ISO 8222:2020/PRF Amd 1
(Amendment)Correction of two typographical errors
Correction of two typographical errors
Correction de deux erreurs typographiques
General Information
RELATIONS
Standards Content (sample)
INTERNATIONAL ISO
STANDARD 8222
Third edition
2020-03
AMENDMENT 1
Petroleum measurement systems —
Calibration — Volumetric measures,
proving tanks and field measures
(including formulae for properties of
liquids and materials)
AMENDMENT 1: Correction of two
typographical errors
Systèmes de mesure du pétrole — Étalonnage — Contenants de
mesure volumétriques, jauges étalons et contenants de mesure de
travail (y compris les formules relatives aux propriétés des liquides et
des matériaux)
AMENDEMENT 1: Correction de deux erreurs typographiques
PROOF/ÉPREUVE
Reference number
ISO 8222:2020/Amd.1:2021(E)
© ISO 2021
---------------------- Page: 1 ----------------------
ISO 8222:2020/Amd.1:2021(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2021
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
PROOF/ÉPREUVE © ISO 2021 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 8222:2020/Amd.1:2021(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).Attention is drawn to the possibility that so
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.