ETSI ETS 300 019-1-1 ed.1 (1992-02)

Equipment Engineering (EE); Environmental conditions and environmental tests for telecommunications equipment; Part 1-1: Classification of environmental conditions; Storage

DE/EE-01019-1-1

Inženiring opreme (EE) – Okoljski pogoji in preskusi vplivov okolja na telekomunikacijsko opremo – 1-1. del: Klasifikacija okoljskih pogojev – Skladiščenje

General Information

• Status: Published
• Publication Date: 27-Feb-1992
• Technical Committee: EE 1 - EE Environmental Conditions
• Current Stage: 12 - Completion
• Due Date: 12-Feb-1993
• Completion Date: 28-Feb-1992
• Ref Project: SIST ETS 300 019-1-1 E1:2006 - Equipment Engineering (EE); Environmental conditions and environmental tests for telecommunications equipment; Part 1-1: Classification of environmental conditions; Storage

Standards Content (Sample)

SLOVENSKI STANDARD
SIST ETS 300 019-1-1 E1:2006
01-februar-2006
,QåHQLULQJRSUHPH((±2NROMVNLSRJRMLLQSUHVNXVLYSOLYRYRNROMDQD
WHOHNRPXQLNDFLMVNRRSUHPR±GHO.ODVLILNDFLMDRNROMVNLKSRJRMHY±
6NODGLãþHQMH
Equipment Engineering (EE); Environmental conditions and environmental tests for
telecommunications equipment; Part 1-1: Classification of environmental conditions;
Storage
Ta slovenski standard je istoveten z: ETS 300 019-1-1 Edition 1
ICS:
19.040 Preskušanje v zvezi z Environmental testing
okoljem
33.050.01 Telekomunikacijska Telecommunication terminal
terminalska oprema na equipment in general
splošno
SIST ETS 300 019-1-1 E1:2006 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST ETS 300 019-1-1 E1:2006

---------------------- Page: 2 ----------------------

SIST ETS 300 019-1-1 E1:2006
EUROPEAN ETS 300 019-1-1
TELECOMMUNICATION February 1992
STANDARD
Source: ETSI TC-EE Reference: DE/EE-1019-1-1
ICS: 33.080
Environment, test, equipment
Key words:
Equipment Engineering (EE);
Environmental conditions and environmental tests for
telecommunications equipment
Part 1-1: Classification of environmental conditions
Storage
ETSI
European Telecommunications Standards Institute
ETSI Secretariat
F-06921 Sophia Antipolis CEDEX - FRANCE
Postal address:
650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE
Office address:
c=fr, a=atlas, p=etsi, s=secretariat - [e-mail]
X.400: Internet:
Tel.: [phone] - Fax: [phone]
Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the
foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 1992. All rights reserved.
New presentation - see History box

---------------------- Page: 3 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 2
ETS 300 019-1-1: February 1992
Whilst every care has been taken in the preparation and publication of this document, errors in content,
typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to
"ETSI Editing and Committee Support Dept." at the address shown on the title page.

---------------------- Page: 4 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 3
ETS 300 019-1-1: February 1992
Contents
Foreword.5
1 Scope .7
2 Normative references .7
3 Definitions. 7
4 Environmental classes .7
4.1 Class 1.1: Weatherprotected, partly temperature-controlled storage locations.7
4.2 Class 1.2: Weatherprotected, not temperature-controlled storage locations.9
4.3 Class 1.3: Non-weatherprotected storage locations; class 1.3E: non-weatherprotected
storage locations - extended. 11
5 Environmental conditions. 13
5.1 Climatic conditions. 13
5.2 Biological conditions . 14
5.3 Chemically active substances. 14
5.4 Mechanically active substances. 15
5.5 Mechanical conditions. 15
History. 17

---------------------- Page: 5 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 4
ETS 300 019-1-1: February 1992
Blank page

---------------------- Page: 6 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 5
ETS 300 019-1-1: February 1992
Foreword
This multi-part European Telecommunication Standard (ETS) has been produced by the Equipment
Engineering (EE) Technical Committee of the European Telecommunications Standards Institute (ETSI).
This standard is concerned with the environmental conditions and environmental tests for
telecommunications equipment and comprises two main parts, each with subdivisions:
- ETS 300 019-1: "Classification of environmental conditions".
This part of the standard, Part 1, specifies different standardised environmental classes covering
climatic and biological conditions, chemically and mechanically active substances and mechanical
conditions during storage, transportation and in use.
- ETS 300 019-2: "Specification of environmental tests".
This part of the standard specifies the test requirements for the different environmental classes.
Each part of the standard is divided into sub-parts. Sub-part 1-0 will form a general overview of Part 1.
This sub-part, Sub-part 1-1, deals with storage.
This part of the standard (Part 1) was submitted to Public Enquiry as prETS 300 019 Part B. The original
Part A is to be published as ETSI Technical Report ETR 035 entitled: "Equipment Engineering (EE);
Environmental engineering Guidance and terminology".

---------------------- Page: 7 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 6
ETS 300 019-1-1: February 1992
Blank page

---------------------- Page: 8 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 7
ETS 300 019-1-1: February 1992
1 Scope
The purpose of this sub-part of this standard is to define the classes of environmental conditions and their
severities to which equipment may be exposed during storage. Only severe conditions, which may be
harmful to the equipment, are included. The severities specified are those which will have a low probability
of being exceeded; generally less than 1 %.
NOTE 1: Temporary storage during transport is included in Sub-part 1-2: Transportation.
NOTE 2: If the equipment is packaged, the environmental conditions apply to the packaging
protecting the equipment.
2 Normative references
This ETS incorporates, by dated or undated reference, provisions from other publications. These normative
references are cited at the appropriate places in the text and the publications are listed hereafter. For
dated references, subsequent amendments to, or revisions of any of these publications apply to this ETS
only when incorporated into it by amendment or revision. For undated references the latest edition of the
publication referred to applies.
[1] ETR 035: "Equipment Engineering (EE); Environmental engineering Guidance
and terminology".
[2] IEC Publication 721-3-1: "Storage".
[3] IEC Publication 68-2-27: "Test Ea: Shock".
[4] IEC Publication 721-2-4: "Solar radiation and temperature".
3 Definitions
In this sub-part of this standard, the following definitions apply:
Storage: The equipment is placed at a certain site for long periods but is not intended for use during these
periods.
Weatherprotected location: A location at which the equipment is protected from weather influences.
- Totally weatherprotected location: Direct weather influences are totally excluded.
- Partly weatherprotected location: Direct weather influences are not completely excluded.
Non-weatherprotected location: A location at which equipment is not protected from direct weather
influences.
4 Environmental classes
The classes shown in parentheses, e.g. (1C1), may be selected for special applications.
4.1 Class 1.1: Weatherprotected, partly temperature-controlled storage locations
This class is a combination of classes 1K3/1Z2/1B1/1C2(1C1)/1S2/1M2 in IEC Publication 721-3-1 [2].
This class applies to weatherprotected partly temperature controlled storage. Humidity is usually not
controlled. The climatogram is shown in figure 1.
Heating may be used to raise low temperatures especially where there is a significant difference between
the conditions of this class and the open-air climate. Building construction is designed to avoid extremely
high temperatures.

---------------------- Page: 9 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 8
ETS 300 019-1-1: February 1992
This class applies to storage locations:
- where equipment may be exposed to solar radiation and heat radiation. It may also be exposed to
movements of the surrounding air due to draughts in buildings, e.g. through open windows. It is not
subjected to precipitation and water from sources other than rain;
- without particular risks by biological attacks. This includes protective measures, e.g. special
package design, or storing at locations of such construction that mould growth, attacks by animals
etc. are not probable;
- with normal levels of contaminants experienced in urban areas with industrial activities scattered
over the whole area, and/or with heavy traffic;
- without special precautions to minimise the presence of dust or sand, but not situated in proximity to
dust or sand sources;
- with vibration of low significance and insignificant shock.
The conditions of this class may occur in ordinary storage rooms for frost-resistant products.

---------------------- Page: 10 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 9
ETS 300 019-1-1: February 1992
Figure 1: Climatogram for class 1.1 - Weatherprotected, partly temperature-controlled storage
locations
4.2 Class 1.2: Weatherprotected, not temperature-controlled storage locations
This class is a combination of classes 1K4/1Z2/1Z3/1Z5/1B2/1C2(1C1)/1S3/1M2 in IEC Publication 721-
3-1 [2].
This class applies to weatherprotected storage having neither temperature nor humidity control. The
location may have openings directly to the open air, i.e. it may be only partly weatherprotected. The
climatogram is shown in figure 2.
This class applies to storage locations:
- where equipment may be exposed to solar radiation and temporarily to heat radiation. They may
also be exposed to movements of the surrounding air due to draughts, e.g. through doors, windows
or other openings. They may be subjected to condensed water, dripping water and to icing. They
may also be subjected to limited wind-driven precipitation including snow;
- where mould growth, or attacks by animals, except termites, may occur;
- with normal levels of contaminants experienced in urban areas with industrial activities scattered
over the whole area, and/or with heavy traffic;

---------------------- Page: 11 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 10
ETS 300 019-1-1: February 1992
- in areas with sources of sand or dust, including urban areas;
- with vibration of low significance and insignificant shock.
The conditions of this class may occur in:
- unattended buildings;
- some entrances of buildings;
- some garages and shacks.
Figure 2: Climatogram for class 1.2: Weatherprotected, not temperature-controlled storage
locations

---------------------- Page: 12 ----------------------

SIST ETS 300 019-1-1 E1:2006
Page 11
ETS 300 019-1-1: February 1992
4.3 Class 1.3: Non-weatherprotected storage locations; class 1.3E: non-weatherprotected
storage locations - extended
1)
Class 1.3 is a combination of classes 1K8/1Z1/1Z4/1B2/1C2/1S3/1M3(1M4) in IEC Publication 721-3-1
1)
[2]. Class 1.3E is a combination of classes 1Z1/1Z4/1B2/1C2/1S3/1M3(1M4) in IEC Publication 721-3-1
[2] and the severities given in subclause 5.1.
This class applies to storage which is not protected from direct weather influences. The climatogram is
shown in figure 3.
This class applies to storage locations:
- which are directly exposed to an open-air climate including solar radiation, movement of the
surrounding air, precipitation and water jets;
- where mould growth, or attacks by animals but excluding termites, may occur;
- with normal levels of contaminants experienced in urban areas with industrial activities scattered
over the whole area, and/or with heavy traffic;
- in areas with sources of sand or dust, including urban areas;
- with significant vibration and shock, e.g. transmitted from machines or passing vehicles in the
vicinity, etc.

...