ETSI ETS 300 561 ed.1 (1995-08)
European digital cellular telecommunications system (Phase 2); Performance requirements on the mobile radio interface (GSM 04.13)
European digital cellular telecommunications system (Phase 2); Performance requirements on the mobile radio interface (GSM 04.13)
DE/SMG-030413P
Evropski digitalni celični telekomunikacijski sistem (faza 2) – Zahtevane lastnosti za vmesnik mobilnega radia (GSM 04.13)
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST ETS 300 561 E1:2003
01-december-2003
(YURSVNLGLJLWDOQLFHOLþQLWHOHNRPXQLNDFLMVNLVLVWHPID]D±=DKWHYDQHODVWQRVWL
]DYPHVQLNPRELOQHJDUDGLD*60
European digital cellular telecommunications system (Phase 2); Performance
requirements on the mobile radio interface (GSM 04.13)
Ta slovenski standard je istoveten z: ETS 300 561 Edition 1
ICS:
33.070.50 Globalni sistem za mobilno Global System for Mobile
telekomunikacijo (GSM) Communication (GSM)
SIST ETS 300 561 E1:2003 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ETS 300 561 E1:2003
---------------------- Page: 2 ----------------------
SIST ETS 300 561 E1:2003
EUROPEAN ETS 300 561
TELECOMMUNICATION July 1995
STANDARD
Source: ETSI TC-SMG Reference: DE/SMG-030413P
ICS: 33.060.30
European digital cellular telecommunications system, Global System for Mobile communications
Key words:
(GSM)
European digital cellular telecommunications system (Phase 2);
Performance requirements on the mobile radio interface
(GSM 04.13)
ETSI
European Telecommunications Standards Institute
ETSI Secretariat
F-06921 Sophia Antipolis CEDEX - FRANCE
Postal address:
650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE
Office address:
c=fr, a=atlas, p=etsi, s=secretariat - secretariat@etsi.fr
X.400: Internet:
Tel.: +33 92 94 42 00 - Fax: +33 93 65 47 16
Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the
foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 1995. All rights reserved.
New presentation - see History box
---------------------- Page: 3 ----------------------
SIST ETS 300 561 E1:2003
Page 2
ETS 300 561: July 1995 (GSM 04.13 version 4.0.2)
Whilst every care has been taken in the preparation and publication of this document, errors in content,
typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to
"ETSI Editing and Committee Support Dept." at the address shown on the title page.
---------------------- Page: 4 ----------------------
SIST ETS 300 561 E1:2003
Page 3
ETS 300 561: July 1995 (GSM 04.13 version 4.0.2)
Contents
Foreword .5
1 Scope .7
2 Normative references.7
3 Definitions and abbreviations .8
3.1 Abbreviations .8
3.2 Definitions .8
4 Default conditions.8
5 Requirements.8
5.1 General requirements .8
5.1.1 Response to layer 3 message.8
5.1.2 Response to an erroneous layer 3 message.8
5.2 Layer 3 Radio Resource signalling .9
5.2.1 Cell reselection.9
5.2.2 Paging commands and immediate assignment rejection (Timer T3122).9
5.2.3 Immediate assignment (Timer T3101).9
5.2.4 Channel assignment.9
5.2.5 Channel mode modify .9
5.2.6 Handover access.10
5.2.6.1 Finely, pseudo and pre synchronized cases.10
5.2.6.2 Non synchronized case .11
5.2.7 Encryption.11
5.2.8 Classmark change .11
5.2.9 Classmark interrogation .11
5.2.10 Release (Timer T3110) .11
5.3 Layer 3 Mobility Management signalling.12
5.3.1 Periodic location updating timer .12
5.3.2 Identification .12
5.3.3 Authentication.12
5.3.4 T3240 expiry.12
5.3.5 TMSI reallocation .12
5.3.6 IMSI detach .12
5.3.7 Location updating with random access failure .12
5.3.8 Follow on call.13
5.4 Layer 3 Call Control signalling .13
5.4.1 Time to send SETUP message.13
5.4.2 Response times to CC messages.13
5.4.3 User alerting .14
5.4.4 Call establishment.14
5.4.5 Call reestablishment.14
5.4.6 In call modification.14
5.4.7 DTMF .14
5.5 Supplementary service signalling .14
5.5.1 Advice of Charge Charging (AoCC) .14
5.6 Short Message Services Point to Point.15
5.6.1 CP-DATA.15
5.6.2 RP-DATA.15
History.16
---------------------- Page: 5 ----------------------
SIST ETS 300 561 E1:2003
Page 4
ETS 300 561: July 1995 (GSM 04.13 version 4.0.2)
Blank page
---------------------- Page: 6 ----------------------
SIST ETS 300 561 E1:2003
Page 5
ETS 300 561: July 1995 (GSM 04.13 version 4.0.2)
Foreword
This European Telecommunication Standard (ETS) has been produced by the Special Mobile Group
(SMG) Technical Committee (TC) of the European Telecommunications Standards Institute (ETSI).
This ETS specifies the measurable performance requirements for signalling aspects of Mobile Stations
(MSs) used within the European digital cellular telecommunications system (Phase 2).
04.13
This ETS corresponds to GSM technical specification, GSM version 4.0.2.
Reference is made within this ETS to GSM Technical Specifications (GSM-TS) (note).
NOTE: TC-SMG has produced documents which give the technical specifications for the
implementation of the European digital cellular telecommunications system.
Historically, these documents have been identified as GSM Technical Specifications
(GSM-TS). These TSs may have subsequently become I-ETSs (Phase 1), or ETSs
(Phase 2), whilst others may become ETSI Technical Reports (ETRs). GSM-TSs are,
for editorial reasons, still referred to in current GSM ETSs.
Transposition dates
Date of adoption of this ETS: 30 July 1995
Date of latest announcement of this ETS (doa): 31 October 1995
Date of latest publication of new National Standard
or endorsement of this ETS (dop/e): 30 April 1996
Date of withdrawal of any conflicting National Standard (dow): 30 April 1996
---------------------- Page: 7 ----------------------
SIST ETS 300 561 E1:2003
Page 6
ETS 300 561: July 1995 (GSM 04.13 version 4.0.2)
Blank page
---------------------- Page: 8 ----------------------
SIST ETS 300 561 E1:2003
Page 7
ETS 300 561: July 1995 (GSM 04.13 version 4.0.2)
1 Scope
This European Telecommunication Standard (ETS) specifies measurable performance requirements for
signalling aspects of mobile stations. To allow implementation flexibility it has been chosen to specify
requirements on the whole mobile station rather than to specify requirements on each "OSI layer". As a
consequence the performance requirements do not fit conveniently in specifications such as TS GSM
04.08 (layer 3 only) or TS GSM 04.06 (layer 2 only).
The main aim of this ETS is to provide the justification for testing of requirements that are not included in
other GSM specifications. Where specific requirements are included in other GSM specifications they are
not duplicated here.
Mobile Stations have to perform a wide variety of functions. As a consequence most performance
measurements have to be made under a set of defined conditions: where necessary, these are included in
this ETS.
Where necessary certain assumptions are made about the interaction times between the mobile
equipment and the SIM. If the (test) SIM does not respond within the assumed time then appropriate
allowances shall be made.
Additionally, it is intended that this ETS should contain sufficient requirements to enable some undefined
network timers in TS GSM 04.08 to be calculated.
2 Normative references
This ETS incorporates by dated and undated reference, provisions from other publications. These
normative references are cited at the appropriate places in the text and the publications are listed
hereafter. For dated references, subsequent amendments to or revisions of any of these publications
apply to this ETS only when incorporated in it by amendment or revision. For undated references, the
latest edition of the publication referred to applies.
[1] GSM 01.04 (ETR 100): "European digital cellular telecommunications system
(Phase 2); Definitions, abbreviations and acronyms".
[2] GSM 03.22 (ETS 300 535): "European digital cellular telecommunications
system (Phase 2); Functions related to Mobile Station (MS) in idle mode".
[3] GSM 04.06 (ETS 300 555): "European digital cellular telecommunications
system (Phase 2); Mobile Station - Base Station System (MS - BSS) interface
Data Link (DL) layer specification".
[4] GSM 04.08 (ETS 300 557): "European digital cellular telecommunications
system (Phase 2); Mobile radio interface layer 3 specification".
[5] GSM 04.86 (ETS 300 570): "European digital cellular telecommunications
system (Phase 2); Advice of Charge (AoC) supplementary services - Stage 3".
[6] GSM 05.02 (ETS 300 574): "European digital cellular telecommunications
system (Phase 2); Multiplexing and multiple access on the radio path".
[7] GSM 05.08 (ETS 300 578): "European digital cellular telecommunications
system (Phase 2); Radio subsystem link control".
---------------------- Page: 9 ----------------------
SIST ETS 300 561 E1:2003
Page 8
ETS 300 561: July 1995 (GSM 04.13 version 4.0.2)
3 Definitions and abbreviations
3.1 Abbreviations
Abbreviations used in this ETS are listed in GSM 01.04.
3.2 Definitions
Ready to transmit
In this ETS the phrase "ready to transmit the message before time x" is defined to mean that the
MS shall transmit part of that message no later than the first burst of the first TCH or control
channel block that occurs after time x.
4 Default conditions
Unless otherwise stated, throughout this ETS the following conditions are associated with the
requirements:
- ideal radio link with an insignificant bit error rate;
- no other signalling is in progress on the main DCCH;
- messages sent by the network are correctly formed;
- the only established data link (or the only data link to be established) is on SAPI 0;
- any Starting Time IE that is included in a message sent by the network does not require the action
to be delayed;
- cells are not barred and all access classes are allowed;
- the layer 2 performance of the network shall satisfy the "System Performance Requirements" of
subclause 5.9 of TS GSM 04.06;
- messages sent by the network may contain any set of optional IEs, and any permitted set of
conditional IEs;
- the mobile has a valid SIM inserted, is powered on, and the SIM's update status is "updated"; and
- on the BCCH, the Page Mode IE is not set to "paging reorganisation" or "same as before".
5 Requirements
5.1 General requirements
5.1.1 Response to layer 3 message
The requirements of subclause 5.1.1 apply if there are no specific requirements for a layer 3 message in
other parts of clause 5.
If the last timeslot of the message block containing a network command occurs at time T, then the MS
shall be ready to transmit the response before time T + 500 ms.
5.1.2 Response to an erroneous layer 3 message
If the last timeslot of the message block containing an erroneous RR, MM or CC message occurs at time
T and if TS GSM 04.08 requires a status message to be returned to the network then the MS shall be
ready to transmit the RR-STATUS or MM-STATUS or STATUS message before T + 500 ms.
---------------------- Page: 10 ----------------------
SIST ETS 300 561 E1:2003
Page 9
ETS 300 561: July 1995 (GSM 04.13 version 4.0.2)
5.2 Layer 3 Radio Resource signalling
5.2.1 Cell reselection
If the BA(SACCH) and BA(BCCH) lists only differ by the carrier of the serving cell and if the MS has been
in a call on the serving cell for more than 10 seconds then, if the last timeslot of the message block
containing a CHANNEL RELEASE message occurs at time T the MS shall respond to PAGE REQUEST
messages sent later than T + 3.5 seconds.
In other cases, if the last timeslot of the message block containing a CHANNEL RELEASE message
occurs at time T the MS shall respond to PAGE REQUEST messages sent later than T + R + 2 seconds,
where R is the higher of 5 seconds and (((5 * N + 6) DIV 7) * BS_PA_MFRMS / 4) seconds. N is the
number of non-serving cell BCCH carriers in the BA(BCCH) list and the parameter BS_PA_MFRMS is
defined in TS GSM 05.02.
5.2.2 Paging commands and immediate assignment rejection (Timer T3122)
If the last timeslot of the message block containing an IMMEDIATE ASSIGNMENT REJECT message is
sent at time T and contains a Wait Indication of W seconds then the MS shall at least respond to PAGE
REQUEST messages sent later than T + (W + 1) seconds.
5.2.3 Immediate assignment (Timer T3101)
If the last timeslot of the message block containi
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.