EN 50090-5-3:2006
(Main)Home and Building Electronic Systems (HBES) - Part 5-3: Media and media dependent layers - Radio frequency
Home and Building Electronic Systems (HBES) - Part 5-3: Media and media dependent layers - Radio frequency
This European Standard defines the mandatory and optional requirements for the medium specific Physical and Data Link Layer of Radio Frequency for HBES products and systems, a multi-application bus system where the functions are decentralised, distributed and linked through a common communication process. This European Standard is used as a product family standard. It is not intended to be used as a stand-alone standard. Data Link Layer interface and general definitions, which are medium independent, are given in EN 50090 4 1.
Elektrische Systemtechnik für Heim und Gebäude (ESHG) - Teil 5-3: Medien und medienabhängige Schichten - Signalübertragung über Funk
Systèmes électroniques pour les foyers domestiques et les bâtiments (HBES) - Partie 5-3: Medias et couches dépendantes des medias - Radio fréquence
Stanovanjski in stavbni elektronski sistemi (HBES) – 5-3. del: Mediji in nivoji, odvisni od medijev – Radijske frekvence
Ta Evropski standard označuje obvezne in neobvezne zahteve za srednje specifične, fizične in podatkovno povezane nivoje radijske frekvence za HBES-produkte in sisteme. Bus-sistem, kjer so funkcije decentralizirane, razdeljene in povezane z navadnim komunikacijskim procesom, je večuporabni. Ta Evropski standard se uporablja kot družinski. Ni mišljen za uporabo kot samostojni. Raven podatkovno povezanega nivoja in osnovne definicije, ki so neodvisne, so navedene v EN 50090-4-1.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-maj-2007
Stanovanjski in stavbni elektronski sistemi (HBES) – 5-3. del: Mediji in nivoji,
odvisni od medijev – Radijske frekvence
Home and Building Electronic Systems (HBES) -- Part 5-3: Media and media dependent
layers - Radio frequency
Elektrische Systemtechnik für Heim und Gebäude (ESHG) Teil 5-3: Medien und
medienabhängige Schichten - Signalübertragung über Funk
Systemes électroniques pour les foyers domestiques et les bâtiments (HBES) Partie 5-3:
Medias et couches dépendantes des medias - Radio fréquence
Ta slovenski standard je istoveten z: EN 50090-5-3:2006
ICS:
97.120 Avtomatske krmilne naprave Automatic controls for
za dom household use
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN 50090-5-3
NORME EUROPÉENNE
October 2006
EUROPÄISCHE NORM
ICS 97.120
English version
Home and Building Electronic Systems (HBES)
Part 5-3: Media and media dependent layers -
Radio frequency
Systèmes électroniques pour les foyers Elektrische Systemtechnik
domestiques et les bâtiments (HBES) für Heim und Gebäude (ESHG)
Partie 5-3: Medias et couches Teil 5-3: Medien und medienabhängige
dépendantes des medias - Schichten -
Radio fréquence Signalübertragung über Funk
This European Standard was approved by CENELEC on 2006-10-01. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Cyprus, the Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2006 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 50090-5-3:2006 E
Foreword
This European Standard was prepared by the Technical Committee CENELEC TC 205, Home and Building
Electronic Systems (HBES) joined by the co-operating partner Konnex Association.
The text of the draft was submitted to the Unique Acceptance Procedure (UAP) and was approved by
CENELEC as EN 50090-5-3 on 2006-10-01.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2007-10-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2009-10-01
CENELEC takes no position concerning the evidence, validity and scope of patent rights.
Konnex Association as Cooperating Partner to CENELEC confirms that to the extent that the standard
contains patents and like rights, the Konnex Association's members are willing to negotiate licenses thereof
with applicants throughout the world on fair, reasonable and non-discriminatory terms and conditions.
Konnex Association Tel.: + 32 2 775 85 90
Neerveldstraat, 105 Fax.: + 32 2 675 50 28
Twin House e-mail: info@konnex.org
B - 1200 Brussels www.konnex.org
Attention is drawn to the possibility that some of the elements of this standard may be the subject of patent
rights other than those identified above. CENELEC shall not be held responsible for identifying any or all
such patent rights.
EN 50090-5-3 is part of the EN 50090 series of European Standards, which will comprise the following
parts:
Part 1: Standardization structure
Part 2: System overview
Part 3: Aspects of application
Part 4: Transport layer and network layer
Part 5: Media and media dependent layers
Part 6: Interfaces
Part 7: Management
Part 8: Conformity assessment of products
Part 9: Installation requirements
__________
- 3 - EN 50090-5-3:2006
Contents
Introduction.5
1 Scope.5
2 Normative references.5
3 Terms, definitions and abbreviations.5
3.1 Terms and definitions.5
3.2 Abbreviations.5
4 Physical Layer Type RF .6
4.1 General.6
4.1.1 Frame structure related.6
5 Data Link Layer Type RF .7
5.1 Differences to existing (bi-directional) HBES protocol .7
5.1.1 Extended Group Address .7
5.1.2 Predefined Extended Group Addresses for transmit-only devices.7
5.1.3 RF Domain Address.8
5.1.4 RF Broadcast and RF System Broadcast.8
5.2 Data Link Layer Frame.8
5.2.1 General .8
5.2.2 Structure .8
5.2.3 Bit and octet order.9
5.2.4 First block.9
5.2.5 Second block .10
5.3 Medium access .10
5.3.1 Medium access times .11
5.4 Data Link Layer protocol .11
5.4.1 RF Repeat Counter for end devices .11
5.4.2 AddrExtensionType.11
5.4.3 Duplication prevention .11
5.5 The Layer-2 of an RF Retransmitter .12
5.5.1 History List .12
5.5.2 RF Repeat Counter.12
5.5.3 Filtering .13
5.5.4 Retransmitter Flowchart.13
5.6 The Layer-2 of an RF-TP Media Coupler.13
5.6.1 Introduction .13
5.6.2 Automatic translation .15
5.6.3 Configuration by a tool.21
5.6.4 Translation between standard and extended frames and RF frames .22
Figure 1 - Overview of the link layer frame.8
Figure 2 - Structure of the first block .9
Figure 3 - Structure of the second block.10
Figure 4 - Flowchart of the Data Link Layer and Network Layer of the retransmitter .13
Figure 5 - Logical Interpretation of Extended Group Address in automatic translation.14
Figure 6 - Coupling a HBES TP and RF system .15
Figure 7 - Automatic translation principle from RF to TP of the source Individual Address.16
Figure 8 - Example for the automatic conversion of the source individual address from RF to TP .16
Figure 9 - Automatic translation principle from RF to TP of the Group Address.17
Figure 10 - Example for the automatic conversion of the group address from RF to TP.17
Figure 11 - Automatic translation principle from TP to RF of the Group Address.18
Figure 12 - Example for the automatic conversion of the group address from TP to RF.18
Figure 13 - Automatic translation principle from TP to RF in case the Group Address is not in the
range of RF Group Addresses Exxx.19
Figure 14 - Example for the automatic conversion of the group address from TP to RF (when not in
the range of Exxxh).19
Figure 15 - Automatic translation principle form TP to RF for Destination Individual Addresses.20
Figure 16 - Example for the automatic conversion of the destination individual address from TP to RF .20
Figure 18 - Example for the automatic conversion of the destination individual address from TP to RF
(if destination individual address not equal to coupler's subnetwork address) .21
Table 1 - General requirements for Physical Layer Type RF.6
Table 2 - Frame definition.6
Table 3 - Coding of the RF info field.9
Table 4 - Significance of fields of second block .10
Table 5 - Medium access time.11
- 5 - EN 50090-5-3:2006
Introduction
According to the OSI reference model, the Physical Layer consists of the medium, the cable, the connectors,
the transmission technology, etc. which refers to the hardware requirements. However, the focus of this
European Standard lies first and foremost on the description of the “communication medium”.
1 Scope
This European Standard defines the mandatory and optional requirements for the medium specific Physical
and Data Link Layer of Radio Frequency for HBES products and systems, a multi-application bus system
where the functions are decentralised, distributed and linked through a common communication process.
This European Standard is used as a product family standard. It is not intended to be used as a stand-alone
standard.
Data Link Layer interface and general definitions, which are medium independent, are given in
EN 50090-4-1.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
1)
EN 50090-1 - Home and Building Electronic Systems (HBES)
Part 1: Standardization structure
EN 300 220-1 2000 ElectroMagnetic Compatibility and Radio Spectrum Matters (ERM); Short
Range Devices (SRD);Radio equipment to be used in the 25 MHz to
1 000 MHz frequency range
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.