ISO 23697-2:2023
(Main)Water quality — Determination of total bound nitrogen (ST-TNb) in water using small-scale sealed tubes — Part 2: Chromotropic acid colour reaction
Water quality — Determination of total bound nitrogen (ST-TNb) in water using small-scale sealed tubes — Part 2: Chromotropic acid colour reaction
This document specifies a method for the determination of total bound nitrogen (ST-TNb) in water of various origins: groundwater, surface water and wastewater, in a measuring range of concentration generally between 0,5 mg/l and 150 mg/l of ST-TNb using the small-scale sealed tube method. Different measuring ranges of small-scale sealed tube methods can be required. The measuring ranges can vary depending on the type of small-scale sealed tube method of different manufacturers. It is up to the user to choose the small-scale sealed tube test with the appropriate application range or to adapt samples with concentrations exceeding the measuring range of a test by preliminary dilution. NOTE The results of a small-scale sealed tube test are most precise in the middle of the application range of the test. All small-scale sealed tube methods are based on a heated alkaline potassium persulfate oxidation in a heating block at 100 °C and different digestion times are applicable. Chromotropic colour reaction is applied, depending on the typical operating procedure of the small-scale sealed tube used, see Clause 9.
Titre manque — Partie 2: Titre manque
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 23697-2
First edition
2023-02
Water quality — Determination of
total bound nitrogen (ST-TN ) in water
b
using small-scale sealed tubes —
Part 2:
Chromotropic acid colour reaction
Reference number
ISO 23697-2:2023(E)
© ISO 2023
---------------------- Page: 1 ----------------------
ISO 23697-2:2023(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii
© ISO 2023 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 23697-2:2023(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 2
5 Interferences . 2
6 Sampling and sample preparation . 3
7 Reagents . 3
8 Apparatus . 3
9 Oxidation and colour reactions principle . 4
9.1 General . 4
9.2 Chromotropic acid colour reaction. 4
10 Quality control . 5
10.1 V erification of the calibration . 5
10.2 System and interferences checks . 5
11 Calculation . 5
12 Expression of results .6
13 Test report . 6
Annex A (informative) Performance data . 7
Bibliography . 8
iii
© ISO 2023 – All rights reserved
---------------------- Page: 3 ----------------------
ISO 23697-2:2023(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to
the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see
www.iso.org/iso/foreword.html.
This document was prepared by Technical Committee ISO/TC 147, Water quality, Subcommittee SC 2,
Physical, chemical and biochemical methods.
A list of all parts in the ISO 23697 series can be found on the ISO website.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www.iso.org/members.html.
iv
© ISO 2023 – All rights reserved
---------------------- Page: 4 ----------------------
ISO 23697-2:2023(E)
Introduction
Total bound nitrogen (ST-TN ) includes all inorganic forms, nitric nitrogen, nitrous nitrogen,
b
ammoniacal nitrogen and all organic forms of nitrogen in a water sample. Nitrate in particular is one
of the fundamental nutrients of algae, which, in the presence of sufficient quantities of phosphates and
other favourable conditions, determine the eutrophication of water. The main sources of nitrogen are
both natural and anthropogenic. Of the anthropogenic sources, particular importance can be attributed
to domestic wastewater and the use of fertilizers in agriculture. Reduction of nitrogen load is carried
out in domestic and industrial wastewater treatment plants through special denitrification processes.
The presence of significant concentrations of nitrogenous substances in water can indicate pollution
and pose a risk to health and environment.
v
© ISO 2023 – All rights reserved
---------------------- Page: 5 ----------------------
INTERNATIONAL STANDARD ISO 23697-2:2023(E)
Water quality — Determination of total bound nitrogen
(ST-TN ) in water using small-scale sealed tubes —
b
Part 2:
Chromotropic acid colour reaction
WARNING — Persons using this document should be familiar with normal laboratory practice.
This document does not purport to address all of the safety problems, if any, associated with its
use. It is the responsibility of the user to establish appropriate safety and health practices.
IMPORTANT — It is absolutely essential that tests conducted in accordance with this document
be carried out by suitably qualified staff.
1 Scope
This document specifies a method for the determination of total bound nitrogen (ST-TN ) in water of
b
various origins: groundwater, surface water and wastewater, in a measuring range of concentration
generally between 0,5 mg/l and 150 mg/l of ST-TN using the small-scale sealed tube method. Different
b
measuring ranges of small-scale sealed tube methods can be required.
The measuring ranges can vary depending on the type of small-scale sealed tube method of different
manufacturers.
It is up to the user to choose the small-scale sealed tube test with the appropriate application range or
to adapt samples with concentrations exceeding the measuring range of a test by preliminary dilution.
NOTE The results of a small-scale sealed tube test are most precise in the middle of the application range of
the test.
All small-scale sealed tube methods are based on a heated alkaline potassium persulfate oxidation in
a heating block at 100 °C and different digestion times are applicable. Chromotropic colour reaction is
applied, depending on the typical operating procedure of the small-scale sealed tube used, see Clause 9.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 5667-1, Water quality — Sampling — Part 1: Guidance on the design of sampling programmes and
sampling techniques
ISO 5667-3, Water quality — Sampling — Part 3: Preservation and handling of water samples
ISO 5667-10, Water quality — Sampling — Part 10: Guidance on sampling of waste water
ISO 8466-1, Water quality — Calibration and evaluation of analytical methods — Part 1: Linear calibration
function
ISO/IEC 17025, General requirements for the competence of testing and calibration laboratories
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
1
© ISO 2023 – All rights reserved
---------------------- Page: 6 ----------------------
ISO 23697-2:2023(E)
ISO and IEC maintain terminology databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https:// www .iso .org/ obp
— IEC Electropedia: available at https:// www .electropedia .org/
3.1
small-scale sealed tube
glass tube commercially available on the market prefilled by manufacturers with reagent(s) to develop
a colour to be read by a photometer or spectrophotometer
3.2
digestion tube
glass tube used to heat and digest samples in an alkaline solution
Note 1 to entry: This tube is capable to keep temperature and pressure generated by the reagents and by the
heating block.
3.3
sealed tube-total bound nitrogen
ST-TN
b
sum of organically bound and inorganically bound nitrogen present in water or suspended matter
measured under the conditions of this method
4 Principle
The sample to be analysed is heated under specific condition (see Clause 9) in a strongly alkaline
solution with potassium persulfate. Organic and inorganic nitrogen are oxidized to nitrate.
Nitrate ions react in acidic solution with chromotropic acid which is read at maximum absorption by a
photometer or a spectrophotometer.
The met
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.