47.020.05 - Materials and components for shipbuilding

This document describes the specification of high manganese (Mn) austenitic steel thin strips with good weldability and good resistance to atmospheric corrosion intended to be used for LNG tanks on board ships. It covers strips with a thickness ranging from 0,3 mm to 6,0 mm.

This document describes the specification of high manganese (Mn) austenitic steel plates to be used for LNG tanks on board ships. The specification of high manganese austenitic steel can be also considered for design and manufacture of cargo tanks and process pressure vessels of LNG supply/terminal and transportation of fuels and traded gases. This document is primarily applicable for the specification of LNG tanks below volumetric capacity of approximately 30 000 m3 using high manganese austeni...view more

ISO 21005:2018 specifies materials and finish, dimensions for interchangeability, tolerances, parallelism and flatness, testing, marking and designation of thermally toughened safety glass panes for windows complying with ISO 3903 and side scuttles complying with ISO 1751.

ISO 17941:2015 specifies classification and designation, requirements, test method, marking, packaging, transport, and storage of hydraulic watertight hinged fireproof doors (hereinafter referred to as "watertight doors"). ISO 17941:2015 is applicable to the design, manufacture, and acceptance of hydraulic watertight hinged fireproof doors with water pressure not more than 1,0 MPa used for ships, other floating structures and ocean engineering.

This European Standard specifies properties and technical conditions for inspection and delivery of wrought and cast aluminium and aluminium alloy products recommended for marine applications, including shipbuilding and offshore applications. Additional information is given about high magnesium alloys, with special regard to their sensitivity to intergranular and exfoliation corrosion. This European Standard is intended to be used in conjunction with relevant European, national or international ...view more

The formulae specified in this International Standard are intended for the establishment of a uniformly acceptable method for calculating the pitting resistance and bending strength capacity for the endurance of the mainpropulsion and auxiliary gears of ships, offshore vessels and drilling rigs, having straight or helical teeth and subject to the rules of classification societies. The rating formulae in this International Standard are not applicable to other types of gear tooth deterioration, su...view more

Specifies the types of hydraulic lubrication nipples and lays down their dimensions. To facilitate the lubrication of machine parts, it is recommended that the number of types and dimensions of nipples be limited in order to avoid the use of too great a number of grease-pumps.

Gives the designation of L sections in an example and the dimensions and sectional properties in a figure and a table. Includes tolerances on height of web and width of flange, on web thickness, on flange thickness as well as the maximum permissible camber, the out-of-square, the tolerances on flatness and on length.