai

Standards Content (sample)

DRAFT INTERNATIONAL STANDARD
ISO/DIS 2100-314
ISO/TC 20/SC 1 Secretariat: SAC
Voting begins on: Voting terminates on:
2017-07-31 2017-10-22
Aerospace elements of electrical and optical connection —
Test methods —
Part 314:
Immersion at low pressure
Connections électriques et optiques d’éléments aérospatiaux — Méthodes d’essai —
Partie 314: Immersion à basse pression d’air
ICS: 49.060
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENT AND APPROVAL. IT IS
THEREFORE SUBJECT TO CHANGE AND MAY
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
This document is circulated as received from the committee secretariat.
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO/DIS 2100-314:2017(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
PROVIDE SUPPORTING DOCUMENTATION. ISO 2017
---------------------- Page: 1 ----------------------
ISO/DIS 2100-314:2017(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland

All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form

or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior

written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of

the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved
---------------------- Page: 2 ----------------------
ISO/DIS 2100-314:2017(E)
Contents Page

Foreword ........................................................................................................................................................................................................................................iv

1 Scope ................................................................................................................................................................................................................................. 1

2 Normative references ...................................................................................................................................................................................... 1

3 Preparation of specimens ........................................................................................................................................................................... 1

4 Apparatus ..................................................................................................................................................................................................................... 2

4.1 Low air pressure chamber ............................................................................................................................................................ 2

4.2 Salt solution ............................................................................................................................................................................................... 2

5 Method ............................................................................................................................................................................................................................ 2

5.1 Initial measurements and requirements (if applicable) ..................................................................................... 2

5.2 Test procedure ......................................................................................................................................................................................... 2

5.2.1 Immersion ............................................................................................................................................................................. 2

5.2.2 Low air pressure cycle ................................................................................................................................................ 2

5.3 Final measurements and requirements ............................................................................................................................ 3

© ISO 2017 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO/DIS 2100-314:2017(E)
Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards

bodies (ISO member bodies). The work of preparing International Standards is normally carried out

through ISO technical committees. Each member body interested in a subject for which a technical

committee has been established has the right to be represented on that committee. International

organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.

ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of

electrotechnical standardization.
International Standard
...