ETSI EN 300 392-2 V2.4.2 (2004-02)

Terrestrial Trunked Radio (TETRA); Voice plus Data (V+D); Part 2: Air Interface (AI)

REN/TETRA-03097

Prizemni snopovni radio (TETRA) – Govor in podatki (V+D) – 2. del: Radijski vmesnik (AI)

General Information

• Status: Published
• Publication Date: 25-Feb-2004
• Technical Committee: TCCE 3 - TCCE Air Interface and Network Protocols
• Current Stage: 12 - Completion
• Due Date: 05-Mar-2004
• Completion Date: 26-Feb-2004
• Ref Project: SIST EN 300 392-2 V2.4.2:2006 - Terrestrial Trunked Radio (TETRA); Voice plus Data (V+D); Part 2: Air Interface (AI)

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 300 392-2 V2.4.2:2006
01-april-2006
Prizemni snopovni radio (TETRA) – Govor in podatki (V+D) – 2. del: Radijski
vmesnik (AI)
Terrestrial Trunked Radio (TETRA); Voice plus Data (V+D); Part 2: Air Interface (AI)
Ta slovenski standard je istoveten z: EN 300 392-2 Version 2.4.2
ICS:
33.070.10 Prizemni snopovni radio Terrestrial Trunked Radio
(TETRA) (TETRA)
SIST EN 300 392-2 V2.4.2:2006 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 300 392-2 V2.4.2:2006

---------------------- Page: 2 ----------------------

SIST EN 300 392-2 V2.4.2:2006

ETSI EN 300 392-2 V2.4.2 (2004-02)
European Standard (Telecommunications series)


Terrestrial Trunked Radio (TETRA);
Voice plus Data (V+D);
Part 2: Air Interface (AI)

---------------------- Page: 3 ----------------------

SIST EN 300 392-2 V2.4.2:2006
 2 ETSI EN 300 392-2 V2.4.2 (2004-02)



Reference
REN/TETRA-03097
Keywords
radio, TETRA, V+D
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: [phone]  Fax: [phone]

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
Individual copies of the present document can be downloaded from:
http://www.etsi.org
The present document may be made available in more than one electronic version or in print. In any case of existing or
perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF).
In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive
within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, send your comment to:
[e-mail]
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2004.
All rights reserved.

TM TM TM
DECT , PLUGTESTS and UMTS are Trade Marks of ETSI registered for the benefit of its Members.
TM
TIPHON and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members.
TM
3GPP is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners.
ETSI

---------------------- Page: 4 ----------------------

SIST EN 300 392-2 V2.4.2:2006
 3 ETSI EN 300 392-2 V2.4.2 (2004-02)
Contents
Intellectual Property Rights.29
Foreword.29
1 Scope.31
2 References.32
3 Definitions and abbreviations.34
3.1 Definitions.34
3.2 Abbreviations.39
4 Radio aspects.42
4.1 Introduction.42
4.2 Set of logical channels.42
4.3 Reference configuration.42
4.4 Error control schemes.43
4.5 Multiple access and time slot structure.43
4.5.1 Hyperframes, multiframes and frames.44
4.5.2 Time slots and bursts .44
4.5.3 Mapping of logical channels onto physical channels.45
4.6 Coding, interleaving and scrambling.45
4.7 Modulation.45
4.8 Transmission and reception.45
4.9 Other radio-related functions.45
4.10 Performance.46
4.11 TETRA modes of operation .46
4.11.1 Transmission modes.46
4.11.1.1 D-CT mode.46
4.11.1.2 D-CTT mode.46
4.11.1.3 D-MCCTT mode.46
4.11.1.4 U-MST mode.46
4.11.2 Control modes.47
4.11.2.1 NCM.47
4.11.2.2 MC mode.47
5 Modulation.47
5.1 Introduction.47
5.2 Modulation type.47
5.3 Modulation rate.47
5.4 Modulation symbol definition .47
5.5 Modulated signal definition.48
5.6 Modulation filter definition .49
5.7 Modulation block diagram .49
6 Radio transmission and reception.49
6.1 Introduction.49
6.2 Frequency bands and channel arrangement.49
6.3 Reference test planes .50
6.4 Transmitter characteristics.50
6.4.1 Output power.50
6.4.1.1 Base Station (BS) .51
6.4.1.2 Mobile Station (MS) .51
6.4.2 Unwanted conducted emissions.51
6.4.2.1 Definitions.51
6.4.2.2 Unwanted emissions close to the carrier .52
6.4.2.2.1 Emission during the useful part of the burst.52
6.4.2.2.2 Emission during the switching transients .53
6.4.2.3 Unwanted emissions far from the carrier .53
6.4.2.4 Unwanted emissions during the CLCH and BLCH .54
ETSI

---------------------- Page: 5 ----------------------

SIST EN 300 392-2 V2.4.2:2006
 4 ETSI EN 300 392-2 V2.4.2 (2004-02)
6.4.2.5 Unwanted emissions in the non-transmit state .54
6.4.3 Unwanted radiated emissions .54
6.4.4 RF tolerance.54
6.4.5 RF Output power time mask.54
6.4.5.1 BS.55
6.4.5.2 MS.55
6.4.6 Transmitter intermodulation attenuation.55
6.4.6.1 Definition.55
6.4.6.2 BS.56
6.4.6.3 MS.56
6.4.7 Intra-BS intermodulation requirements .56
6.5 Receiver characteristics.56
6.5.1 Blocking characteristics.56
6.5.1.1 Definition.56
6.5.1.2 Specification.57
6.5.2 Spurious response rejection .57
6.5.2.1 Definition.57
6.5.2.2 Specification.57
6.5.3 Intermodulation response rejection.58
6.5.3.1 Definition.58
6.5.3.2 Specification.58
6.5.4 Unwanted conducted emissions.58
6.5.4.1 Definition.58
6.5.4.2 Specification.58
6.5.5 Unwanted radiated emissions .58
6.6 Transmitter/receiver performance.58
6.6.1 Modulation accuracy.59
6.6.1.1 Ideal case.59
6.6.1.2 Vector error magnitude requirement at symbol time .59
6.6.2 Receiver performance.60
6.6.2.1 Nominal error rates .60
6.6.2.2 Dynamic reference sensitivity performance.61
6.6.2.2.1 BS receiver performance .61
6.6.2.2.2 MS receiver performance .61
6.6.2.3 Receiver performance at reference interference ratios .62
6.6.2.3.1 BS receiver performance .62
6.6.2.3.2 MS receiver performance .63
6.6.2.4 Static reference sensitivity performance .63
6.6.2.4.1 BS receiver performance .63
6.6.2.4.2 MS receiver performance .64
6.6.2.5 MS receiver performance for synchronization burst acquisition.64
6.6.3 Propagation conditions.64
6.6.3.1 Propagation conditions - introduction .64
6.6.3.2 Tap-gain process types.65
6.6.3.3 Propagation models.65
7 Radio sub-system synchronization.66
7.1 Introduction.66
7.2 General description of synchronization system.66
7.3 Timebase counters.67
7.3.1 Timing counters.67
7.3.2 Values of the counters.67
7.4 Timing of transmitted signals.67
7.5 BS requirements for synchronization .68
7.6 MS requirements for synchronization .68
8 Channel coding and scrambling .68
8.1 Introduction.68
8.2 General.69
8.2.1 Interfaces in the error control structure.69
8.2.2 Notation.70
8.2.3 Definition of error control codes.70
ETSI

---------------------- Page: 6 ----------------------

SIST EN 300 392-2 V2.4.2:2006
 5 ETSI EN 300 392-2 V2.4.2 (2004-02)
8.2.3.1 16-state Rate-Compatible Punctured Convolutional (RCPC) codes .70
8.2.3.1.1 Encoding by the 16-state mother code of rate ¼ .70
8.2.3.1.2 Puncturing of the mother code.71
8.2.3.1.3 Puncturing scheme of the RCPC code of rate 2/3.71
8.2.3.1.4 Puncturing scheme of the RCPC code of rate 1/3.71
8.2.3.1.5 Puncturing scheme of the RCPC code of rate 292/432.71
8.2.3.1.6 Puncturing scheme of the RCPC code of rate 148/432.71
8.2.3.2 Shortened (30,14) Reed-Muller (RM) code .72
8.2.3.3 (K + 16, K ) block code .72
1 1
8.2.4 Definition of interleaving schemes .73
8.2.4.1 Block interleaving.73
8.2.4.2 Interleaving over N blocks .73
8.2.5 Definition of scrambling.73
8.2.5.1 Scrambling method.73
8.2.5.2 Scrambling sequence.73
8.3 Error control schemes.74
8.3.1 Access Assignment Channel (AACH).75
8.3.2 Broadcast Synchronization Channel (BSCH) .75
8.3.3 Traffic channels in circuit switched mode .76
8.3.3.1 Traffic CHannel, net rate = 4,8 kbit/s (TCH/4,8).76
8.3.3.2 Traffic CHannel, net rate = 2,4 kbit/s (TCH/2,4).77
8.3.3.3 Traffic CHannel, net rate = 7,2 kbit/s (TCH/7,2).77
8.3.3.4 Speech Traffic Channel, full slot (TCH/S).78
8.3.3.5 Speech Traffic Channel, half slot (TCH/S) .78
8.3.4 Signalling channels for signalling and packet mode data .78
8.3.4.1 Signalling CHannel for mapping onto Half-bursts on the Downlink (SCH/HD), Broadcast
Network CHannel (BNCH), and STealing CHannel (STCH).78
8.3.4.2 Signalling CHannel for mapping onto Half-bursts on the Uplink (SCH/HU).79
8.3.4.3 Signalling CHannel for mapping onto Full bursts (SCH/F).79
9 Channel multiplexing for V+D.80
9.1 Introduction.80
9.2 Logical channels.80
9.2.1 Logical channels hierarchy .80
9.2.2 Traffic channels.80
9.2.3 Control CHannels (CCH).80
9.2.3.1 General.80
9.2.3.2 BCCH.81
9.2.3.3 LCH.81
9.2.3.4 SCH.81
9.2.3.5 AACH.81
9.2.3.6 STCH.81
9.3 The physical resource.82
9.3.1 General.82
9.3.2 RF channels.82
9.3.3 Timeslots.83
9.3.4 TDMA frame.83
9.3.5 Timeslot numbering.83
9.3.6 Subslot.83
9.3.7 Multiframe.83
9.3.8 Hyperframe.83
9.3.9 Frame alignment.83
9.4 Physical channels.83
9.4.1 General.83
9.4.2 Types of physical channels .84
9.4.2.1 CP channel.84
9.4.2.2 TP channel.84
9.4.2.3 UP channel.84
9.4.3 Bursts.84
9.4.3.1 General.
...