ETSI EN 301 166 V1.1.1 (1999-02)
ElectroMagnetic Compatibility and Radio spectrum Matters (ERM); Land mobile service; Technical characteristics and test conditions for radio equipment for analogue and/or digital communication (speech and/or data) and operating on narrowband channels and having an antenna connector
ElectroMagnetic Compatibility and Radio spectrum Matters (ERM); Land mobile service; Technical characteristics and test conditions for radio equipment for analogue and/or digital communication (speech and/or data) and operating on narrowband channels and having an antenna connector
DEN/ERM-RP02-033
Elektromagnetna združljivost in zadeve v zvezi z radijskim spektrom (ERM) – Kopenske mobilne storitve – Tehnične karakteristike in preskusni pogoji za radijsko opremo za analogne oziroma digitalne komunikacije (prenos govora oziroma podatkov), ki deluje v ozkopasovnih kanalih in ima antenski konektor
General Information
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.ElectroMagnetic Compatibility and Radio spectrum Matters (ERM); Land mobile service; Technical characteristics and test conditions for radio equipment for analogue and/or digital communication (speech and/or data) and operating on narrowband channels and having an antenna connector33.100.01Elektromagnetna združljivost na splošnoElectromagnetic compatibility in general33.070.01Mobilni servisi na splošnoMobile services in general33.060.99Druga oprema za radijske komunikacijeOther equipment for radiocommunicationsICS:Ta slovenski standard je istoveten z:EN 301 166 Version 1.1.1SIST EN 301 166 V1.1.1:2003en01-december-2003SIST EN 301 166 V1.1.1:2003SLOVENSKI
STANDARD
SIST EN 301 166 V1.1.1:2003
EN 301 166 V1.1.1 (1999-02)European Standard (Telecommunications series)Electromagnetic compatibilityand Radio spectrum Matters (ERM);Land mobile service;Technical characteristics and test conditions for radioequipment for analogue and/or digital communication(speech and/or data) and operating on narrowbandchannels and having an antenna connectorSIST EN 301 166 V1.1.1:2003
ETSIEN 301 166 V1.1.1 (1999-02)2ReferenceDEN/ERM-RP02-033 (aso00ico.PDF)Keywordsmobile, radio, speech, data, testingETSIPostal addressF-06921 Sophia Antipolis Cedex - FRANCEOffice address650 Route des Lucioles - Sophia AntipolisValbonne - FRANCETel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16Siret N° 348 623 562 00017 - NAF 742 CAssociation à but non lucratif enregistrée à laSous-Préfecture de Grasse (06) N° 7803/88Internetsecretariat@etsi.frIndividual copies of this ETSI deliverablecan be downloaded fromhttp://www.etsi.orgIf you find errors in the present document, send yourcomment to: editor@etsi.frCopyright NotificationNo part may be reproduced except as authorized by written permission.The copyright and the foregoing restriction extend to reproduction in all media.© European Telecommunications Standards Institute 1999.All rights reserved.SIST EN 301 166 V1.1.1:2003
ETSIEN 301 166 V1.1.1 (1999-02)3ContentsIntellectual Property Rights.8Foreword.8Introduction.91Scope.102References.113Definitions, symbols and abbreviations.123.1Definitions.123.2Symbols.133.3Abbreviations.144General.144.1Presentation of equipment for testing purposes.144.1.1Choice of model for type testing.144.1.2Definitions of Switching Range (SR), alignment range and operating frequency range.154.1.2.1Definition of SR.154.1.2.2Definition of alignment range.154.1.2.3Definition of Operating Frequency Range (OFR).154.1.3Definition of the categories of the alignment range (AR0, AR1, AR2 and AR3).154.1.4Testing of equipment of category AR0.154.1.5Testing of equipment of category AR1.154.1.6Testing of equipment of category AR2.164.1.7Testing of equipment of category AR3.164.1.8Testing of equipment capable of being aligned to operate with more than one Channel Separation(CSP).164.1.9Number of samples for type testing.164.1.10Testing of a family of equipment with a total operating range in excess of each equipment'salignments range.174.1.11Testing of equipment with alternative power levels.174.1.12Testing of equipment with alternative hardware configurations.174.1.13Testing of equipment that does not have an external 50 W RF connector (integral antenna equipment).174.1.13.1Equipment with an internal permanent or temporary antenna connector.174.1.13.2Equipment with a temporary antenna connector.184.2Testing using bit streams or messages.184.3Interpretation of the measurement results.184.4Transmitter power.184.5Facilities sockets.185Test conditions, power sources and ambient temperatures.195.1Normal and extreme test conditions.195.2Test power source.195.3Normal test conditions.195.3.1Normal temperature and humidity.195.3.2Normal test power source.195.3.2.1Mains voltage.195.3.2.2Regulated lead-acid battery power sources used on vehicles.195.3.2.3Other power sources.205.4Extreme test conditions.205.4.1Extreme temperatures.205.4.2Extreme test source voltages.205.4.2.1Mains voltage.205.4.2.2Regulated lead-acid battery power sources used on vehicles.205.4.2.3Power sources using other types of batteries.205.4.2.4Other power sources.20SIST EN 301 166 V1.1.1:2003
ETSIEN 301 166 V1.1.1 (1999-02)45.5Procedure for tests at extreme temperatures.215.5.1Procedure for equipment designed for continuous transmission.215.5.2Procedure for equipment designed for intermittent transmission.216General conditions.216.1Test signals.216.1.1Transmitter test signals (B1), (M5) and (M7).216.1.2Receiver test signal for analogue equipment.226.1.3Receiver test signals for data (and digitized voice) equipment (M2), (M3), (M4) and (M6).226.1.4Transmitter effective radiated power test signal (C1).226.2Test load (artificial antenna).226.3PEP.236.4Encoders.236.5Modulation processing.236.6Test sites and general arrangements for radiated measurements.236.7Transmitter automatic shut-off facility.236.8Arrangement for analogue test signals at the input of the transmitter.236.9Arrangement for test signals at the input of the receiver.236.10Receiver mute or squelch facility.246.11Receiver rated audio output power.246.12Facilities for access.246.12.1Analogue access.246.12.2Test points for bit stream measurements.246.12.3Coupling arrangements.246.12.3.1Arrangements for measurements with continuous bit streams.246.12.3.2Arrangements for measurements with messages.256.12.4Modes of operation of the transmitter.256.13Tests of equipment with a duplex filter.257Technical characteristics of the transmitter.257.1Maximum power (PX) (conducted).257.1.1Definition.257.1.2Method of measurement.257.1.3Limit.267.2Maximum effective radiated power.267.2.1Definition.267.2.2Method of measurement.267.2.2.1Evaluation of CW-to-PEP correction factor for signal C1.267.2.2.2Measurements on a test site.267.2.3Limit.277.3Adjacent and alternate channels power.287.3.1Definition.287.3.2Methods of measurement.287.3.3Limit.297.4Spurious emissions.307.4.1Definition.307.4.2Method of measurement.307.4.2.1Method of measuring conducted spurious emissions in a specified load (subclause 7.4.1 (a)).307.4.2.2Method of measuring the effective radiated power (subclause 7.4.1 (b)).307.4.2.3Method of measuring the effective radiated power (subclause 7.4.1 (c)).317.4.3Limits.327.5Intermodulation attenuation.327.5.1Definition.327.5.2Method of measurement.337.5.3Limits.347.6Transient power.347.6.1Definition.347.6.2Method of measurement.347.6.2.1Characteristics of the transient power measuring device.357.6.3Limits.357.7Frequency error.35SIST EN 301 166 V1.1.1:2003
ETSIEN 301 166 V1.1.1 (1999-02)57.7.1Definition.357.7.2Method of measurement.367.7.3Limits.368Technical characteristics of the receiver.378.1Maximum usable sensitivity (analogue, conducted).378.1.1Definition.378.1.2Method of measuring the SINAD ratio.378.1.3Limits.378.2Maximum usable sensitivity (analogue, field strength).378.2.1Definition.388.2.2Method of measurement.388.2.3Limits.398.3Maximum usable sensitivity (data, conducted).398.3.1Definition.398.3.2Methods of measurement.398.3.2.1Method of measurement with continuous bit streams.398.3.2.2Method of measurement with messages.408.3.3Limits.408.4Maximum usable sensitivity (data, field strength).408.4.1Definition.418.4.2Method of measurement.418.4.2.1Method of measurement with continuous bit streams.418.4.2.2Method of measurement with messages.428.4.3Limits.438.5Adjacent channel selectivity.448.5.1Definition.448.5.2Method of measurement.448.5.2.1Method of measurement (analogue).448.5.2.2Method of measurement (data with continuous bit stream).458.5.2.3Method of measurement with messages.458.5.3Limits.468.6Spurious response rejection.468.6.1Definition.478.6.2Method of measurement.478.6.2.1Introduction to the method of measurement.478.6.2.2Method of search over the "limited frequency range".478.6.2.3Method of measurement (analogue).488.6.2.4Method of measurement (data with continuous bit streams).498.6.2.5Method of measurement (data with messages).498.6.3Limits.508.7Intermodulation response rejection.508.7.1Definition.508.7.2Method of measurement.518.7.2.1Method of measurement (analogue).518.7.2.2Method of measurement (data with continuous bit stream).528.7.2.3Method of measurement with messages.528.7.3Limit.538.8Blocking or desensitization.548.8.1Definition.548.8.2Method of measurement.548.8.2.1Method of measurement (analogue).548.8.2.2Method of measurement (data with continuous bit stream).558.8.2.3Method of measurement with messages.558.8.3Limit.568.9Spurious radiations.568.9.1Definition.568.9.2Methods of measurement.578.9.2.1Method of measuring the power level in a specified load (subclause 8.9.1a)).578.9.2.2Method of measuring the effective radiated power (subclause 8.9.1b)).578.9.2.3Method of measuring the effective radiated power (subclause 8.9.1.c).58SIST EN 301 166 V1.1.1:2003
ETSIEN 301 166 V1.1.1 (1999-02)68.9.3Limits.588.10Co-channel rejection.588.10.1Definition.588.10.2Methods of measurement.598.10.2.1Method of measurement (analogue).598.10.2.2 Method of measurement (data with continuous bit stream).598.10.2.3Method of measurement with messages.608.10.3Limits.619Duplex operation.619.1Receiver desensitization (with simultaneous transmission and reception).619.1.1Definition.619.1.2Methods of measurement.629.1.2.1Desensitization measured with analogue modulation.629.1.2.1.1Method of measurement when the equipment has a duplex filter.629.1.2.1.2Method of measurement when the equipment has to operate with two antennas.639.1.2.2Desensitization measured with continuous bit streams.
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.