ETSI TS 103 543 V1.1.1 (2018-02)

Mobile Standards Group (MSG); Pan-European eCall In-Vehicle Systems; Guidelines for IVS conformity assessment

DTS/MSG-001124

General Information

• Status: Published
• Publication Date: 31-Jan-2018
• Technical Committee: MSG - Mobile Standards Group
• Current Stage: 12 - Completion
• Due Date: 30-Jan-2018
• Completion Date: 01-Feb-2018

Standards Content (Sample)

ETSI TS 103 543 V1.1.1 (2018-02)






TECHNICAL SPECIFICATION
Mobile Standards Group (MSG);
Pan-European eCall In-Vehicle Systems;
Guidelines for IVS conformity assessment

---------------------- Page: 1 ----------------------
2 ETSI TS 103 543 V1.1.1 (2018-02)



Reference
DTS/MSG-001124
Keywords
assessment, conformity, ecall
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: [phone]  Fax: [phone]

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
The present document can be downloaded from:
http://www.etsi.org/standards-search
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
https://portal.etsi.org/TB/ETSIDeliverableStatus.aspx
If you find errors in the present document, please send your comment to one of the following services:
https://portal.etsi.org/People/CommiteeSupportStaff.aspx
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.

© ETSI 2018.
All rights reserved.

TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are trademarks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are trademarks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
oneM2M logo is protected for the benefit of its Members.
GSM® and the GSM logo are trademarks registered and owned by the GSM Association.
ETSI

---------------------- Page: 2 ----------------------
3 ETSI TS 103 543 V1.1.1 (2018-02)
Contents
Intellectual Property Rights . 4
Foreword . 4
Modal verbs terminology . 4
Introduction . 4
1 Scope . 5
2 References . 5
2.1 Normative references . 5
2.2 Informative references . 5
3 Definitions and abbreviations . 6
3.1 Definitions . 6
3.2 Abbreviations . 6
4 IVS conformance assessment . 7
4.0 General . 7
4.1 Prerequisites . 7
4.2 Commission Delegated Regulation (EU) 2017/79 . 7
4.2.1 Sled tests - (EU) 2017/79 Annex I . 7
4.2.2 Coexistence tests - Regulation (EU) 2017/79 Annex IV . 8
4.2.3 GNSS tests - Regulation (EU) 2017/79 Annex VI. 8
4.2.4 In-vehicle system self-test - Regulation (EU) 2017/79 Annex VII . 8
4.2.5 Privacy and data protection tests - Regulation (EU) 2017/79 Annex VIII. 8
4.3 Pan-European eCall end to end and in-band modem conformance testing . 9
4.3.1 Conformance tests for IVS eCall user equipment . 9
4.3.2 Conformance tests for IVS eCall user equipment - additional tests for eCall only systems . 10
4.3.3 Minimum Performance requirements for in-vehicle user equipment for Pan-European eCall . 10
4.4 eCall HLAP interoperability testing . 11
4.5 Additional restrictions and risks . 11
History . 12


ETSI

---------------------- Page: 3 ----------------------
4 ETSI TS 103 543 V1.1.1 (2018-02)
Intellectual Property Rights
Essential patents
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (https://ipr.etsi.org/).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Trademarks
The present document may include trademarks and/or tradenames which are asserted and/or registered by their owners.
ETSI claims no ownership of these except for any which are indicated as being the property of ETSI, and conveys no
right to use or reproduce any trademark and/or tradename. Mention of those trademarks in the present document does
not constitute an endorsement by ETSI of products, services or organizations associated with those trademarks.
Foreword
This Technical Specification (TS) has been produced by ETSI Technical Committee Mobile Standards Group (MSG).
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and
"cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of
provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
Introduction
Pan European eCall IVS devices are subject to vehicle type approval regulations. Mandatory test procedures are
required to fulfill the delegated acts of the European commission (EU) 2015/758 [i.1] and (EU) 2017/79 [i.5]. The type
approval procedures are seen as the minimum set of test points to ensure compliant behaviour of the embedded IVS and
ability to carry out eCall in the applicable user scenarios.
Nevertheless, additional test procedures to the delegated acts are necessary to check IVS device conformity relating to
different protocols involved in the eCall process chain. These are described in detail in the end-to-end conformance
testing specification ETSI TS 103 412 [i.3] and in the interoperability test specification ETSI TS 103 428 [i.4] and
would also be considered as an essential part of the preparation for the type approval homologation.
On the basis of these existing requirements and test procedures the present document compiles conformance relevant
tests as a guideline for a voluntary conformance declaration process for type approval. Therefore, the present document
refers to existing requirements and test cases indicated by number and cross-referenced to published documents.

ETSI

---------------------- Page: 4 ----------------------
5 ETSI TS 103 543 V1.1.1 (2018-02)
1 Scope
The scope of the present document is to provide technical guidelines for assessing device conformity to Pan-European
eCall (according to CEN EN 16072:2015 [i.2]) and essential performance (CEN EN 16072 [i.3], ETSI TS 103 428 [i.4]
and CEN EN 15722:2015 [i.6]). The present document compiles existing test cases / procedures and guides device
suppliers and integrators by differentiating between regulatory and functional test cases. The resulting compilation of
test procedures is a guideline towards regulatory conformance declaration mandated by the EU commission and IVS
full functional conformance self-declaration in regards to Pan-European eCall. This assessment is also seen as a suitable
preparation for the type approval homologation.
The main purpose of the present document is to:
a) Analyse existing regulations on Pan European eCall and provide a conformance relevant list of test cases
based on existing specifications.
b) Guide device supplier and integrators by evaluating test case relevance (regulatory and functional). This
provides an efficient method for indication of Pan-European eCall conformance.
c) Assist device suppliers and integrators in the vehicle type approval homologation.
2 References
2.1 Normative references
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
referenced document (including any amendments) applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
https://docbox.etsi.org/Reference/.
NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee
their long term validity.
Not applicable.
2.2 Informative references
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
referenced document (including any amendments) applies.
NOTE: While any hyperlinks included in this clause were valid at the time of publication ETSI cannot guarantee
their long-term validity.
The following referenced documents are not necessary for the application of the present document but they assist the
user with regard to a particular subject area.
[i.1] Regulation (EU) 2015/758 of the European Parliament and of the Council of 29 April 2015
concerning type-approval requirements for the deployment of the eCall in-vehicle system based on
the 112 service and amending Directive 2007/46/EC.
NOTE: Available at: http://eur-lex.europa.eu/legal-
content/EN/TXT/?uri=uriserv%3AOJ.L_.2015.123.01.0077.01.ENG.
ETSI

---------------------- Page: 5 ----------------------
6 ETSI TS 103 543 V1.1.1 (2018-02)
[i.2] CEN EN 16072:2015: "Intelligent transport systems - eSafety - Pan-European eCall operating
requirements".
NOTE: Available at:
https://standards.cen.eu/dyn/www/f?p=204:110:0::::FSP_PROJECT,FSP_ORG_ID:41797,6259&cs=198
06BB25539A82E8156B31E463B1D5B9.
[i.3] ETSI TS 103 412: "Mobile Standards Group (MSG); Pan-European eCall end to end and in-band
modem conformance testing; Prose test specification".
[i.4] ETSI TS 103 428: "Mobile Standards Group (MSG); eCall HLAP Interoperability Testing".
[i.5] Commission Delegated Regulation (EU) 2017/79 of 12 September 2016 establishing detailed
technical requirements and test procedures for the EC type-approval of motor vehicules with
respect to their 112 based eCall in-vehicules system, of 112-based eCall in-vehicule seperate
technical units and components and supplementing and amending Regulation (EU) 2015/758 of
the European Parliament and of the council with regard to the exemptions and applicable
standards.
NOTE: Available at: http://eur-lex.europa.eu/legal-
content/EN/TXT/?uri=uriserv%3AOJ.L_.2017.012.01.0044.01.ENG
[i.6] CEN EN 15722:2015: "Intelligent Transport Systems - ESafety - eCall minimum set of data".
NOTE: Available at
https://standards.cen.eu/dyn/www/f?p=204:110:0::::FSP_PROJECT,FSP_ORG_ID:41808,6259&cs=1F7
69328F59BFAA4FE011A984FF6A2CEB.
[i.7] CEN EN 16454:2015: "Intelligent Transport Systems - ESafety - eCall end to end conformance
testing".
NOTE: Available at
https://standards.cen.eu/dyn/www/f?p=204:110:0::::FSP_PROJECT,FSP_ORG_ID:39943,6259&cs=1E3
F2D6EF78EAA4A98748757E72557FB4.
[i.8] ETSI TS 102 936-1: "eCall Network Access Device (NAD) conformance specification; Part 1:
Protocol test specification".
[i.9] ETSI TS 102 936-2: "eCall Network Access Device (NAD) conformance specificati
...