ISO 29941:2010

Condoms — Determination of nitrosamines migrating from natural rubber latex condoms

ISO 29941:2010 specifies a test method to determine the release of N-nitrosamines from condoms made from natural rubber latex. The method can also be used for other products such as probe covers, prophylactic dams, female condoms and condoms made from synthetic materials, although there was no experience of testing such products at the time of publication.

Préservatifs — Dosage des nitrosamines migrant des préservatifs en latex de caoutchouc naturel

General Information

• Status: Published
• Publication Date: 24-Nov-2010
• ICS: 11.200 - Birth control. Mechanical contraceptives
• Technical Committee: ISO/TC 157 - Non-systemic contraceptives and STI barrier prophylactics
• Drafting Committee: ISO/TC 157 - Non-systemic contraceptives and STI barrier prophylactics
• Current Stage: 9093 - International Standard confirmed
• Completion Date: 08-Dec-2023

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 29941
First edition
2010-12-15


Condoms — Determination
of nitrosamines migrating from natural
rubber latex condoms
Préservatifs — Dosage des nitrosamines migrant des préservatifs
en latex de caoutchouc naturel





Reference number
ISO 29941:2010(E)
©
ISO 2010

---------------------- Page: 1 ----------------------
ISO 29941:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland

ii © ISO 2010 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 29941:2010(E)
Contents Page
Foreword .iv
1 Scope.1
2 Normative references.1
3 Terms and definition .1
4 Principle .1
5 Reagents and materials .2
6 Apparatus.3
7 Procedure.5
8 Calculation and evaluation of the results of the N-nitrosamine content of the solution.7
9 Confirmation of the detected N-nitrosamines .8
10 Test report.9
Bibliography.10

© ISO 2010 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 29941:2010(E)
Foreword
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible
...