29.035.99 - Other insulating materials

This sheet 8 of IEC 60455-3 gives the requirements for resins for power cable accessories which conform to this specification and meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not on this specification alone.

IEC 61196-8:2012 is part of the IEC 61196 series and applies to semi-flexible coaxial communication cables with polytetrafluoroethylene (PTFE) dielectric and tin soaked copper wire braid outer conductor. These cables are intended for use in microwave and wireless equipments or other signal transmission equipments or units at frequencies from 500 MHz up to 18 GHz.
This publication is to be read in conjunction with IEC 61196-1:2005.

This part of IEC 61061 includes the definitions required for the understanding of all three parts of the standard, the designation of the material types and the general requirements applicable to non-impregnated densified laminated wood for electrical purposes. This specification is intended to cover only sheets and rings of nominal thicknesses between 6 mm and 100 mm, inclusive. Materials which conform to this specification meet established levels of performance. However, the selection of a mat...view more

IEC 60372:2020 is applicable to locking devices used with ball and socket couplings of string insulator units and used with the corresponding metal fittings standardized in IEC 60120, when they are supplied separately.The object of this document is - to define the shapes and some standard dimensions for locking devices, - to define the test methods for locking devices, - to state the acceptance conditions for supply, - to give other dimensions for guidance of manufacturing only. This fourth edit...view more

This part of IEC 61061 includes the definitions required for the understanding of all three parts of the standard, the designation of the material types and the general requirements applicable to non-impregnated densified laminated wood for electrical purposes. This specification is intended to cover only sheets and rings of nominal thicknesses between 6 mm and 100 mm, inclusive.

Applicable to locking devices used with ball and socket couplings of string insulator units and used with the corresponding metal fittings standardized in EN 60120. -Defines the shapes and some standard dimensions for locking devices as well as the test methods for locking devices; -States the acceptance conditions for supply and gives other dimensions for guidance of manufacturing only. Replaces EN 60372-1 (1977) and 60372-2 (1976).

EN following parallel vote

EN following parallel vote

Corrigendum to EN issued February 2002

EN following parallel vote