EN 13480-4:2012/A5:2017
(Amendment)Metallic industrial piping - Part 4: Fabrication and installation
Metallic industrial piping - Part 4: Fabrication and installation
This Part of this European standard EN 13480 describes the requirements for fabrication and installation of piping systems, including supports, designed in accordance with EN 13480-3.
Metallische industrielle Rohrleitungen - Teil 4: Fertigung und Verlegung
Tuyauteries industrielles métalliques - Partie 4 : Fabrication et installation
Kovinski industrijski cevovodi - 4. del: Proizvodnja in vgradnja - Dopolnilo A5
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-januar-2018
1DGRPHãþD
SIST EN 13480-4:2012
Kovinski industrijski cevovodi - 4. del: Proizvodnja in vgradnja - Dopolnilo A5
Metallic industrial piping - Part 4: Fabrication and installation
Metallische industrielle Rohrleitungen - Teil 4: Fertigung und Verlegung
Tuyauteries industrielles métalliques - Partie 4: Fabrication et installation
Ta slovenski standard je istoveten z: EN 13480-4:2012/A5:2017
ICS:
77.140.75 Jeklene cevi in cevni profili Steel pipes and tubes for
za posebne namene specific use
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EN 13480-4:2012/A5
EUROPEAN STANDARD
NORME EUROPÉENNE
June 2017
EUROPÄISCHE NORM
ICS 23.040.01
English Version
Metallic industrial piping - Part 4: Fabrication and
installation
Tuyauteries industrielles métalliques - Partie 4 : Metallische industrielle Rohrleitungen - Teil 4:
Fabrication et installation Fertigung und Verlegung
This amendment A5 modifies the European Standard EN 13480-4:2012; it was approved by CEN on 6 April 2017.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of
this amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2017 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 13480-4:2012/A5:2017 E
worldwide for CEN national Members.
Contents Page
European foreword .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.