EN 2283:2010

Aerospace series - Testing of aircraft wiring

This European Standard specifies:
-   the tests for finished wiring, including connectors and, if necessary, terminals, terminal ends, junction boxes, circuit breakers, etc.;
-   these tests do not concern equipment installed in the aircraft (see operation of systems and do not apply to the wiring used instrumentation;
-   the requirements for verification of aircraft electrical wiring;
-   continuity of circuits;
-   dielectric strength;
-   insulation resistance.

Luft- und Raumfahrt - Prüfung der Verkabelung von Luftfahrzeugen

Diese Europäische Norm legt Folgendes fest:
-   die Prüfungen, die an fertigen Verkabelungen mit ihren Steckverbindern und gegebenenfalls Anschluss-stücken, Kabelschuhen, Verteilerkästen, Schutzschaltern usw. durchzuführen sind;
-   diese Prüfungen gelten nicht für die im Luftfahrzeug eingebauten Geräte (siehe Betrieb der Systeme), und sind nicht anwendbar für die Verkabelung von Messtechnik;
-   die Anforderungen zur Prüfung der elektrischen Verkabelung von Luftfahrzeugen;
-   Stromdurchgang;
-   Spannungsfestigkeit;
-   Isolationswiderstand.

Série aérospatiale - Vérification des câblages d'aéronefs

Aeronavtika - Preskušanje ožičenja pri zrakoplovih

Ta standard določa:
a) preskuse za končno ožičenje, vključno s konektorji in po potrebi terminali, konci terminalov, priključnicami, prekinjevalci toka itd.;
b) ti preskusi ne obravnavajo opreme, vgrajene v zrakoplov (glej obratovanje sistemov) in ne veljajo za instrumente, uporabljene pri ožičenju;
c) zahteve za preverjanje električnega ožičenja zrakopolova:
1) neprekinjenost tokokrogov;
2) jakost napetosti;
3) odpornost izolacije.

General Information

• Status: Published
• Publication Date: 07-Dec-2010
• Withdrawal Date: 29-Jun-2011
• ICS: 49.060 - Aerospace electric equipment and systems
• Technical Committee: ASD-STAN - Aerospace
• Drafting Committee: ASD-STAN/D 2 - Electrical
• Current Stage: 6060 - Definitive text made available (DAV) - Publishing
• Start Date: 08-Dec-2010
• Completion Date: 08-Dec-2010
• Ref Project: SIST EN 2283:2012 - Aerospace series - Testing of aircraft wiring

Relations

• Replaces: EN 2283:1996 - Aerospace series - Testing of aircraft wiring
• Effective Date: 21-Nov-2009

Standards Content (Sample)

SLOVENSKI STANDARD
01-januar-2012
1DGRPHãþD
SIST EN 2283:2001
$HURQDYWLND3UHVNXãDQMHRåLþHQMDSUL]UDNRSORYLK
Aerospace series - Testing of aircraft wiring
Luft- und Raumfahrt - Prüfung der Verkabelung von Luftfahrzeugen
Série aérospatiale - Vérification des câblages d'aéronefs
Ta slovenski standard je istoveten z: EN 2283:2010
ICS:
49.060 /HWDOVNDLQYHVROMVND Aerospace electric
HOHNWULþQDRSUHPDLQVLVWHPL equipment and systems
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 2283
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2010
ICS 49.060 Supersedes EN 2283:1996
English Version
Aerospace series - Testing of aircraft wiring
Série aérospatiale - Vérification des câblages d'aéronefs Luft- und Raumfahrt - Prüfung der Verkabelung von
Luftfahrzeugen
This European Standard was approved by CEN on 4 March 2010.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.

EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 2283:2010: E
worldwide for CEN national Members.

Contents Page
Foreword .3
Introduction .4
1 Scope .4
2 Normative references .4
3 Terms and definitions .5
4 Tests .5
4.1 General .5
4.2 Continuity .5
4.3 Dielectric strength .5
4.4 Insulation resistance .6
4.5 Test preparation .6
5 Procedures .6
5.1 General .6
5.2 Testing of wiring in production .8
5.2.1 Continuity .8
5.2.2 Dielectric strength .8
5.3 Testing of assembled and installed bundles .8
6 Requirements .8
7 Test report .8

Foreword
This document (EN 2283:2010) has been prepared by the Aerospace and Defence Industries Association of
Europe - Standardization (ASD-STAN).
After enquiries and votes carried out in accordance with the rules of this Association, this Standard has
received the approval of the National Associations and the Official Services of the member countries of ASD,
prior to its presentation to CEN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by June 2011, and conflicting national standards shall be withdrawn at
the latest by June 2011.
This document supersedes EN 2283:1996.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
Introduction
Due to the diversity of aircraft, manufacturing and installing methods for wiring, the tests defined in Clause 1
are carried out at different stages in the manufacturing programme:
 after assembly of cables into bundles before installation in the aircraft;
 after installation of bundles into the aircraft;
 after repairs or modifications.
1 Scope
This European Standard specifies:
 the tests for finished wiring, including connectors and, if necessary, terminals, terminal ends, junction
boxes, circuit breakers, etc.;
 these tests do not concern equipment installed in the aircraft (see operation of systems and do not apply
to the wiring used instrumentation;
 the requirements for verification of aircraft electrical wiring;
 continuity of circuits;
 dielectric strength;
 insulation resistance.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
EN 2282, Aerospace series – Characteristics of aircraft electrical supplies
EN 61557-2, Electrical safety in low voltage distribution systems up to 1000 V a.c. and 1500 V d.c. –
Equipment for testing, measuring or monitoring of protective measures – Part 2: Insulation resistance
(IEC 61557-2:2007)
EN 61557-4, Electrical safety in low voltage distribution systems up to 1000 V a.c. and 1500 V d.c. –
Equipment for testing, measuring or monitoring of protective measures – Part 4: Resistance of earth
connection and equipotential bonding (IEC 61557-4:2007
...