ETSI ETS 300 242/A1 ed.1 (1994-09)

Terminal Equipment (TE); Group 3 facsimile equipment

RE/TE-02020

Terminalska oprema (TE) – Oprema za faksimilno skupino 3

General Information

• Status: Published
• Publication Date: 29-Sep-1994
• Technical Committee: TE 2 - Telematics: Facsimile, Document Handling and Transfer
• Current Stage: 12 - Completion
• Due Date: 12-Oct-1994
• Completion Date: 30-Sep-1994
• Ref Project: SIST ETS 300 242:2003/A1 E1:2003 - Terminal Equipment (TE); Group 3 facsimile equipment

Standards Content (Sample)

SLOVENSKI STANDARD
SIST ETS 300 242:2003/A1 E1:2003
01-december-2003
Terminalska oprema (TE) – Oprema za faksimilno skupino 3
Terminal Equipment (TE); Group 3 facsimile equipment
Ta slovenski standard je istoveten z: ETS 300 242/A1 Edition 1
ICS:
33.050.30 Oprema za teleks, teletekst, Equipment for telex, teletext,
telefaks telefax
35.180 Terminalska in druga IT Terminal and other
periferna oprema IT peripheral equipment
SIST ETS 300 242:2003/A1 E1:2003 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST ETS 300 242:2003/A1 E1:2003

---------------------- Page: 2 ----------------------

SIST ETS 300 242:2003/A1 E1:2003
ETS 300 242/A1
AMENDMENT
September 1994
Source: ETSI TC-TE Reference: RE/TE-02020
ICS: 33.020, 33.040.40
Key words: Facsimile, group 3, ECM mode
This amendment A1 modifies
the European Telecommunication Standard ETS 300 242 (1992)
Terminal Equipment (TE);
Group 3 facsimile equipment
ETSI
European Telecommunications Standards Institute
ETSI Secretariat
F-06921 Sophia Antipolis CEDEX - FRANCE
Postal address:
650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE
Office address:
c=fr, a=atlas, p=etsi, s=secretariat - [e-mail]
X.400: Internet:
Tel.: [phone] - Fax: [phone]
Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the
foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 1994. All rights reserved.
New presentation - see History box

---------------------- Page: 3 ----------------------

SIST ETS 300 242:2003/A1 E1:2003
Page 2
ETS 300 242: December 1992/A1: September 1994
Whilst every care has been taken in the preparation and publication of this document, errors in content,
typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to
"ETSI Editing and Committee Support Dept." at the address shown on the title page.

---------------------- Page: 4 ----------------------

SIST ETS 300 242:2003/A1 E1:2003
Page 3
ETS 300 242: December 1992/A1: September 1994
Foreword
This Amendment to ETS 300 242 (1992) has been produced by the Terminal Equipment (TE) Technical
Committee of the European Telecommunications Standards Institute (ETSI).
This Amendment to ETS 300 242 covers changes to tests in Annex B - Testing. The changes are to
include clarification regarding the possibility of combining tests for efficiency and also to include a new
Clause (B.7) covering the CCITT standardized Error Correction Mode (ECM).
ECM is an optional feature of a facsimile equipment. For equipment providing ECM, conformance to this
ETS will include tests defined in Clause B.7 (see below).
For equipment not providing ECM, conformance testing to this ETS does not include tests defined in
Clause B.7 (see below).
Amendments
The changes covering the combination of tests are as follows:
Page 14, subclause B.1.3 insert the following text at the start of the 4th paragraph.
"For efficiency in testing, a test sequence may combine any number of tests where the combination does
not affect its validity".
Page 15, subclause B.1.4.1 add the following sentence at the end of the text.
"However, for efficiency, tests may be combined".
Insert the following text as Clause B.7 to Annex B.
"B.7 Tests for CCITT Recommendation T.30 in ECM mode
B.7.1 Tests for normal conditions
B.7.1.1 Test No. TNO1 . TNO9
Testing normal conditions with ECM capability.
Facsimile equipment transmitting/tester receiving.
Facsimile equipment transmits two test charts: first a CCITT Test Chart No.3 followed by an all white page
not exceeding A4 length.
Before each sequence a call is established and the tester shall:
T-DIS V2;
R-DCS;
R-phasing/training, TCF;
T-CFR;
R-fax msg in ECM mode.
For facsimile equipment capable of transmitting only one page, tests TNO4, TNO5 and TNO6 shall not be
applied.
NOTE 1: Optional signals may appear before DCS.
NOTE 2: Tests TNO1-TNO3 may be repeated several times, depending on the number of bytes
per frame selected in the DCS frame.

---------------------- Page: 5 ----------------------

SIST ETS 300 242:2003/A1 E1:2003
Page 4
ETS 300 242: December 1992/A1: September 1994
Table B.24
Test No. Type of Test Tester Action Tester Detects Comments
TNO1 transmit R-PPS-NULL NOTE 2
PPS-NULL
TNO2 receive MCF T-MCF
TNO3 transmit R-fax msg
fax msg
TNO4 transmit R-PPS-MPS
PPS-MPS
TNO5 receive MCF T-MCF
TNO6 transmit R-fax msg
fax msg
TNO7 transmit R-PPS-EOP
PPS-EOP
TNO8 receive MCF T-MCF
TNO9 transmit DCN R-DCN
R-disconnect

---------------------- Page: 6 ----------------------

SIST ETS 300 242:2003/A1 E1:2003
Page 5
ETS 300 242: December 1992/A1: September 1994
B.7.1.2 Test No. RNO1 . RNO9
Testing normal conditions with ECM capability.
Facsimile equipment receiving/tester transmitting.
Facsimile equipment receives two pages not exceeding A4 length generated electronically by the Tester.
Before each sequence a call is established and the tester shall:
R-DIS;
T-DCS V2;
T-phasing/training, TCF;
R-CFR;
T-fax msg in ECM mode.
For facsimile equipment capable of receiving only one page, tests RNO4, RNO5 and RNO6 shall not be
applied.
NOTE 1: Optional signals may appear before DIS.
NOTE 2: After PPS-Q is sent by tester, it i
...