ISO/TS 15453:2017

Gas cylinders — Seamless steel and aluminium-alloy gas cylinders — Evaluation of existing gas cylinders and consideration of their safe use in other jurisdictions

ISO/TS 15453:2017 details the checks, inspections and tests to be performed in order to qualify and certify existing seamless steel and aluminium-alloy cylinders of water capacity less than 150 l used for the transport of gases, manufactured in a jurisdiction in accordance with its national regulations, for use in jurisdictions other than that of manufacture or first use. NOTE For specific requirements regarding gas cylinders that have been used in toxic gas service, see 5.7. ISO/TS 15453:2017 does not address acetylene cylinders.

Bouteilles à gaz — Bouteilles à gaz en acier et en alliages d'aluminium, sans soudure — Évaluation des bouteilles à gaz existantes et considérations relatives à leur utilisation en toute sécurité dans d'autres jurisdictions

General Information

• Status: Published
• Publication Date: 23-Apr-2017
• ICS: 23.020.30 - Pressure vessels, gas cylinders
• ICS: 23.020.35 - Gas cylinders
• Technical Committee: ISO/TC 58/SC 4 - Operational requirements for gas cylinders
• Drafting Committee: ISO/TC 58/SC 4 - Operational requirements for gas cylinders
• Current Stage: 9093 - International Standard confirmed
• Completion Date: 23-Jan-2024

Standards Content (Sample)

TECHNICAL ISO/TS
SPECIFICATION 15453
First edition
2017-04
Gas cylinders — Seamless steel and
aluminium-alloy gas cylinders —
Evaluation of existing gas cylinders
and consideration of their safe use in
other jurisdictions
Bouteilles à gaz — Bouteilles à gaz en acier et en alliages
d’aluminium, sans soudure — Évaluation des bouteilles à gaz
existantes et considérations relatives à leur utilisation en toute
sécurité dans d’autres jurisdictions
Reference number
ISO/TS 15453:2017(E)
©
ISO 2017

---------------------- Page: 1 ----------------------
ISO/TS 15453:2017(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO/TS 15453:2017(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols and abbreviated terms . 2
5 Requirements . 3
5.1 Inspection body . 3
5.2 Information to be provided . 3
5.2.1 General. 3
5.2.2 Basic information . 3
5.2.3 Additional information . 3
5.3 V erification of the information provided . 3
5.4 Cylinders subject to restriction on use . 4
5.5 Compatibility with intended gas service . 4
5.6 Specific requirements for seamless steel cylinders used-in carbon monoxide service . 4
5.7 Toxic gas service . 4
5.8 Manufacturing certificate or equivalent . 4
6 Acceptance by the inspector .
...