EN 2714-012:2005
(Main)Aerospace series - Cables, electrical, single and multicore for general purpose - Operating temperatures between - 55 °C and 260 °C - Part 012: DM family, screened (braided) and jacketed, UV laser printable - Product standard
Aerospace series - Cables, electrical, single and multicore for general purpose - Operating temperatures between - 55 °C and 260 °C - Part 012: DM family, screened (braided) and jacketed, UV laser printable - Product standard
This standard specifies the characteristics of UV laser printable DM family, 5 to 7 multicore screened (braided) and jacketed electrical lightweight cables for use in the on-board electrical systems of aircraft, at operating temperatures between - 55 °C and 260 °C. Nevertheless, if needed, - 65 °C is also acceptable as shown by cold test.
It shall also be possible to mark these cables by qualified compatible marking.
These markings shall satisfy the requirements of EN 3838.
Luft- und Raumfahrt - Leitungen, elektrisch, ein- und mehradrig, für allgemeine Verwendung - Betriebstemperaturen zwischen - 55 °C und 260 °C - Teil 012: DM-Familie, geschirmt (Umflechtung) und ummantelt, UV Laser-bedruckbar - Produktnorm
Diese Norm legt die Eigenschaften von UV-Laser-bedruckbaren, fünf- bis siebenadrigen, geschirmten (umseilten) und ummantelten, leichten elektrischen Leitungen der DM-Familie zur Verwendung in Bordnetzen von Luftfahrzeugen bei Betriebstemperaturen zwischen 55 °C und 260 °C fest. Es können aber auch, falls erforderlich, 65 °C verwendet werden, wie die Kälteprüfung zeigt.
Es muss auch möglich sein, diese Leitungen mit einer qualifizierten, verträglichen Kennzeichnung zu versehen.
Diese Kennzeichnungen müssen den Anforderungen von EN 3838 entsprechen.
Série aérospatiale - Câbles, électriques, mono et multiconducteurs d'usage général - Températures de fonctionnement comprises entre - 55 °C et 260 °C - Partie 012 : Famille DM, blindés (tressés) et gainés, marquable au laser UV - Norme de produit
Aeronavtika – Eno- ali večžilni električni kabli za splošno uporabo – Delovne temperature med –55 °C in 260 °C – 012. del: Družina DM, oklopljeni (opleteni) in oplaščeni, z možnostjo UV-laserskega tiskanja – Standard za proizvod
General Information
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Aerospace series - Cables, electrical, single and multicore for general purpose - Operating temperatures between - 55 °C and 260 °C - Part 012: DM family, screened (braided) and jacketed, UV laser printable - Product standardYRGSérie aérospatiale - Câbles, électriques, mono et multiconducteurs d'usage général - Températures de fonctionnement comprises entre - 55 °C et 260 °C - Partie 012 : Famille DM, blindés (tressés) et gainés, marquable au laser UV - Norme de produitLuft- und Raumfahrt - Leitungen, elektrisch, ein- und mehradrig, für allgemeine Verwendung - Betriebstemperaturen zwischen - 55 °C und 260 °C - Teil 012: DM-Familie, geschirmt (Umflechtung) und ummantelt, UV Laser-bedruckbar - ProduktnormTa slovenski standard je istoveten z:EN 2714-012:2005SIST EN 2714-012:2006en49.060ICS:SLOVENSKI
STANDARDSIST EN 2714-012:200601-julij-2006
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 2714-012
October 2005 ICS 49.060 English Version
Aerospace series - Cables, electrical, single and multicore for general purpose - Operating temperatures between - 55 °C and 260 °C - Part 012: DM family, screened (braided) and jacketed, UV laser printable - Product standard
Série aérospatiale - Câbles, électriques, mono et multiconducteurs d'usage général - Températures de fonctionnement comprises entre - 55 °C et 260 °C - Partie 012 : Famille DM, blindés (tressés) et gainés, marquable au laser UV - Norme de produit
Luft- und Raumfahrt - Leitungen, elektrisch, ein- und mehradrig, für allgemeine Verwendung - Betriebstemperaturen zwischen - 55 °C und 260 °C - Teil 012: DM-Familie, geschirmt (Umflechtung) und ummantelt UV Laser bedruckbar - Produktnorm This European Standard was approved by CEN on 12 September 2005.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36
B-1050 Brussels © 2005 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 2714-012:2005: E
EN 2714-012:2005 (E) 2 Contents Page Foreword.3 1 Scope.4 2 Normative references.4 3 Terms, definitions and symbols.4 4 Materials and construction.5 5 Required characteristics.7 6 Quality assurance.9 7 Designation.9 8 Identification and marking.9 9 Packaging, labelling and delivery lengths.9 10 Technical specification.9
EN 2714-012:2005 (E) 3 Foreword This European Standard (EN 2714-012:2005) has been prepared by the European Association of Aerospace Manufacturers - Standardization (AECMA-STAN). After enquiries and votes carried out in accordance
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.