ETSI TS 145 008 V7.12.0 (2008-10)

Digital cellular telecommunications system (Phase 2+); Radio subsystem link control (3GPP TS 45.008 version 7.12.0 Release 7)

RTS/TSGG-0145008v7c0

General Information

• Status: Published
• Publication Date: 20-Oct-2008
• Technical Committee: 3GPP GERAN 1 - Radio aspects
• Current Stage: 12 - Completion
• Due Date: 08-Oct-2008
• Completion Date: 21-Oct-2008

Standards Content (Sample)

ETSI TS 145 008 V7.12.0 (2008-10)
Technical Specification


Digital cellular telecommunications system (Phase 2+);
Radio subsystem link control
(3GPP TS 45.008 version 7.12.0 Release 7)


R
GLOBAL SYSTEM FOR
MOBILE COMMUNICATIONS

---------------------- Page: 1 ----------------------
3GPP TS 45.008 version 7.12.0 Release 7 1 ETSI TS 145 008 V7.12.0 (2008-10)



Reference
RTS/TSGG-0145008v7c0
Keywords
GSM
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: [phone]  Fax: [phone]

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
Individual copies of the present document can be downloaded from:
http://www.etsi.org
The present document may be made available in more than one electronic version or in print. In any case of existing or
perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF).
In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive
within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
http://portal.etsi.org/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2008.
All rights reserved.

TM TM TM TM
DECT , PLUGTESTS , UMTS , TIPHON , the TIPHON logo and the ETSI logo are Trade Marks of ETSI registered
for the benefit of its Members.
TM
3GPP is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners.
ETSI

---------------------- Page: 2 ----------------------
3GPP TS 45.008 version 7.12.0 Release 7 2 ETSI TS 145 008 V7.12.0 (2008-10)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://webapp.etsi.org/IPR/home.asp).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Technical Specification (TS) has been produced by ETSI 3rd Generation Partnership Project (3GPP).
The present document may refer to technical specifications or reports using their 3GPP identities, UMTS identities or
GSM identities. These should be interpreted as being references to the corresponding ETSI deliverables.
The cross reference between GSM, UMTS, 3GPP and ETSI identities can be found under
http://webapp.etsi.org/key/queryform.asp.
ETSI

---------------------- Page: 3 ----------------------
3GPP TS 45.008 version 7.12.0 Release 7 3 ETSI TS 145 008 V7.12.0 (2008-10)
Contents
Intellectual Property Rights.2
Foreword.2
Foreword.7
1 Scope.8
1.1 References.8
1.2 Abbreviations.9
2 General.9
3 Handover.11
3.1 Overall process.11
3.2 MS measurement procedure.11
3.3 BSS measurement procedure.11
3.4 Strategy.11
4 RF power control.12
4.1 Overall process.12
4.2 MS implementation.12
4.3 MS power control range .13
4.4 BSS implementation.14
4.5 BSS power control range.14
4.6 Strategy.14
4.7 Timing.14
4.7.1 Normal Power Control.14
4.7.2 Fast Power Control .15
4.7.3 Enhanced Power Control .15
4.8 Dedicated channels used for a voice group call or voice broadcast.15
5 Radio link failure.16
5.1 Criterion.16
5.2 MS procedure.16
5.3 BSS procedure.17
6 Idle mode tasks.17
6.1 Introduction.17
6.2 Measurements for normal cell selection.18
6.3 Measurements for stored list cell selection.18
6.4 Criteria for cell selection and reselection .19
6.5 Downlink signalling failure.20
6.6 Measurements for Cell Reselection.20
6.6.1 Monitoring of received signal level and BCCH data .20
6.6.2 Path loss criteria and timings for cell re-selection .21
6.6.3 Cell reselection algorithm for SoLSA.22
6.6.4 Measurements on cells of other radio access technologies .23
6.6.5 Algorithm for cell re-selection from GSM to UTRAN.24
6.7 Release of TCH, SDCCH and DBPSCH.26
6.7.1 Normal case.26
6.7.2 Call re-establishment.26
6.8 Abnormal cases and emergency calls.27
7 Network pre-requisites .27
7.1 BCCH carriers.27
7.2 Identification of surrounding BSS for handover measurements.28
7.3 Handover measurements on other radio access technologies.30
8 Radio link measurements .31
8.1 Signal level.32
8.1.1 General.32
ETSI

---------------------- Page: 4 ----------------------
3GPP TS 45.008 version 7.12.0 Release 7 4 ETSI TS 145 008 V7.12.0 (2008-10)
8.1.2 Physical parameter.32
8.1.3 Statistical parameters.33
8.1.4 Range of parameter.33
8.1.5 Measurement quantity for other radio access technologies .34
8.1.5.1 UTRAN FDD.34
8.1.5.2 UTRAN TDD.34
8.1.5.3 cdma2000.34
8.2 Signal quality.34
8.2.1 General.34
8.2.2 Physical parameter.34
8.2.3 Statistical parameters.35
8.2.3.1 RXQUAL.35
8.2.3.2 MEAN_ BEP and CV_BEP .35
8.2.4 Range of parameter RXQUAL .36
8.2.5 Range of parameters MEAN_BEP and CV_BEP.37
8.3 Aspects of discontinuous transmission (DTX).40
8.4 Measurement reporting.41
8.4.1 Measurement reporting for the MS.41
8.4.1a Measurement reporting for the MS in FPC mode .42
8.4.1b Measurement reporting for the MS in EPC mode.42
8.4.2 Measurement reporting for the MS on a SDCCH.43
8.4.3 Additional cell reporting requirements for multi band MS.43
8.4.4 Common aspects for the MS on a TCH, a SDCCH or a DBPSCH.44
8.4.5 Measurement reporting for the BSS .44
8.4.6 Extended measurement reporting.45
8.4.7 Additional cell reporting requirements for multi-RAT MS .45
8.4.8 Enhanced Measurement Reporting .46
8.4.8.1 Reporting Priority.46
8.4.8.2 Measurement Reporting.47
8.4.8.3 NBR_RCVD_BLOCKS for FLO.48
8.5 Absolute MS-BTS distance .48
8.5.1 General.48
8.5.2 Physical parameter.48
9 Control parameters .49
10 GPRS mode tasks.53
10.1 Cell Re-selection.53
10.1.1 Monitoring the received signal level and PBCCH data .54
10.1.1.1 Packet idle mode or MAC-Idle state .54
10.1.1.2 Packet transfer mode or MAC-Shared state .55
10.1.1.2a Broadcast/multicast receive mode.56
10.1.1.3 Monitoring cells of other radio access technologies .56
10.1.2 Cell Re-selection Criteria.58
10.1.3 Cell Re-selection Algorithm.59
10.1.3.1 Abnormal cell reselection .60
10.1.3.2 Algorithm for cell re-selection from GSM to UTRAN .60
10.1.4 Network controlled Cell re-selection .61
10.1.4.1 Measurement reporting.62
10.1.4.2 Cell re-selection command.65
10.1.4.3 Exceptional cases.65
10.2 RF Power Control.65
10.2.1 MS output power .65
10.2.2 BTS output power.67
10.2.3 Measurements at MS side .68
10.2.3.1 Deriving the C value .68
10.2.3.1.1 Packet idle mode or MAC-Idle state .68
10.2.3.1.2 Packet transfer mode or MAC-Shared state .68
10.2.3.2 Derivation of Channel Quality Report .70
10.2.3.2.1 Packet transfer mode or MAC-Shared state .70
10.2.3.2.2 Void.73
10.2.3.2.3 Measurement reporting.73
ETSI

---------------------- Page: 5 ----------------------
3GPP TS 45.008 version 7.12.0 Release 7 5 ETSI TS 145 008 V7.12.0 (2008-10)
10.2.3.3 Range of parameters MEAN_BEP and CV_BEP for EGPRS2 .74
10.2.4 Measurements at BSS side.78
10.3 Measurement requirements.78
10.4 Control parameters.78
11 CTS mode tasks.84
11.1 CTS idle mode tasks.84
11.1.1 CTS cell selection .85
11.1.1.1 Synchronization and measurements for CTS cell selection .85
11.1.1.2 Initial sychronization of CTS-MS .85
11.1.2 Criterion for CTS cell selection .85
11.1.3 Monitoring of CTSBCH and CTSPCH.86
11.1.3.1 Monitoring of received signal level .86
11.1.3.2 Downlink beacon failure.86
11.1.3.3 Downlink paging failure.86
11.1.4 Procedures with reporting to the CTS-FP .86
11.1.4.1 AFA monitoring.86
11.1.4.2 BCCH detection.87
11.1.4.3 Observed Frequency Offset (OFO) measurement.87
11.2 Intra-cell handover.87
11.2.1 Overall process.87
11.2.2 CTS-MS measurement procedure.87
11.2.3 CTS-FP measurement procedure.87
11.2.4 Strategy.88
11.3 RF power control.88
11.3.1 Overall process.88
11.3.2 CTS-MS implementation.88
11.3.3 CTS-MS power control range.88
11.3.4 CTS-FP implementation.88
11.3.5 CTS-FP power control range .89
11.3.6 Strategy.89
11.3.7 Timing.89
11.4 Radio link failure.89
11.4.1 Criterion.89
11.4.2 CTS-MS procedure.89
11.4.3 CTS-FP procedure.90
11.5 Radio link measurements.90
11.5.1 Signal strength.90
11.5.1.1 General.90
11.5.1.2 Physical parameter.90
11.5.1.3 Statistical parameters.90
11.5.1.4 Range of parameter .90
11.5.2 Signal quality.91
11.5.2.1 General.91
11.5.2.2 Physical parameter.91
11.5.2.3 Statistical parameters.91
11.5.2.4 Range of parameter .91
11.5.3 Aspects of discontinuous transmission (DTX) .91
11.5.4 Measurement reporting for the CTS-MS on a TCH.91
11.6 Control of CTS-FP service range .92
11.7 Control parameters.92
12 COMPACT Mode Tasks.94
12.1 Introduction.94
12.2 Network Pre-requisites.94
12.2.1 CPBCCH carriers.94
12.3 COMPACT Idle Mode Tasks.94
12.3.1 Introduction.
...