ISO 8745:1986

Grooved pins -- Half-length taper grooved

Goupilles cannelées à cannelures progressives sur la moitié de la longueur (débouchantes)

General Information

• Status: Replaced
• Publication Date: 05-Nov-1986
• Withdrawal Date: 05-Nov-1986
• ICS: 21.060.50 - Pins, nails
• Technical Committee: ISO/TC 2 - Fasteners
• Drafting Committee: ISO/TC 2 - Fasteners
• Current Stage: 6060 - International Standard published
• Completion Date: 06-Nov-1986

RELATIONS

• Revised: ISO 8745:1997 - Grooved pins -- Half-length taper grooved
• Effective Date: 15-Apr-2008

Standards Content (sample)

International Standard @ 8745

INTERNATIONAL ORGANIZATION FOR STANDARDIZATION*MEXKllYHAPOPHAR OPrAHM3AUMfl Il0 CTAHnAPTH3AUMM*ORGANlSATlON INTERNATIONALE DE NORMALISATION

Grooved pins - Half-length taper grooved

Goupilles cannelées à cannelures progressives sur la moitié de la longueur (débouchantes)

First edition - 1986-11-01
UDC 621.886.12 Ref. No. IS0 8746-1986 (E)

Descriptors : fasteners, pins (mechanics), grooved pins, specifications, dimensions, designation.

Price based on 3 pages
---------------------- Page: 1 ----------------------
Foreword

IS0 (the International Organization for Standardization) is a worldwide federation of

national standards bodies (IS0 member bodies). The work of preparing International

Standards is normally carried out through IS0 technical committees. Each member

body interested in a subject for which a technical committee has been established has

the right to be represented on that committee. International organizations, govern-

mental and non-governmental, in liaison with ISO, also take part in the work.

Draft International Standards adopted by the technical committees are circulated to

the member bodies for approval before their acceptance as International Standards by

the IS0 Council. They are approved in accordance with IS0 procedures requiring at

least 75 % approval by the member bodies voting.
International Standard IS0 8745 was prepared by Technical Committee ISO/TC 2,
Fasteners.

Users should note that all International Standards undergo revision from time to time

and that any reference made herein to any other International Standard implies its

latest edition, unless otherwise stated.
O International Organization for Standardization, 1986 O
Printed in Switzerland
---------------------- Page: 2 ----------------------
INTERNATIONAL STANDARD
Grooved pins - Half-length taper grooved
Scope and field of application

This International Standard specifies the characteristics of half-length taper grooved pins which have three equally spaced grooves

impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, dl, from 1,5 to 25 mm inclusive.

The displaced material to each side of the grooves forming an expanded diameter d2 which is larger than the nominal diameter dl will

cause a positive locking fit when these grooved pins are forced into a drilled hole equal to the nominal diameter dl (see clause 4).

2 References
IS0 2081, Metallic coatings - Electroplated coatings of zinc on iron or steel.
IS0 3269, Fasteners - Acceptance inspection.
IS0 4520, Chromate conversion coatings on elect
...