IEC 62868-1:2020/AMD1:2025
(Amendment)Amendment 1 - Organic light emitting diode (OLED) Light sources for general lighting - Safety - Part 1: General requirements and tests
Amendment 1 - Organic light emitting diode (OLED) Light sources for general lighting - Safety - Part 1: General requirements and tests
Amendement 1 - Sources lumineuses à diodes électroluminescentes organiques (OLED) destinées à l'éclairage général - Sécurité - Partie 1: Exigences générales et essais
General Information
Relations
Buy Standard
Standards Content (Sample)
IEC 62868-1 ®
Edition 1.0 2025-02
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
AMENDMENT 1
AMENDEMENT 1
Organic light emitting diode (OLED) Light sources for general lighting – Safety –
Part 1: General requirements and tests
Sources lumineuses à diodes électroluminescentes organiques (OLED)
destinées à l'éclairage général – Sécurité –
Partie 1: Exigences générales et essais
IEC 62868-1:2020-05/AMD1:2025-02(en-fr)
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester. If you have any questions about IEC
copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or
your local IEC member National Committee for further information.
Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite ni
utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie et
les microfilms, sans l'accord écrit de l'IEC ou du Comité national de l'IEC du pays du demandeur. Si vous avez des
questions sur le copyright de l'IEC ou si vous désirez obtenir des droits supplémentaires sur cette publication, utilisez
les coordonnées ci-après ou contactez le Comité national de l'IEC de votre pays de résidence.
IEC Secretariat Tel.: +41 22 919 02 11
3, rue de Varembé info@iec.ch
CH-1211 Geneva 20 www.iec.ch
Switzerland
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.
About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigendum or an amendment might have been published.
IEC publications search - webstore.iec.ch/advsearchform IEC Products & Services Portal - products.iec.ch
The advanced search enables to find IEC publications by a Discover our powerful search engine and read freely all the
variety of criteria (reference number, text, technical publications previews, graphical symbols and the glossary.
committee, …). It also gives information on projects, replaced With a subscription you will always have access to up to date
and withdrawn publications. content tailored to your needs.
IEC Just Published - webstore.iec.ch/justpublished
Electropedia - www.electropedia.org
Stay up to date on all new IEC publications. Just Published
The world's leading online dictionary on electrotechnology,
details all new publications released. Available online and once
containing more than 22 500 terminological entries in English
a month by email.
and French, with equivalent terms in 25 additional languages.
Also known as the International Electrotechnical Vocabulary
IEC Customer Service Centre - webstore.iec.ch/csc
(IEV) online.
If you wish to give us your feedback on this publication or need
further assistance, please contact the Customer Service
Centre: sales@iec.ch.
A propos de l'IEC
La Commission Electrotechnique Internationale (IEC) est la première organisation mondiale qui élabore et publie des
Normes internationales pour tout ce qui a trait à l'électricité, à l'électronique et aux technologies apparentées.
A propos des publications IEC
Le contenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possédez l’édition la
plus récente, un corrigendum ou amendement peut avoir été publié.
Recherche de publications IEC - IEC Products & Services Portal - products.iec.ch
webstore.iec.ch/advsearchform Découvrez notre puissant moteur de recherche et consultez
La recherche avancée permet de trouver des publications IEC gratuitement tous les aperçus des publications, symboles
en utilisant différents critères (numéro de référence, texte, graphiques et le glossaire. Avec un abonnement, vous aurez
comité d’études, …). Elle donne aussi des informations sur les toujours accès à un contenu à jour adapté à vos besoins.
projets et les publications remplacées ou retirées.
Electropedia - www.electropedia.org
IEC Just Published - webstore.iec.ch/justpublished
Le premier dictionnaire d'électrotechnologie en ligne au monde,
Restez informé sur les nouvelles publications IEC. Just
avec plus de 22 500 articles terminologiques en anglais et en
Published détaille les nouvelles publications parues.
français, ainsi que les termes équivalents dans 25 langues
Disponible en ligne et une fois par mois par email.
additionnelles. Egalement appelé Vocabulaire
Electrotechnique International (IEV) en ligne.
Service Clients - webstore.iec.ch/csc
Si vous désirez nous donner des commentaires sur cette
publication ou si vous avez des questions contactez-nous:
sales@iec.ch.
IEC 62868-1 ®
Edition 1.0 2025-02
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
AMENDMENT 1
AMENDEMENT 1
Organic light emitting diode (OLED) Light sources for general lighting – Safety –
Part 1: General requirements and tests
Sources lumineuses à diodes électroluminescentes organiques (OLED)
destinées à l'éclairage général – Sécurité –
Partie 1: Exigences générales et essais
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 29.140.99 ISBN 978-2-8327-0205-5
– 2 – IEC 62868-1:2020/AMD1:2025
© IEC 2025
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
ORGANIC LIGHT EMITTING DIODE (OLED) LIGHT
SOURCES FOR GENERAL LIGHTING – SAFETY –
Part 1: General requirements and tests
AMENDMENT 1
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international
co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and
in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports,
Publicly Available Specifications (PAS) and Guides (hereafter referred to as "IEC Publication(s)"). Their
preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with
may participate in this preparatory work. International, governmental and non-governmental organizations liaising
with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for
Standardization (ISO) in accordance with conditions determined by agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence between
any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter.
5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity
assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any
services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) IEC draws attention to the possibility that the implementation of this document may involve the use of (a)
patent(s). IEC takes no position concerning the evidence, validity or applicability of any claimed patent rights in
respect thereof. As of the date of publication of this document, IEC had not received notice of (a) patent(s), which
may be required to implement this document. However, implementers are cautioned that this may not represent
the latest information, which may be obtained from the patent database available at https://patents.iec.ch. IEC
shall not be held responsible for identifying any or all such patent rights.
Amendment 1 to IEC 62868-1:2020 has been prepared by subcommittee 34A: Electric light
sources, of IEC technical committee 34: Lighting.
The text of this Amendment is based on the following documents:
Draft Report on voting
34A/2421/FDIS 34A/2433/RVD
Full information on the voting for its approval can be found in the report on voting indicated in
the above table.
© IEC 2025
The language used for the development of this Amendment is English.
This document was drafted in accordance with ISO/IEC Directives, Part 2, and developed in
accordance with ISO/IEC Directives, Part 1 and ISO/IEC Directives, IEC Supplement, available
at www.iec.ch/members_experts/refdocs. The main document types developed by IEC are
described in greater detail at www.iec.ch/publications/.
The committee has decided that the contents of this document will remain unchanged until the
stability date indicated on the IEC website under webstore.iec.ch in the data related to the
specific document. At this date, the document will be
• reconfirmed,
• withdrawn, or
• revised.
___________
Throughout the document, replace the term "product" with "light source" with the exception of
the instances of the term "product" in the second and third columns of Table 1, and in the
Normative references, where the term "product" is kept.
Throughout the document, replace "IEC 60598-1:2014 and IEC 60598-1:2014/AMD1:2017" with
"IEC 60598-1:2020".
1 Scope
Replace the existing two paragraphs and notes with the following new paragraphs and notes:
This part of IEC 62868 specifies general safety requirements of organic light emitting diode
(OLED) light sources (tiles, panels and modules and OLED lamps) for use on DC supplies up
to 1 000 V or AC supplies up to 1 000 V at 50 Hz or 60 Hz for indoors and similar general
lighting purposes.
Where an appropriate part of the IEC 62868-2 series for an OLED light source does not exist,
the applicable part with the nearest configuration of the IEC 62868-2 series can be used as a
guide to the requirements and tests in conjunction with this document.
NOTE 1 The OLED lighting system consisting of OLED panels or modules is illustrated in Annex D.
NOTE 2 This document applies to OLED light sources (tiles, panels, modules and lamps), and it is intended so that
the OLED light source in accordance with this document fits in the IEC 60598 series as a component of lighting
equipment, in combination with other components.
– 4 – IEC 62868-1:2020/AMD1:2025
© IEC 2025
2 Normative references
Replace the existing reference to IEC 60598-1:2014 and IEC 60598-1:2014/AMD1:2017 with
the following new reference:
IEC 60598-1:2020, Luminaires – Part 1: General requirements and tests
Add the following new references:
IEC 60598 (all parts), Luminaires
IEC 60838-2-2, Miscellaneous lampholders – Part 2-2: Particular requirements – Connectors
for LED-modules
3 Terms and definitions
In both terminological entries 3.1 (organic light emitting diode) and 3.4 (OLED module), delete
the Note 1 to entry.
Replace the existing terminological entry 3.7 with the following new entry 3.7:
3.7
integral OLED
OLED, designed to form a non-replaceable component of a luminaire
Note 1 to entry: Refer to Annex D.
Replace the existing terminological entry 3.8 with the following new entry 3.8:
3.8
built-in OLED
OLED, designed to form a replaceable component to be built into a luminaire and into a module
Note 1 to entry: Refer to Annex D.
Replace the existing terminological entry 3.9 with the following new entry 3.9:
3.9
independent OLED
OLED, designed for being mounted or placed separately from a luminaire, from an additional
box or enclosure or the like
Note 1 to entry: Refer to Annex D.
Note 2 to entry: Independent OLED light sources can be considered as an OLED luminaire.
4.1 General requirements
Delete the last paragraph.
© IEC 2025
4.2 General test requirements
Add, before the first paragraph, the following new paragraph:
Tests according to this document are type tests.
Add, at the end of the existing last paragraph, the following two new paragraphs:
Integral OLED light sources shall be regarded as integral components of luminaires according
to IEC 60598-1:2020, 0.5.1.
In addition to the requirements of this document, independent OLED light sources shall comply
with the IEC 60598 series.
5 Marking
5.2 Durability and legibility of marking
Replace the existing second paragraph with the following new paragraph:
Com
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.