iTeh StandardsiTeh Standards
EURUSD
Your shopping cart is empty.
CLC

HD 384.4.47 S2:1995

(Main)

Electrical installations of buildings - Part 4: Protection for safety - Chapter 47: Application of protective measures for safety - Section 470: General - Section 471: Measures of protection against electric shock

Electrical installations of buildings - Part 4: Protection for safety - Chapter 47: Application of protective measures for safety - Section 470: General - Section 471: Measures of protection against electric shock

Applies in every installation, part of an installation, and to equipment. Describes the measures of protection against electric shock, in normal service and in the case of a fault.

Elektrische Anlagen von Gebäuden - Teil 4: Schutzmaßnahmen - Kapitel 47: Anwendung der Schutzmaßnahmen - Hauptabschnitt 470: Allgemeines - Hauptabschnitt 471: Anwendung der Maßnahmen zum Schutz gegen elektrischen Schlag

Installations électriques des bâtiments - Partie 4: Protection pour assurer la sécurité - Chapitre 47: Application des mesures de protection pour assurer la sécurité - Section 470: Généralités - Section 471: Mesures de protection contre les chocs électriques

S'applique dans toute installation, partie d'installation et aux matériels. Décrit les mesures de protection contre les chocs électriques, en service normal et en cas de défaut.

Električne inštalacije zgradb – 4. del: Zaščitni ukrepi – 47. poglavje: Uporaba zaščitnih ukrepov – 470. oddelek: Splošno – 471. oddelek: Ukrepi zaščite pred električnim udarom (IEC 60364-4-47:1981 + A1:1993, spremenjen)

General Information

Status
Withdrawn
Publication Date
17-Aug-1995
ICS
91.140.50 - Electricity supply systems
Technical Committee
CLC/TC 64 - Electrical installations and protection against electric shock
Drafting Committee
IEC/TC 64 - IEC_TC_64
Parallel Committee
IEC/TC 64 - IEC_TC_64
Current Stage
9960 - Withdrawal effective - Withdrawal
Start Date
01-Feb-2009
Completion Date
01-Feb-2009
Ref Project
SIST HD 384.4.47 S2:2000 - Electrical installations of buildings -- Part 4: Protection for safety -- Chapter 47: Application of protective measures for safety - Section 470: General - Section 471: Measures of protection against electric shock

Relations

Replaced By
HD 60364-4-41:2007 - Low-voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
Effective Date
28-Jan-2023

Buy Standard

HD 384.4.47 S2:2000HD 384.4.47 S2:2000
PreviousNext
Standardization document
HD 384.4.47 S2:2000
English language
11 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST HD 384.4.47 S2:2000
01-februar-2000
(OHNWULþQHLQãWDODFLMH]JUDGE±GHO=DãþLWQLXNUHSL±SRJODYMH8SRUDED
]DãþLWQLKXNUHSRY±RGGHOHN6SORãQR±RGGHOHN8NUHSL]DãþLWHSUHG
HOHNWULþQLPXGDURP ,(&$VSUHPHQMHQ
Electrical installations of buildings -- Part 4: Protection for safety -- Chapter 47:
Application of protective measures for safety - Section 470: General - Section 471:
Measures of protection against electric shock
Elektrische Anlagen von Gebäuden -- Teil 4: Schutzmaßnahmen -- Kapitel 47:
Anwendung der Schutzmaßnahmen - Hauptabschnitt 470: Allgemeines - Hauptabschnitt
471: Anwendung der Maßnahmen zum Schutz gegen elektrischen Schlag
Installations électriques des bâtiments -- Partie 4: Protection pour assurer la sécurité --
Chapitre 47: Application des mesures de protection pour assurer la sécurité - Section
470: Généralités - Section 471: Mesures de protection contre les chocs électriques
Ta slovenski standard je istoveten z: HD 384.4.47 S2:1995
ICS:
29.120.50 9DURYDONHLQGUXJD Fuses and other overcurrent
PHGWRNRYQD]DãþLWD protection devices
91.140.50 Sistemi za oskrbo z elektriko Electricity supply systems
S
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.

This May Also Interest You

CLC
HD 60364-5-54:2011/A1:2022(Amendment)
Low-voltage electrical installations - Part 5-54: Selection and erection of electrical equipment - Earthing arrangements and protective conductors
SIST HD 60364-5-54:2011/A1:2023

IEC 60364-5-54:2011 addresses the earthing arrangements and protective conductors including protective bonding conductors in order to satisfy the safety of the electrical installation. This third edition cancels and replaces the second edition, published in 2002, and constitutes a technical revision. The main changes with respect to the previous edition are listed below: - clarification of the definition of protective conductor; - improved specification of mechanical characteristics of the earth electrode; - introduction of earth electrode for protection against electric shock and lighting protection; - annexes describing concrete-embedded foundation earth electrodes and soil-embedded earth electrode. IEC 60364-5-54:2011 has the status of a basic safety publication in accordance with IEC Guide 104. This document also includes requirements regarding earthing and equipotential bonding for information and communication technology (ICT) with the aim of: - reducing the risk of electrical hazards for correct operation of these devices and the information and communication technology wiring; - providing the telecommunication systems with a reliable signal reference plane that can improve resistance to electromagnetic interference (EMI) by reference to ISO/IEC 30129. NOTE Examples of information and communication technology (ICT) include: - DC supply networks (and systems) for supplying power to ICT equipment within a building; - star-shaped private automatic branch exchanges (PABX) or their equipment; - local area (communication) networks (LANs); - fire and intruder alarms communication systems; - building automation systems, e.g. direct digital control systems; - systems for computer-aided manufacturing (CAM) and other computer-aided services; - broadcast and communication technology.

  • Amendment
    4 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-5-52:2011/A12:2022(Amendment)
Low-voltage electrical installations - Part 5-52: Selection and erection of electrical equipment - Wiring systems
SIST HD 60364-5-52:2011/A12:2023

IEC 60364-5-52:2009 deals with the selection and erection of wiring systems. This third edition cancels and replaces the second edition, published in 2001, and constitutes a technical revision. The main changes with respect to the previous edition are as follows: - Subclause 521.4 introduces minor changes with regard to busbar trunking systems and powertrack systems. - Subclause 523.6 introduces minor changes with regard to the sizing of cables where harmonic currents are present. - A new sublause 523.9 concerning single-core cables with a metallic covering has been introduced. - Clause 525 introduces changes in the maximum value of voltage drop permitted between the origin of the consumer's installation and the equipment which should not be greater than that given in the relevant annex. - Clause 526 introduces minor changes to electrical connections including additional exceptions for inspection of connections and additional notes. - Clause 528 introduces additional requirements with regard to proximity of underground power and telecommunication cables. - Clause 529 introduces minor changes to selection and erection of wiring systems in relation to maintainability, including cleaning.

  • Amendment
    20 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-5-53:2022/AC:2022-08(Corrigendum)
Low-voltage electrical installations - Part 5-53: Selection and erection of electrical equipment - Switchgear and controlgear
SIST HD 60364-5-53:2022/AC:2022

CCMC - Correction of ToC, clause numbering
TC - Correction of Figure 534.1

  • Corrigendum
    2 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-5-53:2022(Main)
Low-voltage electrical installations - Part 5-53: Selection and erection of electrical equipment - Switchgear and controlgear
SIST HD 60364-5-53:2022

2020-10-09: document blockeddue to technical changes. waiting for bt decision to resolve

  • Standardization document
    94 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-4-42:2011/A11:2021(Amendment)
Low voltage electrical installations - Part 4-42: Protection for safety - Protection against thermal effects
SIST HD 60364-4-42:2011/A11:2022

NEXT ACTION: TC action by 2021-11-01
2021-06-24 MDC: Document on hold awaiting BT approval of A-deviations
2019-10-01: upcoming CLC/TC 64 request to CLC/BT to proceed with a second formal vote.

  • Amendment
    9 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-8-2:2018/A12:2021(Amendment)
Low-voltage electrical installations - Part 8-2: Prosumer's low-voltage electrical installations
SIST HD 60364-8-2:2019/A12:2021

No scope available

  • Amendment
    3 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-7-706:2007/A1:2020(Amendment)
Low-voltage electrical installations - Part 7-706: Requirements for special installations or locations - Conducting locations with restricted movement
SIST HD 60364-7-706:2007/A1:2021

The particular requirements of this part apply to fixed equipment in conducting locations where movement of persons is restricted by the location, and to supplies for portable equipment for use in such locations. A conducting location with restricted movement is comprised mainly of metallic or other conductive surrounding parts, within which it is likely that a person will come in contact through a substantial portion of his body with the metallic or other conductive surrounding parts and where the possibility of interrupting this contact is limited.

  • Amendment
    11 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-4-41:2017/A12:2019(Amendment)
Low-voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
SIST HD 60364-4-41:2017/A12:2019

ISO/TR 22411:2008 presents ergonomics data and guidelines for applying ISO/IEC Guide 71 in addressing the needs of older persons and persons with disabilities in standards development. It provides ergonomics data and knowledge about human abilities - sensory, physical and cognitive - and allergies, as well as guidance on the accessible design of products, services and environments.

  • Addendum – translation
    4 pages
    Slovenian language
    sale 10% off
    e-Library read for
    1 day
  • Amendment
    3 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-8-2:2018/A11:2019(Amendment)
Low-voltage electrical installations - Part 8-2: Prosumer's low-voltage electrical installations
SIST HD 60364-8-2:2019/A11:2019

D163/C014: NO SNC approved by BT on 2019-06-12.
CMs to 59032

  • Amendment
    5 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 60364-8-1:2019(Main)
Low-voltage electrical installations - Part 8-1: Functional aspects - Energy efficiency
SIST HD 60364-8-1:2019

IEC 60364-8-1:2019(E) provides additional requirements, measures and recommendations for the design, erection and verification of all types of low-voltage electrical installation including local production and storage of energy for optimizing the overall efficient use of electricity. It introduces requirements and recommendations for the design of an electrical installation within the framework of an energy efficiency management approach in order to get the best permanent functionally equivalent service for the lowest electrical energy consumption and the most acceptable energy availability and economic balance. These requirements and recommendations apply, within the scope of the IEC 60364 series, for new installations and modification of existing installations. This standard is applicable to the electrical installation of a building or system and does not apply to products. The energy efficiency of these products and their operational requirements are covered by the relevant product standards. This standard does not specifically address building automation systems. This edition includes the following significant technical changes with respect to the previous edition: a) revision of Annex B; b) revision of 4.2: Energy efficiency assessment for electrical installations; c) update of 8.3: Input from loads, sensors and forecasts; d) introduction of new definitions. This group energy efficiency publication is primarily intended to be used as an energy efficiency standard for the low voltage electrical installations mentioned in Clause 1, but is also intended to be used by technical committees in the preparation of standards, in accordance with the principles laid down in IEC Guide 119 and IEC Guide 118. The contents of the corrigendum of May 2019 have been included in this copy.

  • Standardization document
    75 pages
    English language
    sale 10% off
    e-Library read for
    1 day