EN 61300-3-29:2006

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-29: Examinations and measurements - Measurement techniques for characterizing the amplitude of the spectral transfer function of DWDM components

This part of IEC 61300 identifies two basic measurement methods for characterising the spectral transfer functions of DWDM filter components. The transfer functions can be used to produce measurements of attenuation (A), polarisation dependent loss (PDL), isolation, centre wavelength and bandwidth (BW).

Lichtwellenleiter - Verbindungselemente und passive Bauteile - Grundlegende Prüf- und Messverfahren - Teil 3-29: Untersuchungen und Messungen - Messverfahren zur Charakterisierung der spektralen Übertragungsfunktion von DWDM-Bauteilen

Dispositifs d'interconnexion et composants passifs à fibres optiques - Méthodes fondamentales d'essais et de mesures - Partie 3-29: Examens et mesures - Techniques de mesure pour caractériser l'amplitude de la fonction de transfert spectrale des composants DWDM

La présente partie de la CEI 61300 a pour objet d'identifier deux méthodes fondamentales de mesure pour caractériser les fonctions de transfert spectrales des composants à filtre DWDM (dense wavelength division multiplexing, multiplexage par répartition en longueur d'onde à forte densité). Les fonctions de transfert peuvent être utilisées pour produire des mesures d'affaiblissement (A), de perte dépendant de la polarisation (PDL, polarisation dependent loss), d'isolation, de longueur d'onde centrale et de largeur de bande (BW, bandwidth).

Naprave za medsebojno povezovanje optičnih vlaken in pasivne komponente – Osnovni preskusni in merilni postopki – 3-29. del: Preiskave in meritve – Merilne tehnike za ugotavljanje lastnosti amplitude spektralne prenosne funkcije komponent DWDM (IEC 61300-3-29:2005)

General Information

• Status: Withdrawn
• Publication Date: 09-Mar-2006
• Withdrawal Date: 28-Feb-2009
• ICS: 33.180.20 - Fibre optic interconnecting devices
• Technical Committee: CLC/TC 86BXA - Fibre optic interconnect, passive and connectorised components
• Drafting Committee: IEC/SC 86B - IEC_SC_86B
• Parallel Committee: IEC/SC 86B - IEC_SC_86B
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Start Date: 23-Apr-2015
• Completion Date: 23-Apr-2015
• Ref Project: SIST EN 61300-3-29:2006 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures -- Part 3-29: Examinations and measurements - Measurement techniques for characterizing the amplitude of the spectral transfer function of DWDM components

Relations

• Replaced By: EN 61300-3-29:2014 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-29: Examinations and measurements - Spectral transfer characteristics of DWDM devices
• Effective Date: 29-Jan-2023

Standards Content (Sample)

SLOVENSKI SIST EN 61300-3-29:2006

STANDARD
julij 2006
Naprave za medsebojno povezovanje optičnih vlaken in pasivne komponente
– Osnovni preskusni in merilni postopki – 3-29. del: Preiskave in meritve –
Merilne tehnike za ugotavljanje lastnosti amplitude spektralne prenosne
funkcije komponent DWDM (IEC 61300-3-29:2005)
Fibre optic interconnecting devices and passive components – Basic test and
measurement procedures – Part 3-29: Examinations and measurements –
Measurement techniques for characterizing the amplitude of the spectral transfer
function of DWDM components (IEC 61300-3-29:2005)
ICS 33.180.20 Referenčna številka
SIST EN 61300-3-29:2006(en)
©  Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno

---------------------- Page: 1 ----------------------

EUROPEAN STANDARD
EN 61300-3-29

NORME EUROPÉENNE
March 2006
EUROPÄISCHE NORM

ICS 33.180.20


English version


Fibre optic interconnecting devices and passive components -
Basic test and measurement procedures
Part 3-29: Examinations and measurements -
Measurement techniques for characterizing the amplitude
of the spectral transfer function of DWDM components
(IEC 61300-3-29:2005)

Dispositifs d'interconnexion  Lichtwellenleiter -
et composants passifs à fibres optiques - Verbindungselemente
Méthodes fondamentales und passive Bauteile -
d'essais et de mesures Grundlegende Prüf- und Messverfahren
Partie 3-29: Examens et mesures - Teil 3-29: Untersuchungen
Techniques de mesure pour caractériser und Messungen -
l'amplitude de la fonction de transfert Messverfahren zur Charakterisierung
spectrale des composants DWDM der spektralen Übertragungsfunktion
(CEI 61300-3-29:2005) von DWDM-Bauteilen
(IEC 61300-3-29:2005)

This European Standard was approved by CENELEC on 2006-03-01. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Cyprus, the Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Central Secretariat: rue de Stassart 35, B - 1050 Brussels


© 2006 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61300-3-29:2006 E

---------------------- Page: 2 ----------------------

EN 61300-3-29:2006 - 2 -
Foreword
The text of document 86B/2216/FDIS, future edition 1 of IEC 61300-3-29, prepared by SC 86B, Fibre
optic interconnecting devices and passive components, of IEC TC 86, Fibre optics, was submitted to the
IEC-CENELEC parallel vote and was approved by CENELEC as EN 61300-3-29 on 2006-03-01.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2006-12-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2009-03-01
This European Standard makes reference to International Standards. Where the International Standard
referred to has been endorsed as a European Standard or a home-grown European Standard exists, this
European Standard shall be applied instead. Pertinent information can be found on the CENELEC web
site.
__________
Endorsement notice
The text of the International Standard IEC 61300-3-29:2005 was approved by CENELEC as a European
Standard without any modification.
__________

---------------------- Page: 3 ----------------------

NORME CEI
INTERNATIONALE
IEC



61300-3-29
INTERNATIONAL


Première édition
STANDARD

First edition

2005-12



Dispositifs d'interconnexion et
composants passifs à fibres optiques –
Méthodes fondamentales d'essais
et de mesures –
Partie 3-29:
Examens et mesures –
Techniques de mesure pour caractériser
l'amplitude de la fonction de transfert
spectrale des composants DWDM

Fibre optic interconnecting devices
and
...