ASTM D5246-15
(Test Method)Standard Test Method for Isolation and Enumeration of Pseudomonas aeruginosa from Water
Standard Test Method for Isolation and Enumeration of <emph type="ital">Pseudomonas aeruginosa </emph> from Water
SIGNIFICANCE AND USE
5.1 Pseudomonas aeruginosa is an opportunistic pathogen, and has been linked as the causative agent of numerous infections that may be transmitted through a contaminated water supply to a susceptible host.
Note 1: Fecal waste is >95 % E. coli which is found in humans and warm bloodied animals.
5.2 The membrane filtration procedure described is a rapid and reliable test method of detecting P. aeruginosa in water.
SCOPE
1.1 The test method covers the isolation and enumeration of Pseudomonas aeruginosa. Testing was performed on spiked samples using reagent grade water as the diluent from surface waters; recreational waters; ground water, water supplies; especially rural nonchlorinated sources; waste water; and saline waters. The detection limit of this test method is one microorganism per 100 mL.
1.2 This test method was used successfully with reagent water. It is the user's responsibility to ensure the validity of this test method for surface waters, recreational waters, ground water, rural nonchlorinated sources; waste water; and saline waters.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 10.
General Information
Relations
Buy Standard
Standards Content (Sample)
NOTICE: This standard has either been superseded and replaced by a new version or withdrawn.
Contact ASTM International (www.astm.org) for the latest information
Designation: D5246 − 15
Standard Test Method for
Isolation and Enumeration of Pseudomonas aeruginosa from
1
Water
This standard is issued under the fixed designation D5246; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision.Anumber in parentheses indicates the year of last reapproval.A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope D1193Specification for Reagent Water
D2777Practice for Determination of Precision and Bias of
1.1 Thetestmethodcoverstheisolationandenumerationof
Applicable Test Methods of Committee D19 on Water
Pseudomonas aeruginosa. Testing was performed on spiked
D3370Practices for Sampling Water from Flowing Process
samples using reagent grade water as the diluent from surface
Streams
waters; recreational waters; ground water, water supplies;
especially rural nonchlorinated sources; waste water; and
3. Terminology
saline waters. The detection limit of this test method is one
microorganism per 100 mL. 3.1 Definitions:
3.1.1 For definitions of terms used in this standard, refer to
1.2 This test method was used successfully with reagent
Terminology D1129.
water.Itistheuser’sresponsibilitytoensurethevalidityofthis
3.2 Definitions of Terms Specific to This Standard:
test method for surface waters, recreational waters, ground
3.2.1 Pseudomonas aeruginosa, n—an aerobic, motile,
water, rural nonchlorinated sources; waste water; and saline
gram negative rod that produces fluorescent pigments and
waters.
pyocyanin.
1.3 The values stated in SI units are to be regarded as
3.2.1.1 Discussion—It is oxidase and caseinase positive, is
standard. No other units of measurement are included in this
abletogrowat42°C,isrelativelyresistanttomanyantibiotics,
standard.
and may utilize acetamide.
1.4 This standard does not purport to address all of the
3.2.2 refrigeration, n—storage at 2 to 8°C.
safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish appro-
4. Summary of Test Method
priate safety, health, and environmental practices and deter-
4.1 A water sample is passed through a 0.45 mm or
mine the applicability of regulatory limitations prior to use.
equivalent membrane filter. The filter carrying the retained
Specific hazard statements are given in Section 10.
3
organisms is placed on a selective medium (M-PA-C) and is
1.5 This international standard was developed in accor-
incubated at 41.5 6 0.5°C for 72 h. The resulting pink-brown
dance with internationally recognized principles on standard-
to black colonies of Pseudomonas aeruginosa are counted and
ization established in the Decision on Principles for the
reported per 100 mL of the sample. Colonies may be verified
Development of International Standards, Guides and Recom-
on skim milk agar.
mendations issued by the World Trade Organization Technical
Barriers to Trade (TBT) Committee.
5. Significance and Use
2. Referenced Documents
5.1 Pseudomonas aeruginosa is an opportunistic pathogen,
2
and has been linked as the causative agent of numerous
2.1 ASTM Standards:
infections that may be transmitted through a contaminated
D1129Terminology Relating to Water
water supply to a susceptible host.
NOTE 1—Fecal waste is >95 % E. coli which is found in humans and
1
warm bloodied animals.
This test method is under the jurisdiction ofASTM Committee D19 on Water
and is the direct responsibility of Subcommittee D19.24 on Water Microbiology.
5.2 The membrane filtration procedure described is a rapid
Current edition approved June 1, 2015. Published June 2015. Originally
and reliable test method of detecting P. aeruginosa in water.
approved in 1992. Last previous edition approved in 2013 as D5246–13. DOI:
10.1520/D5246-15.
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or
contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM
3
Standards volume information, refer to the standard’s Document Summary page on Available from BBL Microbiological Systems, Division of Becton Dickinson
the ASTM website. and Co., Cockeysville, MD 21030. Other suppliers may be utilized if equivalent.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1
---------------------- Page: 1 ----------------------
D5246 − 15
6. Interferences 7.10.1 Petri dishes, sterile, plastic,9×50mm, with tight-
fitting lids; or 15 × 60 mm, glass or plastic, with loose-fitting
6.1 For certain samples, bacterial cells may have been
lids; or 15 × 100 mm.
exposed to adverse environmental factors that lower their
7.10.2 Membrane filtration units (filter base and funnel),
probability for survival and growth on a membrane filter
glass, plastic or stainless steel, wrapped w
...
This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Because
it may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current version
of the standard as published by ASTM is to be considered the official document.
Designation: D5246 − 13 D5246 − 15
Standard Test Method for
Isolation and Enumeration of Pseudomonas aeruginosa from
1
Water
This standard is issued under the fixed designation D5246; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope
1.1 The test method covers the isolation and enumeration of Pseudomonas aeruginosa. Testing was performed on spiked
samples using reagent grade water samples.as the diluent from surface waters; recreational waters; ground water, water supplies;
especially rural nonchlorinated sources; waste water; and saline waters. The detection limit of this test method is one
microorganism per 100 mL.
1.2 This test method was used successfully with reagent water. It is the user’suser’s responsibility to ensure the validity of this
test method for surface waters, ground waters, recreational waters fresh and marine), wastewaters.recreational waters, ground
water, rural nonchlorinated sources; waste water; and saline waters.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility
of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory
limitations prior to use. Specific hazard statements are given in Section 10.
2. Referenced Documents
2
2.1 ASTM Standards:
D1129 Terminology Relating to Water
D1193 Specification for Reagent Water
D2777 Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
D3370 Practices for Sampling Water from Closed Conduits
3. Terminology
3.1 Definitions:
3.1.1 For definitions of terms used in this test method, standard, refer to Terminology D1129.
3.2 Definitions of Terms Specific to This Standard:
3.2.1 Pseudomonas aeruginosa—aeruginosa, n—an aerobic, motile, gram negative rod that produces fluorescent pigments and
pyocyanin. It is oxidase and caseinase positive, is able to grow at 42°C, is relatively resistant to many antibiotics, and may utilize
acetamide.
1
This test method is under the jurisdiction of ASTM Committee D19 on Water and is the direct responsibility of Subcommittee D19.24 on Water Microbiology.
Current edition approved May 1, 2013June 1, 2015. Published July 2013June 2015. Originally approved in 1992. Last previous edition approved in 20042013 as
D5246 – 92D5246 – 13. (2004). DOI: 10.1520/D5246-13.10.1520/D5246-15.
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards
volume information, refer to the standard’s Document Summary page on the ASTM website.
3.2.1.1 Discussion—
It is oxidase and caseinase positive, is able to grow at 42°C, is relatively resistant to many antibiotics, and may utilize acetamide.
3.2.2 refrigeration—refrigeration, n—storage at 2 to 8°C.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1
---------------------- Page: 1 ----------------------
D5246 − 15
4. Summary of Test Method
4.1 A water sample is passed through a 0.45 mm or equivalent membrane filter. The filter carrying the retained organisms is
3
placed on a selective medium (M-PA-C) and is incubated at 41.5 6 0.5°C for 72 h. The resulting pink-brown to black colonies
of Pseudomonas aeruginosa are counted and reported per 100 mL of the sample. Colonies may be verified on skim milk agar.
5. Significance and Use
5.1 Pseudomonas aeruginosa is an opportunistic pathogen, and has been linked as the causative agent of numerous infections
that may be transmitted through a contaminated water supply to a susceptible host.
NOTE 1—Fecal waste is >95 % E. coli which is found in humans and warm bloodied animals.
5.2 The membrane filtration procedure described is a rapid and reliable test method of detecting P. aeruginosa in water.
6. Interferences
6.1 For certain samples, bacterial cells may have been exposed to adverse environmental factors that lower their probability for
survival and growth on a membrane filter medium. This effect may be pronounced in this test method due to the presence of
antibiotics and the elevated incub
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.