ETSI TR 102 021-6 V1.2.1 (2011-08)

Terrestrial Trunked Radio (TETRA); User Requirement Specification TETRA Release 2.1; Part 6: Smart Card (SC) and Subscriber Identity Module (SIM)

RTR/TETRA-01195

General Information

• Status: Published
• Publication Date: 10-Aug-2011
• Technical Committee: TCCE 1 - TCCE User Requirements / Services
• Current Stage: 12 - Completion
• Due Date: 24-Aug-2011
• Completion Date: 11-Aug-2011

Standards Content (Sample)

Technical Report
Terrestrial Trunked Radio (TETRA);
User Requirement Specification TETRA Release 2.1;
Part 6: Smart Card (SC) and Subscriber Identity Module (SIM)

2 ETSI TR 102 021-6 V1.2.1 (2011-08)

Reference
RTR/TETRA-01195
Keywords
SC, SIM, Smart Card, TETRA, UR, user
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: [phone]  Fax: [phone]

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
Individual copies of the present document can be downloaded from:
http://www.etsi.org
The present document may be made available in more than one electronic version or in print. In any case of existing or
perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF).
In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive
within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
http://portal.etsi.org/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2011.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI
3 ETSI TR 102 021-6 V1.2.1 (2011-08)
Contents
Intellectual Property Rights . 4
Foreword . 4
Introduction . 4
1 Scope . 6
2 References . 6
2.1 Normative references . 6
2.2 Informative references . 6
3 Definitions and abbreviations . 7
3.1 Definitions . 7
3.2 Abbreviations . 7
4 User Requirement Specification . 8
4.1 Introduction . 8
4.2 Security functions . 10
4.2.1 Authentication . 10
4.2.2 End-to-End Encryption . 10
4.2.3 Operational-Tactical Address . 11
4.2.4 Enable and disable . 11
4.3 Personalisation functions . 11
4.3.1 Subscriber identity . 12
4.3.2 Parameters not depending on subscriber identity. 12
4.3.3 Parameters depending on subscriber identity . 12
4.4 Smart Card reference implementation . 13
History . 14

ETSI
4 ETSI TR 102 021-6 V1.2.1 (2011-08)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://ipr.etsi.org).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Technical Report (TR) has been produced by ETSI Technical Committee Terrestrial Trunked Radio (TETRA).
The present document is part 6 of a multi-part deliverable covering the User Requirement Specification for TETRA
Release 2 and Release 2.1, as identified below:
Part 1: "General overview" (Release 2.1);
Part 2: "High Speed Data" (Release 2.1);
Part 3: "Codec" (Release 2);
Part 4: "Air Interface Enhancements" (Release 2.1);
Part 5: "Interworking and Roaming" (Release 2.1);
Part 6: "Smart Card and Subscriber Identity Module" (Release 2.1);
Part 7: "Security" (Release 2.1);
Part 8: "Air - Ground - Air services" (Release 2);
Part 9: "Peripheral Equipment Interface" (Release 2.1);
Part 10: "Local Mode Broadband" (Release 2.1);
Part 11: "Over The Air Management" (Release 2.1);
Part 12: "Direct Mode Operation" (Release 2.1).
Introduction
The Terms of Reference for TC TETRA approved at ETSI Board meeting #69, November 2008 is to produce ETSI
deliverables (and maintenance thereafter) in accordance with the following requirements.
The Terms of Reference for TC TETRA are to produce ETSI deliverables (and maintenance thereafter) in accordance
with the following requirements:
a) The provision of user driven services, facilities and functionality as required by traditional Professional Mobile
Radio (PMR) user organisations such as the Emergency Services, Government, Military, Transportation,
Utility and Industrial organisations as well as Public Access Mobile Radio (PAMR) operators.
b) The evolution and enhancement of TETRA as required by the market with the provision of new services,
facilities and functionality made possible by new technology innovations and standards.
ETSI
5 ETSI TR 102 021-6 V1.2.1 (2011-08)
c) Further enhancements of the TETRA standard in order to provide increased benefits and optimisation in terms
of spectrum efficiency, network capacity, system performance, quality of service, security and other relevant
parameters.
d) The backward compatibility and integration of the new services, facilities and functionality with existing
TETRA standards in order to future-proof the existing and future investments of TETRA users.
Technical Objective:
TETRA is one of a number of digital wireless communication technologies standardised by ETSI.
ETSI TC TETRA produces standards and/or adapts existing standards for efficient digital PMR and PAMR voice and
data services, including broadband evolution. The approved programme for TETRA Release 2.1 covers work areas,
namely:
• high speed data;
• air interface enhancements;
• interworking and roaming;
• smart card and subscriber identity module;
• security;
• air-ground-air services;
• peripheral equipment interface enhancements;
• local mode broadband;
• over-the-air management;
• direct mode operation.
The User Requirement Specification for each of these work areas is covered by its own document.
The present document provides the User Requirement Specification for the TETRA Smart Card and Subscriber Identity
Module required by TC TETRA for TETRA Release 2.1.
ETSI
6 ETSI TR 102 021-6 V1.2.1 (2011-08)
1 Scope
The present document defines the user requirements for Smart Card (SC) and Subscriber Identity Module (SIM) and is
applicable to the specification of TETRA Release 2.1 equipment.
2 References
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
reference document (including any amendments) applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
http://docbox.etsi.org/Reference.
NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee
their long term validity.
2.1 Normative references
The following referenced documents are necessary for the application of the present document.
Not applicable.
2.2 Informative references
The following referenced documents are not necessary for the application of the present document but they assist the
user with regard to a particular subject area.
[i.1] ETSI ES 200 812-1: "Terrestrial Trunked Radio (TETRA); Subscriber Identity Module to Mobile
Equipment (TSIM-ME) interface; Part 1: Universal Integrated Circuit Card (UICC); Physical and
logical characteristics".
[i.2] ETSI TR 102 021-4: "Terrestrial Trunked Radio (TETRA); User Requirement Specification
TETRA Release 2.1; Part 4: Air Interface Enhancements".
[i.3] ETSI TR 102 021-7: "Terrestrial Trunked Radio (TETRA); User Requirement Specification
TETRA Release 2.1; Part 7: Security".
[i.4] ETSI TR 102 021-9: "Terrestrial Trunked Radio (TETRA); User Requirement Specification
TETRA Release 2.1; Part 9: Peripheral Equipment Interface".
[i.5] ETSI TR 102 021-11: "Terrestrial Trunked Radio (TETRA); User Requirement Specification
TETRA Release 2.1; Part 11: Over-The-Air Management".
[i.6] ETSI EN 300 392-7: "Terrestrial Trunked Radio (TETRA); Voice plus Data (V+D); Part 7:
Security".
[i.7] ETSI EN 300 392-12-22: "Terrestrial Trunked Radio (TETRA); Voice plus Data (V+D); Part 12:
Supplementary services stage 3; Sub-part 22: Dynamic Group Number Assignment (DGNA) ".
[i.8] ETSI TS 100 392-18-3: "Terrestrial Trunked Radio (TETRA); Voice plus Data (V+D) and Direct
Mode Operation (DMO); Part 18: Air interface optimized applications; Sub-part 3: Direct mode
Over The Air Management protocol (DOTAM)".
[i.9] ETSI ES 200 812-2: "Terrestrial Trunked Radio (TETRA); Subscriber Identity Module to Mobile
Equipment (TSIM-ME) interface; Part 2: Universal Integrated Circuit Card (UICC);
Characteristics of the TSIM application".
ETSI
7 ETSI TR 102 021-6 V1.2.1 (2011-08)
[i.10] TETRA MOU Association Security and Fraud Prevention Group Recommendation 02 and 07.
NOTE: Available at http://www.tetramou.com/members/page.
3 Definitions and abbreviations
3.1 Definitions
For the purposes of the present document, the following terms and definitions apply:
Cryptographic Module (CM): functional entity of a Smart Card (SC) which encapsulates the following security
functions:
1) cryptographic algorithms for authentication between Smart Card (SC) and Mobile Equipment (ME);
2) cryptographic algorithms for End-to-End Encryption of traffic data;
3) over-the-air key management functions for End-to-End Encryption cipher key material (OTAK);
4) tamper-proof data management of End-to-End Encryption cipher key material.
Cryptographic Smart Card (CSC): Smart Card (SC) incorporating a Cryptographic Module (CM)
Mobile Equipment (ME): physical part of a Mobile Station (MS) which is used to obtain TETRA services in V+D and
DMO and which interfaces to and is parameterized either by a Smart Card (SC) or Subscriber Identity Module (SIM)
Mobile Station (MS): physical entity consisting of two parts, Mobile Equipment (ME) and Smart Card (SC)
Operational-Tactical Address (OPTA): subscriber identity which provides additional information about a subscriber's
operational role or user organisation and which is not used for air interface addressing, e.g. for call setup
Personalized Smart Card (PSC): Smart Card (SC) incorporating a Cryptographic Module (CM) and a Subscriber
Identity Module (SIM)
Smart Card (SC): physical part of a Mobile Station (MS) incorporating a Cryptographic Module (CM) and an optional
Subscriber Identity Module (SIM)
Subscriber Identity Module (SIM): optional functional entity of a Smart Card (SC) which encapsulates the following
personalisation function: tamper-proof data management of user data
TETRA Release 2: Work Programme with new terms of reference within ETSI Project TETRA to enhance the services
and facilities of TETRA in order to meet new user requirements, utilize new technology and increase the longevity of
TETRA within the traditional market domains of PMR and PAMR
TETRA Release 2.1: Work Programme within TC TETRA to enhance the services and facilities of TETRA in order to
meet new user requirements, utilise new technology and increase the longevity of TETRA within the traditional market
domains of PMR and PAMR
3.2 Abbreviations
For the purposes of the present document, the following abbreviations apply:
API Application Programming Interface
APN Access Point Name
CM Cryptographic Module
CSC Cryptographic Smart Card
DGNA Dynamic Group Number Assignment
DM-MS Direct Mode – Mobile Station
DMO Direct Mode Operation
DOTAM Direct Mode Over-The-Air Management
E2EE End-to-End Encryption
ETSI
8 ETSI TR 102 021-6 V1.2.1 (2011-08)
ETSI European Telecommunications Standards Institute
GSM Global System for Mobile Communications
ITSI Individual TETRA Subscriber Identity
K Authentication Key
LTE Long Term Evolution
ME Mobile Equipment
MMI Man-Machine Interface
MNI Mobile Network Iden
...