SIST EN ISO 1683:2015
(Main)Acoustics - Preferred reference values for acoustical and vibratory levels (ISO 1683:2015)
Acoustics - Preferred reference values for acoustical and vibratory levels (ISO 1683:2015)
This International Standard specifies reference values used in acoustics, in order to establish a uniform
basis for the expression of acoustical and vibratory levels.
The reference values are mandatory for use in acoustics for sounds in air and other gases, sounds in
water and other liquids, and for structure-borne sound, but can also be used in other applications.
Akustik - Bevorzugte Bezugswerte für Pegel in der Akustik und Schwingungstechnik (ISO 1683:2015)
Diese Internationale Norm legt Bezugswerte für die Anwendung in der Akustik fest, um eine einheitliche Grundlage für die Angabe von Pegeln in der Akustik und Schwingungstechnik zu schaffen.
Die Bezugswerte sind verpflichtend auf dem Gebiet der Akustik für Schall in Luft und anderen Gasen, in Wasser und anderen Flüssigkeiten sowie für Körperschall; diese dürfen jedoch auch auf anderen Gebieten Anwendung finden.
Acoustique - Valeurs de référence recommandées pour les niveaux acoustiques et vibratoires (ISO 1683:2015)
ISO 1683:2015 spécifie des valeurs de référence utilisées en acoustique, de façon à établir une base uniforme d'expression des niveaux acoustiques et vibratoires.
Ces valeurs de référence sont d'utilisation obligatoire en acoustique pour les sons émis dans l'air et autres gaz, pour ceux émis dans l'eau et autres liquides, et pour les bruits de structure, mais elles peuvent également être utilisées dans d'autres applications.
Akustika - Prednostne referenčne vrednosti akustičnih ravni in ravni vibracij (ISO 1683:2015)
Ta mednarodni standard določa referenčne vrednosti v akustiki za določanje enotne podlage za izražanje akustičnih ravni in ravni vibracij. Uporaba referenčnih vrednosti je obvezna v akustiki za zvoke v zraku in drugih plinih, zvoke v vodi in drugih tekočinah ter za strukturne zvoke, vendar je mogoča tudi na drugih področjih uporabe.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN ISO 1683:2015
01-oktober-2015
1DGRPHãþD
SIST EN ISO 1683:2008
$NXVWLND3UHGQRVWQHUHIHUHQþQHYUHGQRVWLDNXVWLþQLKUDYQLLQUDYQLYLEUDFLM ,62
Acoustics - Preferred reference values for acoustical and vibratory levels (ISO
1683:2015)
Akustik - Bevorzugte Bezugswerte für Pegel in der Akustik und Schwingungstechnik
(ISO 1683:2015)
Acoustique - Valeurs de référence recommandées pour les niveaux acoustiques et
vibratoires (ISO 1683:2015)
Ta slovenski standard je istoveten z: EN ISO 1683:2015
ICS:
17.140.01 $NXVWLþQDPHUMHQMDLQ Acoustic measurements and
EODåHQMHKUXSDQDVSORãQR noise abatement in general
SIST EN ISO 1683:2015 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 1683:2015
---------------------- Page: 2 ----------------------
SIST EN ISO 1683:2015
EUROPEAN STANDARD
EN ISO 1683
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2015
ICS 17.140.01 Supersedes EN ISO 1683:2008
English Version
Acoustics - Preferred reference values for acoustical and
vibratory levels (ISO 1683:2015)
Acoustique - Valeurs de référence recommandées pour les Akustik - Bevorzugte Bezugswerte für Pegel in der Akustik
niveaux acoustiques et vibratoires (ISO 1683:2015) und Schwingungstechnik (ISO 1683:2015)
This European Standard was approved by CEN on 30 April 2015.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2015 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 1683:2015 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN ISO 1683:2015
EN ISO 1683:2015 (E)
Contents Page
Foreword .3
2
---------------------- Page: 4 ----------------------
SIST EN ISO 1683:2015
EN ISO 1683:2015 (E)
Foreword
This document (EN ISO 1683:2015) has been prepared by Technical Committee ISO/TC 43 “Acoustics” in
collaboration with Technical Committee CEN/TC 211 “Acoustics” the secretariat of which is held by DIN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by November 2015, and conflicting national standards shall be withdrawn
at the latest by November 2015.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 1683:2008.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
Endorsement notice
The text of ISO 1683:2015 has been approved by CEN as EN ISO 1683:2015 without any modification.
3
---------------------- Page: 5 ----------------------
SIST EN ISO 1683:2015
---------------------- Page: 6 ----------------------
SIST EN ISO 1683:2015
INTERNATIONAL ISO
STANDARD 1683
Third edition
2015-05-15
Acoustics — Preferred reference values
for acoustical and vibratory levels
Acoustique — Valeurs de référence recommandées pour les niveaux
acoustiques et vibratoires
Reference number
ISO 1683:2015(E)
©
ISO 2015
---------------------- Page: 7 ----------------------
SIST EN ISO 1683:2015
ISO 1683:2015(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved
---------------------- Page: 8 ----------------------
SIST EN ISO 1683:2015
ISO 1683:2015(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Specifications . 2
4.1 Reference values for airborne sound quantities . 2
4.2 Reference values for sound quantities in liquids . 2
4.3 Reference values for vibratory quantities . 3
Bibliography . 4
© ISO 2015 – All rights reserve
...
SLOVENSKI STANDARD
oSIST prEN ISO 1683:2013
01-december-2013
$NXVWLND3UHGQRVWQHUHIHUHQþQHYUHGQRVWLDNXVWLþQLKUDYQLLQUDYQLYLEUDFLM
,62',6
Acoustics - Preferred reference values for acoustical and vibratory levels (ISO/DIS
1683:2013)
Akustik - Bevorzugte Bezugswerte für Pegel in der Akustik und Schwingungstechnik
(ISO/DIS 1683:2013)
Acoustique - Valeurs de référence recommandées pour les niveaux acoustiques et
vibratoires (ISO/DIS 1683:2013)
Ta slovenski standard je istoveten z: prEN ISO 1683 rev
ICS:
17.140.01 $NXVWLþQDPHUMHQMDLQ Acoustic measurements and
EODåHQMHKUXSDQDVSORãQR noise abatement in general
oSIST prEN ISO 1683:2013 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN ISO 1683:2013
---------------------- Page: 2 ----------------------
oSIST prEN ISO 1683:2013
DRAFT INTERNATIONAL STANDARD
ISO/DIS 1683
ISO/TC 43 Secretariat: DS
Voting begins on: Voting terminates on:
2013-10-03 2014-03-03
Acoustics — Preferred reference values for acoustical and
vibratory levels
Acoustique — Valeurs de référence recommandées pour les niveaux acoustiques et vibratoires
[Revision of second edition (ISO 1683:2008)]
ICS: 17.140.01
ISO/CEN PARALLEL PROCESSING
This draft has been developed within the International Organization for
Standardization (ISO), and processed under the ISO lead mode of collaboration
as defined in the Vienna Agreement.
This draft is hereby submitted to the ISO member bodies and to the CEN member
bodies for a parallel five month enquiry.
Should this draft be accepted, a final draft, established on the basis of comments
received, will be submitted to a parallel two-month approval vote in ISO and
THIS DOCUMENT IS A DRAFT CIRCULATED
formal vote in CEN.
FOR COMMENT AND APPROVAL. IT IS
THEREFORE SUBJECT TO CHANGE AND MAY
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
To expedite distribution, this document is circulated as received from the
IN ADDITION TO THEIR EVALUATION AS
committee secretariat. ISO Central Secretariat work of editing and text
BEING ACCEPTABLE FOR INDUSTRIAL,
composition will be undertaken at publication stage.
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO/DIS 1683:2013(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
©
PROVIDE SUPPORTING DOCUMENTATION. ISO 2013
---------------------- Page: 3 ----------------------
oSIST prEN ISO 1683:2013
ISO/DIS 1683:2013(E)
Copyright notice
This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as
permitted under the applicable laws of the user’s country, neither this ISO draft nor any extract
from it may be reproduced, stored in a retrieval system or transmitted in any form or by any means,
electronic, photocopying, recording or otherwise, without prior written permission being secured.
Requests for permission to reproduce should be addressed to either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Reproduction may be subject to royalty payments or a licensing agreement.
Violators may be prosecuted.
ii © ISO 2013 – All rights reserved
---------------------- Page: 4 ----------------------
oSIST prEN ISO 1683:2013
ISO/DIS 1683
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 1683 was prepared by Technical Committee ISO/TC 43, Acoustics.
This third edition cancels and replaces the second edition (ISO 1683:2008), which has been technically
revised.
© ISO 2013 – All rights reserved LLL
---------------------- Page: 5 ----------------------
oSIST prEN ISO 1683:2013
ISO/DIS 1683
Introduction
Various kinds of acoustical and vibratory levels expressed
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.