Natural gas - Extended analysis - Gas-chromatographic method (ISO 6975:1997)

describes the method of test to determine the stability of transmission performance of a finished cable used in analogue and digital communication systems when submitted to temperature changes which may occur during use, storage or transportation.

Erdgas - Erweiterte Analyse - Gaschromatographisches Verfahren (ISO 6975:1997)

Diese Internationale Norm beschreibt die Anforderungen für die quantitative Analyse der folgenden Erdgaskomponenten:
Helium
Wasserstoff
Argon
Sauerstoff
Stickstoff
Kohlenstoffdioxid
gesättigte Kohlenwasserstoffe von C1 bis C5
Kohlenwasserstofffraktionen ab C6 aufwärts
aromatische Verbindungen wie Benzol und Toluol.
Die gaschromatographischen Verfahren bestimmen diese Komponenten in den folgenden Gehaltsbereichen:
Sauerstoff:   0,001 % (n/n)   bis   0,5 % (n/n)
Helium:   0,001 % (n/n)   bis   0,5 % (n/n)
Wasserstoff:   0,001 % (n/n)   bis   0,5 % (n/n)
Argon:   0,001 % (n/n)   bis   0,5 % (n/n)
Stickstoff:   0,001 % (n/n)   bis   40 % (n/n)
Kohlenstoffdioxid:   0,001 % (n/n)   bis   40 % (n/n)
Methan:   0,001 % (n/n)   bis   100 % (n/n)
Ethan:   0,02 % (n/n)   bis   15 % (n/n)
Propan:   0,001 % (n/n)   bis   5 % (n/n)
höhere Kohlenwasserstoffe:   Das Verfahren kann Kohlenwasserstoffkomponenten ab einer Konzentration von 10-6 (n/n) bis zur jeweiligen Maximalkonzentration messen, was mit der Anforderung in Einklang steht, dass das Gas bei beliebigem Druck im Bereich zwischen 1 ´ 10² kPa und 7 ´ 10³ kPa frei von Kohlenwasserstoffkondensaten ist.
Dieses Verfahren ist nicht dazu ausgelegt, Sauerstoff- (Wasserdampf, Methanol, Glykole) und Schwefelverbindungen zu bestimmen.
Die Möglichkeit zur eindeutigen Identifizierung von Kohlenwasserstoffen oberhalb C6 ist nicht gegeben. Selbst wenn durch das "Spiking" eines Gases mit bekannten Komponenten aufgezeigt werden kann, an welcher Stelle deren Elution stattfindet, kann nicht mit Sicherheit behauptet werden, dass diese Komponente die einzige mit der jeweils in Rede stehenden Retentionszeit ist. Nicht identifizierte Komponenten werden entsprechend jener Kohlenstoffzahl klassifiziert, die aufgrund der Analyse als angemessen anzusehen ist. Dies stellt zwar eine notwendige Vereinfachung dar, erlaubt jedoch die Gewinnung vernünftiger quantitativer Werte.
Dieses Verfahren ist für den Einsatz in Fällen vorgesehen, in denen eine Analyse der Hexane und höheren Kohlenwa

Gaz naturel - Analyse étendue - Méthode par chromatographie en phase gazeuse (ISO 6975:1997)

La présente Norme internationale fixe les spécifications relatives à l'analyse quantitative des constituants suivants du gaz naturel:
  hélium
  hydrogène
  argon
  oxygène
  azote
  dioxyde de carbone
  hydrocarbures saturés de C1 à C5
  fractions d'hydrocarbures, C6 et supérieurs
  composés aromatiques tels que le benzène et le toluène
Les méthodes de chromatographie en phase gazeuse permettent de déterminer
  les constituants dans les gammes suivantes:
  oxygène: 0,001 % (n/n) à 0,5 % (n/n)
  hélium: 0,001 % (n/n) à 0,5 % (n/n)
  hydrogène: 0,001 % (n/n) à 0,5 % (n/n)
  argon: 0,001 % (n/n) à 0,5 % (n/n)
  azote: 0,001 % (n/n) à 40 % (n/n)
  dioxyde de carbone: 0,001 % (n/n) à 40 % (n/n)
  méthane: 50 % (n/n) à 100 % (n/n)
  éthane: 0,02 % (n/n) à 15 % (n/n)
  propane: 0,001 % (n/n) à 5 % (n/n)
  hydrocarbures supérieurs: la méthode peut mesurer les constituants
    depuis 10-6 (n/n) jusqu'à leur concentration maximale compatible
    avec la prescription selon laquelle le gaz ne doit contenir aucun condensat
    d'hydrocarbure, à n'importe quelle pression, dans la gamme 1 x 102
    kPa à 7 x 103 kPa.
Cette méthode n'est pas destinée à identifier les composés
oxygénés (la vapeur d'eau, le méthanol, les glycols) et les
composés sulfurés. Il est impossible que l'identification des hydrocarbures
supérieurs à C6 soit ambiguë. Même lorsqu'un
pic indique le point d'élution des constituants connus d'un mélange
gazeux, on ne peut pas établir avec certitude que ce constituant est le
seul qui présente ce temps de rétention. Les constituants non identifiés
sont classés selon l'indice de carbone qui est apparu approprié
suite à l'analyse. Bien que cette simplification soit nécessaire,
elle permet d'obtenir une valeur quantitative convenable. Cette méthode
est à utiliser lorsqu'on désire analyser la composition des hexanes+
et/ou effectuer une analyse
complète.
La méthode n'est pas destinée à des gaz en phase dense dont
la pression dépasse le cricondebar (pression de condensation critique)
ou, pour des échantillons de gaz ne contenant aucun condensat d'hydrocarbures
en quantité mesurable, de l'eau à I'état liquide ou de fluide
de traitement comme le méthanol ou les glycols (voir ISO 6570-1 et ISO
10715).
II est peu vraisemblable que les gaz traités en vue de leur transport contiennent
une proportion décelable d'hydrocarbures supérieurs à C12.
Les échantillons prélevés plus près de la tête
de puits peuvent contenir, avant leur passage par l'usine de traitement, des hydrocarbures
allant jusqu'a cl6 ou au-delà.

Zemeljski plin – Širše analize – Plinsko-kromatografska metoda (ISO 6975:1997)

General Information

Status
Published
Publication Date
10-May-2005
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
11-May-2005
Due Date
16-Dec-2004
Completion Date
11-May-2005

Buy Standard

Standard
EN ISO 6975:2005
English language
26 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 6975:2005
01-julij-2005
Zemeljski plin – Širše analize – Plinsko-kromatografska metoda (ISO 6975:1997)
Natural gas - Extended analysis - Gas-chromatographic method (ISO 6975:1997)
Erdgas - Erweiterte Analyse - Gaschromatographisches Verfahren (ISO 6975:1997)
Gaz naturel - Analyse étendue - Méthode par chromatographie en phase gazeuse (ISO
6975:1997)
Ta slovenski standard je istoveten z: EN ISO 6975:2005
ICS:
75.060 Zemeljski plin Natural gas
SIST EN ISO 6975:2005 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 6975:2005

---------------------- Page: 2 ----------------------

SIST EN ISO 6975:2005
EUROPEAN STANDARD
EN ISO 6975
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2005
ICS 75.060
English version
Natural gas - Extended analysis - Gas-chromatographic method
(ISO 6975:1997)
Gaz naturel - Analyse étendue - Méthode par Erdgas - Erweiterte Analyse - Gaschromatographisches
chromatographie en phase gazeuse (ISO 6975:1997) Verfahren (ISO 6975:1997)
This European Standard was approved by CEN on 17 April 2005.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 6975:2005: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 6975:2005
EN ISO 6975:2005 (E)






Foreword



The text of ISO 6975:1997 has been prepared by Technical Committee ISO/TC 193 "Natural
gas” of the International Organization for Standardization (ISO) and has been taken over as EN
ISO 6975:2005 by CMC.

This European Standard shall be given the status of a national standard, either by publication of
an identical text or by endorsement, at the latest by November 2005, and conflicting national
standards shall be withdrawn at the latest by November 2005.

According to the CEN/CENELEC Internal Regulations, the national standards organizations of
the following countries are bound to implement this European Standard: Austria, Belgium,
Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary,
Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.



Endorsement notice

The text of ISO 6975:1997 has been approved by CEN as EN ISO 6975:2005 without any
modifications.

2

---------------------- Page: 4 ----------------------

SIST EN ISO 6975:2005
INTERNATIONAL
STANDARD
Second edition
1997-04-O 1
- Extended analysis -
Natural gas
Gas-chromatographic method
M&hode par chromatographie
Gaz nature/ - Analyse &endue -
en phase gazeuse
Reference number
IS0 69759 997(E)

---------------------- Page: 5 ----------------------

SIST EN ISO 6975:2005
IS0 6975:1997(E)
Page
Contents
1
..........................................................................................
1 Scope
2
.................................................................
2 Normative references
3
..................................................................................
3 Definitions
4
......................................................................................
4 Principle
......................................... 5
5 Analysis and analytical requirements
7
.................................................................................
6 Procedures
8
.....................................................
7 Calibration and control charts
11
................................................................................
8 Calculations
13
.....................................................................................
9 Precision
14
10 Test report .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.