ETSI TR 103 061-6 V1.1.1 (2015-09)

Intelligent Transport Systems (ITS); Testing; Conformance test specifications for ITS Security; Part 6: Validation report

DTR/ITS-0050022

General Information

• Status: Published
• Publication Date: 02-Sep-2015
• Technical Committee: ITS WG5 - Security
• Current Stage: 12 - Completion
• Due Date: 29-Sep-2015
• Completion Date: 03-Sep-2015

Standards Content (Sample)

ETSI TR 103 061-6 V1.1.1 (2015-09)






TECHNICAL REPORT
Intelligent Transport Systems (ITS);
Testing;
Conformance test specifications for ITS Security;
Part 6: Validation report

---------------------- Page: 1 ----------------------
2 ETSI TR 103 061-6 V1.1.1 (2015-09)



Reference
DTR/ITS-0050022
Keywords
ITS, OTE, testing
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: [phone]  Fax: [phone]

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
The present document can be downloaded from:
http://www.etsi.org/standards-search
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
https://portal.etsi.org/People/CommiteeSupportStaff.aspx
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2015.
All rights reserved.

TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI

---------------------- Page: 2 ----------------------
3 ETSI TR 103 061-6 V1.1.1 (2015-09)
Contents
Intellectual Property Rights . 5
Foreword . 5
Modal verbs terminology . 5
Introduction . 5
1 Scope . 7
2 References . 7
2.1 Normative references . 7
2.2 Informative references . 7
3 Abbreviations . 8
4 Validation report . 8
4.1 Validation level . 8
4.2 Source code evaluation . 8
4.2.1 TTCN-3 version . 8
4.2.2 TTCN-3 tools used for compilation . 8
4.3 Validation Process . 9
4.3.1 Test Platforms . 9
4.3.2 SUTs . 9
4.3.3 Validation Status . 9
4.4 Feedback to standardization process . 11
4.4.1 Base standard issues. 11
4.4.2 New features . 12
4.4.3 Test specification issues . 12
4.4.4 Typical SUT issues . 12
History . 14

ETSI

---------------------- Page: 3 ----------------------
4 ETSI TR 103 061-6 V1.1.1 (2015-09)
List of tables
Table 1: TTCN-3 tools used for compilation . 9
Table 2: Validation test platform components . 9
Table 3: SUTs used for validation . 9
Table 4: Test case validation status . 9

ETSI

---------------------- Page: 4 ----------------------
5 ETSI TR 103 061-6 V1.1.1 (2015-09)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://ipr.etsi.org).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Technical Report (TR) has been produced by ETSI Technical Committee Intelligent Transport Systems (ITS).
The present document is part 6 of a multi-part deliverable covering Intelligent Transport Systems (ITS); Testing;
Conformance test specifications for ITS Security, as identified below:
Part 1: "Conformance test specifications for Co-operative Awareness Messages (CAM); CAM validation report";
Part 2: "Conformance test specifications for Decentralized Environmental Notification basic service Messages
(DENM); DENM validation report";
Part 3: "Conformance test specifications for Geographical addressing and forwarding for point-to-point and
point-to-multipoint communications; GeoNetworking validation report";
Part 4: "Conformance test specification for GeoNetworking Basic Transport Protocol (BTP); GeoNetworking
BTP validation report";
Part 5: "IPv6 over GeoNetworking validation report";
Part 6: "Validation report".
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "need not", "will", "will not", "can" and
"cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of
provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
Introduction
In response to EC mandate M/453 [i.6], ETSI Technical Committee ITS has standardized base and test specifications
for ITS protocols. In a next step a prototype TTCN-3 test system was built and validated. The present document and its
related ETSI TR 103 099 [i.3] (Architecture of Conformance Validation Framework), describe the validation and design
of the prototype TTCN-3 test system.
The action described in the present document has supported the implementation of ITS standards by:
• Making available validated and standardized test specifications and thus enabling the application of reliable
certification schemes.
• Executing conformance validation framework against real Implementations Under Test (IUTs) from industry
and thus providing these companies with a conformance assessment of their implementations. During the
lifetime of this action, the conformance validation framework was as well provided at ITS Cooperative
Mobility Services Interoperability events.
ETSI

---------------------- Page: 5 ----------------------
6 ETSI TR 103 061-6 V1.1.1 (2015-09)
• Releasing all software as open source and thus allowing industry to build and run their own conformance
validation framework.
ETSI

---------------------- Page: 6 ----------------------
7 ETSI TR 103 061-6 V1.1.1 (2015-09)
1 Scope
The present document is the validation report of the ITS Security conformance tests defined in ETSI TS 103 096-3 [i.2]
derived from ETSI TS 103 097 (V1.2.1) [i.1]. It provides statistics of executed and validated GeoNetworking
conformance tests. The information provided has been produced by validation against at least two prototype
implementations from industry.
2 References
2.1 Normative references
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
reference document (including any amendments) applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
http://docbox.etsi.org/Reference.
NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee
their long term validity.
The following referenced documents are necessary for the application of the present document.
Not applicable.
2.2 Informative references
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the
reference document (including any amendments) applies.
NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee
their long term validity.
The following referenced documents are not necessary for the application of the present document but they assist the
user with regard to a particular subject area.
[i.1] ETSI TS 103 097 (V1.2.1): "Intelligent Transport Systems (ITS); Security; Security header and
certificate formats".
[i.2] ETSI TS 103 096-3 (V1.2.1): "Intelligent Transport Systems (ITS); Testing; Conformance test
specifications for ITS Security; Part 3: Abstract Test Suite (ATS) and Protocol Implementation
eXtra Information for Testing (PIXIT)".
[i.3] ETSI TR 103 099 (V1.2.1): "Intelligent Transport Systems (ITS); Architecture of conformance
validation framework".
[i.4] ETSI EG 201 015 (V1.1.1): "Methods for Testing and Specification (MTS); Specification of
protocols and services; Validation methodology for standards using SDL; Handbook".
[i.5] ETSI ES 201 873-1 (V4.5.1): "Methods for Testing and Specification (MTS); The Testing and
Test Control Notation version 3; Part 1: TTCN-3 Core Language".
[i.6] EC mandate M/453: "Standardisation mandate addressed to CEN, CENELEC and ETSI in the
field of Information and Communication Technologies to support the interoperability of
co-operative Systems for Intelligent Transport in the European Community".
[i.7] ETSI TS 102 894-2: "Intelligent Transport Systems (ITS); Users and applications requirements;
Part 2: Applications and facilities layer common data dictionary".
ETSI

---------------------- Page: 7 ----------------------
8 ETSI TR 103 061-6 V1.1.1 (2015-09)
3 Abbreviations
For the purposes of the present document, the following abbreviations apply:
AA Authorization Authority
ASN.1 Abstract Syntax Notation One
AT Authorization
...