ETSI TS 102 933-1 V1.2.1 (2011-12)

Railway Telecommunications (RT); GSM-R improved receiver parameters; Part 1: Requirements for radio reception

RTS/RT-EGSM-R-003-1

General Information

• Status: Published
• Publication Date: 19-Dec-2011
• Technical Committee: RT EGSM-R - Extended-GSM-R
• Current Stage: 12 - Completion
• Due Date: 30-Dec-2011
• Completion Date: 20-Dec-2011

Standards Content (Sample)

Technical Specification
Railway Telecommunications (RT);
GSM-R improved receiver parameters;
Part 1: Requirements for radio reception

2 ETSI TS 102 933-1 V1.2.1 (2011-12)

Reference
RTS/RT-EGSM-R-003-1
Keywords
ER-GSM, radio, R-GSM
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: [phone]  Fax: [phone]

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
Individual copies of the present document can be downloaded from:
http://www.etsi.org
The present document may be made available in more than one electronic version or in print. In any case of existing or
perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF).
In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive
within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
http://portal.etsi.org/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2011.
All rights reserved.
TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI
3 ETSI TS 102 933-1 V1.2.1 (2011-12)
Contents
Intellectual Property Rights . 4
Foreword . 4
1 Scope . 5
2 References . 5
2.1 Normative references . 5
2.2 Informative references . 6
3 Abbreviations . 6
4 Frequency bands and channel arrangement . 6
5 Transmitter characteristics . 7
5.1 Output power . 7
5.1.1 Mobile Station . 7
6 Receiver characteristics . 9
6.1 Blocking characteristics . 9
6.2 Intermodulation characteristics . 10
7 Other requirements . 10
Annex A (normative): Environmental conditions . 11
A.1 General . 11
A.2 Environmental requirements for the MSs. 11
A.2.1 Temperature (R-GSM 900 and ER-GSM 900) . 11
A.2.2 Vibration (R-GSM 900 and ER-GSM 900) . 11
Annex B (informative): Bibliography . 12
History . 13

ETSI
4 ETSI TS 102 933-1 V1.2.1 (2011-12)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://ipr.etsi.org).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Technical Specification (TS) has been produced by ETSI Technical Committee Railway Telecommunications
(RT).
The present document is part 1 of a multi-part deliverable covering the Railway Telecommunications (RT); GSM-R
improved receiver parameters, as identified below:
Part 1: "Requirements for radio reception";
Part 2: "Radio conformance testing".
ETSI
5 ETSI TS 102 933-1 V1.2.1 (2011-12)
1 Scope
The present document defines the requirements for the receiver of professional mobile station (professional MS) for the
pan-European digital cellular telecommunication system R-GSM/ER-GSM.
Requirements are defined for two categories of parameters:
• Those that are required to provide compatibility between the radio channels, connected either to separate or
common antennas, that are used in the system. This category also includes parameters providing compatibility
with existing systems in the same or adjacent frequency bands.
• Those that define the reception requirements for the professional MS.
The present document defines the Radio Frequency characteristics specific for the professional Mobile Station. The
measurement methods are specified in TS 102 933-2 [5] and TS 100 607-1 [2].
MSs may operate on more than one of the frequency bands specified in clause 2. These MSs, defined in
EN 300 919 [1], are referred to as "Multi band MSs" in the present document.
2 References
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
reference document (including any amendments) applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
http://docbox.etsi.org/Reference.
NOTE: While any hyperlinks included in this clause were valid at the time of publication ETSI cannot guarantee
their long term validity.
2.1 Normative references
The following referenced documents are necessary for the application of the present document.
[1] ETSI EN 300 919: "Digital cellular telecommunications system (Phase 2+) (GSM); Types of
Mobile Stations (MS) (GSM 02.06)".
[2] ETSI TS 100 607-1: "Digital cellular telecommunications system (Phase 2+); Mobile Station (MS)
conformance specification; Part 1: Conformance specification (3GPP 11.10-1 Release 1999)".
[3] CENELEC EN 50155: "Railway applications - Electronic equipment used on rolling stock".
[4] ETSI TS 100 910: "Digital cellular telecommunications system (Phase 2+); Radio transmission
and reception (3GPP TS 05.05 Release 1999)".
[5] ETSI TS 102 933-2: "Railway Telecommunications GSM-R improved receiver parameters ;
Part 2: Radio conformance testing".
[6] UIC Project EIRENE (European Integrated Railway Radio Enhanced Network): "System
Requirements Specification".
[7] ETSI TS 100 911: "Digital cellular telecommunications system (Phase 2+); Radio subsystem link
control (3GPP TS 05.08)".
[8] ETSI TS 101 349: "Digital cellular telecommunications system (Phase 2+); General Packet Radio
Service (GPRS); Mobile Station (MS) - Base Station System (BSS) interface; Radio Link
Control/Medium Access Control (RLC/MAC) protocol (3GPP TS 04.60)".
ETSI
6 ETSI TS 102 933-1 V1.2.1 (2011-12)
[9] ITU-T Recommendation O.153: "Basic parameters for the measurement of error performance at
bit rates below the primary rate".
2.2 Informative references
The following referenced documents are not necessary for the application of the present document but they assist the
user with regard to a particular subject area.
[i.1] ETSI TR 101 748: "Digital cellular telecommunications system (Phase 2+) (GSM); Abbreviations
and acronyms (GSM 01.04)".
3 Abbreviations
For the purposes of the present document, the abbreviations given in TR 101 748 [i.1] apply.
4 Frequency bands and channel arrangement
i) Railways GSM 900 Band, R-GSM (includes Standard and Extended GSM 900 Band):
- for Railways GSM 900 band, the system is required to operate in the following frequency band:
� 876 MHz to 915 MHz: mobile transmit, base receive;
� 921 MHz to 960 MHz: base transmit, mobile receive.
ii) Extended Railways GSM 900 Band, ER-GSM (includes Standard and Extended GSM 900 Band):
- for Railways GSM 900 band, the system is required to operate in the following frequency band:
� 873 MHz to 915 MHz: mobile transmit, base receive;
� 918 MHz to 960 MHz: base transmit, mobile receive.
NOTE 1: The term GSM 900 is used for any GSM system, which operates in any 900 MHz band.
NOTE 2: The BTS may cover a complete band, or the BTS capabilities may be restricted to a subset only,
de
...